Question about 1999 Infiniti.5 QX4

1 Answer

Inf qx4 back door will not open. one side now neather side will open. Left side was intermettent took panel off everything looked ok. Now doors are closed and can't take panel off.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has answered 200 questions.


    An expert who has answered 20 questions.

  • Expert
  • 215 Answers

Check to see if it got a safety lock on it you need to unlock it.

Posted on Dec 30, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I put the driver side power window back on track and the door panel for my 2003 Nissan Altima 3.5SE?

R/R the inner door panel, slide the window back on track, reconnect the window transmission to the window, (or reinstall the trans) bolt everything back together (window motor, window trans to door etc.) Make sure the window is in the UP position. use the switch to raise the window & keep it up if all is back together before finally installing the door panel ( make sure the switch & other plugs are plugged in before the door panel is reinstalled.) Lights etc. Good luck

Sep 14, 2014 | 2003 Nissan Altima

1 Answer

Where is the turn signal flasher relay located in a qx4 2001

The flasher is located behind and above the left side of the small fuse box at the driver's left knee. You will need a small rachet handle, 10mm socket and a Phillips head screwdriver. A socket extension of 6 to 10 inches will be helpful. To access the old flasher: 1) Remove bolt securing driver's plastic kick plate and wiggle it out of place and set aside. This is the trim panel just fore of the driver's door opening. 2) Remove two Phillips Head screws on the plastic knee panel. This panel runs below the steering column from left kick plate to the center console. The panel includes the small fuse box access door and two sets of wiring. No need to totally remove this panel; just remove the screws, pull it loose and swing or tie to the right so that you can... 3) Remove the three bolts that secure the fuse panel. Note that the fuse panel "hangs" by two pivot points. Lift the panel up to free the pivot points and the wiring harness has enough play to let you drop the panel a few inches. 4) Now you should see the black flasher (small box shape). It hangs on the metal framework; slide it to the right to release from the framework. Push in the wiring connector catch and carefully separate the wiring harness from the flasher. Connect your new flasher and secure the flasher to the nearest wiring harness.

Jun 16, 2014 | 2001 Infiniti QX4

1 Answer

My fuse panel diagram is missing from my 1993 cadillac fleetwood brougham and my digital dash isnt indicator lights are working so im wondering which fuse to check

i have a 1995 fleetwood brougham and when you open the doors inside lights dont work neather does any of the in side light work with doors closed even the ones on the mirror

Nov 03, 2011 | 1993 Cadillac Fleetwood

1 Answer

Interior door handle right side

first you need to order a new handle and trim ring, 2 separate pieces. beige or grey are your only choices. cheapest and only one i found that caries beige. i did both front doors for 25 dollars total including shipping. Remove door panel, 2 screws under round plastic caps that pry out and off, 2 screws at bottom, 2 lg screws in middle handle, 1 plastic retainer in side that prys out, 1 screw under square cap in the center of the trim ring. remove black plastic triangle shaped piece near the mirror, prys off easy. grab door panel and pull out then lift up. leave wires attached and let panel hang loose. remove screw from old door handle. remove linkage from handle and from lock. connect linkages to new handle and lock (look carefully at the old one before you remove the linkages) , install the last screw you removed to hold lock in place while you check to if everything works. when i finished mine neither door would open from the inside. i had to take pliers and slightly bend the linkage at the elbo's to shorten the travel distance. check this before you put everything back together by just putting the door panel back in place down fist then in, window down, close door, reach in and open door, if it doesn't open bend linkage and try again. when you are sure everything is ok install all screws except the one that was under the square plastic cap in the trim ring. to install trim ring look for notch on back side toward front of ring, push ring in notch end fist, back end slightly out, when the front end is in and seated push the back end straight in. install screw and push cap in. this job is not as hard as it sounds and will make sense when have the panel off and can see.

Nov 07, 2010 | 1998 Toyota Camry

1 Answer

My drivers side passenger door wouldn't open either, then...

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Aug 08, 2009 | 2002 BMW 5 Series

1 Answer

My inside coursty and dome light stays on when i open the door. i took the fuse out to keep the battery from running down but the horn and back door latch works off of the same fuse. its a 1996 blazer.

There is a dome override switch located below the head lamp switch make sure it is in the off position - if it is ok - open the driver side door look on the side on the instrument panel for a little black plunger - that is the switch for the dome lamp and courtsey lamps if it is broken or not there this will cause the lights to stay on. It will have to be replaced if it is broken or missing.

Aug 03, 2009 | Chevrolet Blazer Cars & Trucks

3 Answers

Where are the fuse boxes in a 1998 passat

have tried looking in the side of the dash on the driverside?

Jul 15, 2009 | 1999 Volkswagen Passat

1 Answer

1999 Infinity QX4. Door Open warning light

usually on post where door closes, or in jamb by hinge area. Open door & try pushing any button/pin like object or may be a lever style too, with thumb or finger.When interior light goes out, you found it

May 03, 2009 | 1999 Infiniti.5 QX4

1 Answer


Pull drivers rear door panel off
1. Remove door lock solenoid and plug it into another door to see if it works
2. If you can reach inside the door to the final mechanism that everything pushes on, push it yourself to see if it works
3. Also look on side of door for possible child saftey lock switch

Dec 23, 2008 | 1997 Chevrolet Suburban

1 Answer

Left side rear door will not unlatch.

stupid question but did you try inside latch?If so you should be able to remove seat from other side and remove door panel and replace parts (probley clip) as needed or at least open door if latch is defective

Oct 16, 2008 | 1999 Chevrolet Suburban

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

204 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14411 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides