Question about Lincoln LS

1 Answer

Only drives 6 mph have repaced throttle body and clearded codes

Posted by on

  • 1 more comment 
  • ccsphx Dec 30, 2010

    2004 Lincoln LS 3.0 code 2107 and 2110 have replaced thottlebody from ford complete cleared the codes and inspected for broken wires

  • ccsphx Dec 30, 2010


  • ccsphx Dec 30, 2010




1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Lincoln Master
  • 1,420 Answers

Welcome to

Year make and model with engine size please

Thank you for using

Regards, Lee Davidian

Posted on Dec 30, 2010

  • Auto Repair Help
    Auto Repair Help Dec 30, 2010

    Did the codes come back?

  • Auto Repair Help
    Auto Repair Help Dec 30, 2010

    ok i am checking into this give me a bit , Lee



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Will not go faster than 20 mph

want to know if u have any codes first comon is throttle body if it said power loss on cluster unplug battery and re connect and drive .need toknow the codes thoug

Mar 05, 2015 | 2000 GMC Yukon

1 Answer

1999 Chevy G-30 utility van code p-0174 , cleaned then replaced MAFcleared code, back on 50 miles later, found vacum leak hose off vac. ball, code cleard 50 miles light back on,

what size engine do you have in the g-30 van. is it the plastic plenum. if it is there are rubber o-ring seals that go bad all the time and will cause the p0171,p0174,p0172,p0175 these are all lean codes also check for fuel pressure to make sure it is up to specs.
have you changed your fuel filter lately this can effect fuel trims.

Jan 09, 2012 | Chevrolet Cars & Trucks

1 Answer

I have a 2002 gmc envoy with 4.2 i 6 with 65k the reduce engine power light came on, and it would only go about 10 mph. After it sat a day or so it ran go for about a week then it did it the...

Sounds like your throttle body is sticking. Common problem, the reduced power is just a safe mode. 1st disconnect your battery, then clean your throttle body with throttle body cleaner. When finished, connect the battery back up. Turn off all accessoried and drive around for 20 minutes or so, for the computer to relearn a properly functioning throttle body. Should solve your problem, and if you do it yourself, will cost you around $5 for the can of TB cleaner.

Apr 26, 2011 | 2002 GMC Envoy

1 Answer

It wont go at all and teh throttle control light came on

ETC Failsafe, and now you can only go 6 mph ??

(Electronic Throttle Control )

Spray the throttle plate with -- CRC Throttle Body Cleaner

Give me all the Fault Codes you have ,for Ignition
Misfires. They are most likely what put it into Failsafe

Too technical to explain for now.

Mar 23, 2011 | 2004 Lincoln LS

1 Answer

2005 Explorer changed EGR valve due to code and now fail safe mode is in and wrench light is on. Vehicle starts but throttle does not work.

Most likely the ETC Fail Safe (Electronic Throttle Control)
Various Codes for the Throttle Body will be present

Before you replace the Throttle Body because of a failed
TACM (Throttle Actuator Control Motor) Spray the throttle
inlet and plate with CRC Throttle Body Cleaner

The Failsafe can also occur from a really bad COP Ignition
Coil spiking the PCM (computer) and coming back on both
sides of the TPS Sensor. You then loose throttle plate
position and thus shut down or go only 6 mph

Jan 29, 2011 | 2005 Ford Explorer

1 Answer

Dear Sir, I have a 1997 Jeep Cherokee Sport, 6 cylinder 4.0 liter. I recently tried cleaning my throttle body with carb cleaner while the vehicle was running. After spraying a half can of cleaner in the...

do a compression check on the engine, and replace the bad sensor, i take the throttle body off to clean it and some sensors are touchy about cleaner, i fear maybe something got on the egr valve pintle

May 26, 2010 | 1997 Jeep Cherokee

2 Answers


An additional clarification to terian_5's suggestion of checking the vacuum lines, usually the rubber elbow on the back of the throttle body gets cracks in it.
Remove the plastic throttle body cover, and check the rubber elbow, and the vacuum line for this. You might have to look close, sometime they are hard to see.

Ignore the IAC notation in this picture, it is the best one I have that shows the rubber elbow, it is the elbow right below the text

This is ~ 20.00 ( + tax/ship ) from Ford to get a new one. Replace this, clear the codes and do 2 driver cycles ( steady throttle up to 47 mph min, back to a stop and back up to 47 mph again ).
If you do not have a code scanner to clear the codes, disconnect the battery fro ~ 10 min, reconnect battery, start let idle to warm up, and do 2 drive cycles.

Jan 22, 2010 | 2002 Ford F150 Regular Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts


Level 3 Expert

79865 Answers


Level 3 Expert

5687 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides