Question about 2004 Lincoln Navigator

2 Answers

How to change the power steering pump on a 2004 Lincoln Navigator

Posted by on

  • Lisa Jones
    Lisa Jones Dec 30, 2010

    I just downloaded a trojan from you all i get is some commercial and music playing in back ground no help video thanks man want my money back

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 750 Answers
Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,530 Answers

Welcome to Fixya

Here's the procedure on how to replace the power steering pump"

Remove the Drive Belt
1.1
Disconnect the black, negative battery cable from the car's battery using a wrench.
2.2
Turn the idler belt tensioner using a breaker bar with a 1/2-inch drive. Insert the drive into the square hole on the tab located behind the belt tensioner and turn it clockwise. Slide the belt off the power steering pulley. On some models, you may need a breaker bar with a 3/8-inch drive. See the Tip section at the bottom for more information. Go to the next section.
3.3
Loosen the adjusting and pivot bolts from the alternator, if you have a Lincoln Continental with a 5.0L engine. Use a ratchet, ratchet extension and socket.
4.4
Push the alternator towards the engine and slide the drive belt off the power steering pump.
Remove the Power Steering Pump
5.1
Place a drain pan underneath the engine in the direction of the power steering pump hoses.
6.2
Detach the return hose form the steering pump by unscrewing the clamp at the pump using a ratchet and socket. Let the fluid drip onto the drain pan.
7.3
Detach the pressure hose from the steering pump by turning the retaining nut using a tube wrench. Let the fluid drip onto the drain pan if necessary.
8.4
Unscrew the mounting bolts from the power steering pump using a ratchet, ratchet extension and socket.
9.5
Remove the power steering pump from the engine.
Install the New Power Steering Pump
10.1
Set the new power steering pump in place.
11.2
Start the pump mounting bolts by hand to avoid damage to the threads. Use the ratchet extension if necessary.
12.3
Tighten the steering pump mounting bolts.
13.4
Connect the pressure hose to the power steering fitting by starting the retaining nut by hand to avoid damage to the threads. Then tighten the nut using the tube wrench.
14.5
Attach the return hose to the steering pump and tighten the clamp using a ratchet and socket.
15.6
Fill the power steering pump reservoir with power steering fluid and make sure the level is between the Low and Full marks.
Install the Drive Belt
16.1
Turn the idler belt tensioner clockwise using a 1/2- or 3/8-inch drive breaker bar, depending on your particular model. Then slide the drive belt over the steering pump pulley. Then go to the next section.
17.2
Place the drive belt over the power steering pump pulley, if you had to move the alternator to release the belt.
18.3
Pull the alternator away from the engine using a pry bar to give the drive belt the required tension and tighten the alternator-adjusting bolt. Then tighten the alternator pivot bolt. Use a ratchet, ratchet extension and socket.
19.4
Connect the black, negative battery cable to the car's battery using a wrench.
Bleed the Power Steering System
20.1
Start the engine.
21.2
Turn the steering wheel four times left and right completely.
22.3
Check the power steering fluid and add if necessary.
23.4
Turn the steering wheel again, check the power steering fluid and add more if necessary. Repeat the steps 2 and 3 until the level remains between the Low and Full marks.
24.5
Turn off the engine.

Thank you for using Fixya!

Posted on Dec 31, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 Lincoln Navigator fuel pump relay


look behind the passenger frt. kick panel under glove box

Oct 02, 2017 | 2004 Lincoln Navigator

1 Answer

2004 Lincoln Navigator when making slow turn wheel fully turned in either direction the truck comes to a complete stop while in gear. I have to press the gas hard to move. I had a strutmasters kit...


check and adjust the turn stops so that a turn angle of 20 degrees is the maximum
It is possible that with the changed suspension that the steering on full turn is making the wheels at such an angle that the vehicle is trying to push the wheel sideways instead of rolling it around the corner

Aug 02, 2017 | 2004 Lincoln Navigator 4x4

2 Answers

I have a 2004 4x4 navigator and the front wont pump up. Would I have the same ride if i convert to shocks and springs or do you have any tips to trouble shoot it?


It may be that the airbag has a hole in it (you will probably hear the air compressor running a lot if this is the case), or (more likely) it could also be that the sensor for the ride height on the front is faulty and the car does not realize that it needs to be inflated. These sensors lay inside the front fender and can get full of road gunk and cause them to fail. I do not suggest trying to convert to a conventional suspension system, I'm not even sure it's possible. It would change the ride and confuse the computers on the car. Instead take it to a Lincoln dealership and have them properly diagnose it with their system scan tool.

Apr 07, 2011 | 2004 Lincoln Navigator

2 Answers

I changed my 2003 Lincoln Navigator air suspension with Strutmaster,since then,I faced a problem with power steering wheel.It became stiff and is hard to steer,although I checked the fluid and was within...


i have thesame problem but i didnt take it to a shop i did it my self i though i did something wrong but i found out that i only needed to take the truck for a alignment and that solve my problem

Mar 20, 2011 | 2003 Lincoln Navigator

2 Answers

I changed my 2003 Lincoln Navigator air suspension with Strutmaster, LOVE IT, drives like new, however, I'm experiencing a problem with my power steering,its stiff and hard to steer. Is there something...


I would guess your steering rack is worn out,
mainly because you don't flush the fluid every
3 years or not more than 30,000 miles, as you
should also do with the transmission, on ALL
your vehicles

Feb 06, 2011 | 2003 Lincoln Navigator

4 Answers

I changes my 2003 Lincoln Navigatorn air suspension with Strutmaster, LOVE IT, drives like new, however, I'm experiencing a slight problem with my power steering, its stiff for the first 15 seconds of...


I replaced my air suspension with strutmasters on my 2003 navigator. Cut the wire to disarm warning light and my p. s. did same as yours. Reconnected wire and ps worked normal but suspension warning is now on.

Dec 16, 2010 | 2003 Lincoln Navigator

1 Answer

2004 Lincoln Navigator My steering wheel and air conditioner


If the air conditioner compressor is seizing it could cause the vibration you experience.

Jul 26, 2010 | 2004 Lincoln Navigator

1 Answer

Vehicle Dynamic Module 2003 Lincoln Navigator


Sounds like a dealer only part. Sorry. There are other routes you can take with these vehicles. you can change out the air bag suspension with regular shocks and struts.

Feb 12, 2009 | 2003 Lincoln Navigator

1 Answer

2004 lincoln navigator gear shifter locked


Make sure that you have brake lights. It has a shifter interlock solenoid in the console that is activated when ever the brake lamps are on.

Jan 24, 2009 | 2003 Lincoln Navigator

Not finding what you are looking for?
2004 Lincoln Navigator Logo

Related Topics:

832 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...