Question about 2006 Pontiac Torrent

Open Question

How do I replace the license plate bulbs on an 06 Pontiac Torrent?

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: how to replace license plate light bulb

open back hatch in the center there is a rectangle shaped piece of plastic pop it out and you will see the wire on the back of the bulbs

Posted on Dec 04, 2008

  • 5158 Answers

SOURCE: pontiac torrent headlight burnt out? Can I replace it myself?

yes you can replace it. the bulb is removed from inside the engine compartment. if the burnt out bulb is on the battery side you will likely have to take the battery out. the socket generally turns about a quarter turn or so... have a look to see if there is a large ring that you turn and remove first.
One important detail do NOT touch the bulb with your fingers as it shortens the bulbs lifespan.


Please take a moment to rate this solution thanks

Posted on Jan 28, 2009

  • 14036 Answers

SOURCE: 2007 Pontiac G6. Rear license plate bulb socket dead

park lamp and license plate share same fuse.check park lamp fuse.if fuse good you have ground wire problems.

Posted on Nov 30, 2009

Testimonial: "Thanks for the help! Not sure why the owner's manual doesn't mention that."

  • 88 Answers

SOURCE: check engine light stays on since air filter

the filter is in a plastic casethat has a sensor on the side of it or on lid make sure it was pluged back in

Posted on Jan 20, 2010

  • 44 Answers

SOURCE: How to replace license plate light

you have to remove the lamp housing (2) screws.then wiggle the housing down,so you can turn the bulb socket out.lh loose rh tight.

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Head gasket replacement 06 pontiac torrent step by step pictures please

best is for you to go to an auto parts shop and get a workshop manual for that engine
the vehicle will be immaterial if it uses that same engine as yours

Jul 23, 2016 | Pontiac Cars & Trucks

1 Answer

2003 bonneville licence plate bulb replacement

You need to remove the trunk lid liner and then you will see the connector which twists out. The bulb is normally capless and 5 watts.

HOWEVER, Pontiac do it completely different. This a Monte Carlo, but I reckon it will be the same.
Text answers too

Jun 13, 2016 | 2003 Pontiac Bonneville

1 Answer

Where are my licence plate lights on a 2001 pontiac sunfire and how do u get to them

Remove the license plate and remove the lamp assembly. 2 screws. Bulb is behind.

Oct 01, 2015 | 2001 Pontiac Sunfire

1 Answer

How to replace License Plate Bulb '96 Jeep Grand Cherokee Limited

Hi Timmy:

Check this procedure from Repair manual...

(1) Remove screws and license plate lamp visor from liftgate (Fig. 10).
(2) Remove bulb from lamp socket.

(1) Install a bulb in lamp socket.
(2) Position license plate lamp visor on liftgate and install screws (Fig 10).


Hope this helps.

Apr 28, 2012 | 1996 Jeep Grand Cherokee

2 Answers

How do I replace the rear license plate light on a 2004 Pontiac grand am? The light bulb doesn't seem to be removable. I've removed the covering, but the silvery colored bulb appears to be stationary in...

in your fuse panel check for faulty fuse ,or you might have to replace the whole assembly,if at the part store there is no replacement bulb then its not removeable.

Oct 13, 2010 | 2004 Pontiac Grand Am

1 Answer

2001 Mits Spyder --- license plate light bulb out, must replace. Removed screw, assembly drops out -- how do I unplug?

Twist the bulb to the left, and it should come right out, and then you just pull the bulb out and replce it..

Dec 21, 2009 | 2005 Pontiac Vibe

1 Answer

2007 Pontiac G6. Rear license plate bulb socket dead

park lamp and license plate share same fuse.check park lamp fuse.if fuse good you have ground wire problems.

Nov 30, 2009 | 2007 Pontiac G6 GT Convertible

1 Answer

License plate lamp replacement, how to on a 2004 pontiac sunbird

ok if its hard plastic around you license plate lamp and it feels very brittle...the chances of breaking it is bout a 80 pecent chance when trying to twist it out..but in the mean time feel up to where the bulb is and grab the bulb with a little pressure but not too much pressure...then gently as u can twist it to unlock it from its assembly or if its a puller then gently pull it but it may take a little wiggling and it should come right out

Nov 21, 2009 | Pontiac Sunbird Cars & Trucks

1 Answer

How do I removed and replace the license plate bulb?

up under the license plate it changes like all other on your vehicle

Oct 12, 2009 | 1997 Pontiac Grand Prix

1 Answer

1999 Dodge Neon rear license Plate bulb

  1. Remove screws attaching license plate lamp to rear bumper
  2. Remove lamp from bumper.
  3. Remove bulb socket from lamp.
  4. Pull bulb from socket.

  1. Install bulb into socket.
  2. Install bulb socket into lamp.
  3. Place lamp in position.
  4. Install screws attaching license plate lamp to rear bumper.

Oct 08, 2009 | 1999 Dodge Neon

Not finding what you are looking for?
2006 Pontiac Torrent Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides