Question about 2005 Chevrolet Malibu
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Rear Windshield Wiper Problems
Check the wiper motor connection if its touching anything and loose it will automatically ground out and check at connection make sure you put some gel and then snap it in/ Please rate my response thank you very much
Posted on Jan 31, 2009
you change the from inside the engine compartment. you may need to remove the car battery if it's on that side. if you are already trying this way... what are you having troubles with ?
Posted on Mar 30, 2009
look at the check valve/one-way vacuum valve (located behind the rear left paneling). chances are that the valve is broken and leaking. remove the valve from the hose and replace it.
Posted on Jun 15, 2009
SOURCE: windshield wipers groan
1. It's hard to know what you mean by groan. Is there a problem with the wiper motor or is it just noise from the wipers riding over the new glass?
I hope the wiper mechanism was not damaged during installation of the new glass.
2. I will assume it's just the wipers on the glass. If that is the case you should first try:
a. Clean the glass with a strong glass cleaner and water and flush well.
Dry off with paper towel/ Do this a couple of times.
b. Carefully check that there is no damage to the wiper arms cause by the windscreen replacement people.
c. Replace the wiper rubbers with new inserts. Make sure you get the correct item for your vehicle.
3. If you are still getting the "groan" you will need to investigate problems with the wiper mechanism/motor. Your vehicle should still be under its new car warranty. However any damage caused by the windscreen people cannot be claimed on warranty of course.
Posted on Dec 02, 2009
THe wind doesn't just push the power arm off, it must be broken and will need be replaced, You need to check if the actuall bracket that holds the arm is broken as well. It has teeth on it which when the arm is put on it lock in place with a clip
Posted on Feb 28, 2010
Tips for a great answer:
Dec 04, 2016 | Cars & Trucks
Sep 28, 2016 | 2005 Chevrolet Malibu
Mar 06, 2015 | 2005 Mercury Mountaineer
Aug 13, 2014 | 2009 Chevrolet Malibu
Jun 07, 2011 | 1999 Chevrolet Malibu
Jan 28, 2011 | 2005 Scion xA
Jan 18, 2011 | Chevrolet Malibu Cars & Trucks
Jan 18, 2009 | 1999 Chevrolet Suburban
100 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: