Question about 1992 Isuzu Amigo

1 Answer

Vacuum line problems

I need the vacuum shematics for a 1992 isuzu amigo 2.6 litre and fuel injection

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 162 Answers

I think I saw a thing on ebay for schematics? I could take pictures for you of my 92 but I have the 2.3 l

Posted on Aug 12, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

My car has been for long time without use. Now after tuning it on, it drives if driven a flat street, but if there is a some inclination of the street it fails may be the injectors are dirty?


the standardization of the 2.6-liter engine for 1992
low engine power has over 50 causes.
with bad fuel, the job gets harder.
the ECU can not inject correctly with clogged injectors, or low fuel pressure, (fuel filter new/)?????
new spark plugs yet> be the time, no ?
ill look up your engine now in, Mitchells (so can you)
and see what you have, Isuzu rand carbs here until 1994.
so.....
the engine is the 4ZE1 engine.
looks like its not TBI but the MPI engine with 4 injectors.
so is the fuel pressure, at spec> (a gauge does that)
spec it below, 35psi,
so engine good? compression, its old.
spark good, do the tuneup yet.
then fueling. is next and last.
bad fuel, is bad fuel. and causes collateral damage.
new fuel filter yet>?
and what came out of the oil filter. clean fuel or what?
sludge, slime, dust , rust, or clean fuel smelled good.??????
this engine runs off a MAP sensor, on the top center right fender.
the vacuum line to it must be good, and have normal vacuum to it.
the engine has no OBD2 scanners.
its OBD1 that year, in USA> and you;d first check all fuses.
then see that the CEL lamp glows key on, than goes out running
if it goes out running ok, but if not, its best no matter what to
do the ISUZU flash codes (DTC errors) first.
(this works on all cars EFI up to 1995)


tuneup spec, page. , gap, timing , PSI pump, rpm. and lash.
26226393-kn0bytz2tvc3oakcon55wlc3-2-0.jpg

Jun 26, 2016 | 1992 Isuzu Amigo

1 Answer

1992 isuzu bighorn 3.1 turbo diesel, rebuilt injection pump, will not cold start


1: compression good.
2: glow plugs hot.
3: test fuel, does test fuel work??????
yes, you did it wrong
no, #1 or #2 caused.

Aug 27, 2014 | Isuzu Cars & Trucks

1 Answer

1988-1992 12V or 24V


Isuzu models sold in the US are all 12 volt. I am assuming your vehicle is from another country if it is 24 volt.

Aug 23, 2012 | 1988 Isuzu Trooper 2 Door

1 Answer

Is the 1992 isuzu rodeo, automatic - fuel injected? that is, do you need to give it any gas to start?


No, you don't have to press the accelerator in fuel injected engines. That's a general rule for all fuel injected engines.

Carbureted engines require that you push the accelerator slightly when starting.

Good luck on using your fuel injected vehicle.

Nov 05, 2010 | 1992 Isuzu Rodeo

2 Answers

Vacum hose diagram for a 1990 Isuzu Amigo fuel injected


Is there not one under the hood?? Usually there is a diagram for the emissions which has the vacuum hoses.

Nov 01, 2010 | Isuzu Amigo Cars & Trucks

2 Answers

1998 isuzu amigo 2.2l 5 spd 4 cyl .\r\ni need to


in all fuel injected cars you do not adjust idle. All you can do is clean the throttle and replace the Idle Air Control valve and check data thru a scanner to see if any sensors are out of specs. If this car has a maf sensor in the air filter tube it could become contaminated and cleaning or replacemnet will allow it to see more air which in turn allows the computer to add more fuel for better idling and accelration.

Jun 11, 2010 | 1998 Isuzu Amigo

2 Answers

1993 rodeo not running no power to fuel pump


if there is no power to the fuel pump check relays and fuses....UNDERHOOD FUSE & RELAY PANEL IDENTIFICATION Fig. 2: Underhood Fuse & Relay Panel Identification Courtesy of ISUZU MOTOR CO. Fusible Link Identification ? A - 80 Amp (1991-92 3.1L) ? A - 60 Amp Main-1 ? B - 30 Amp Main-2 ? C - 30 Amp (1993-94) ECM (3.2L) ? D - 30 Amp Condenser Fan (A/T Models) Relay Identification ? 1 - Headlight Relay ? 2 - A/C - Heater Relay ? 3 - Starter Relay ? 4 - A/C Compressor Relay ? 5 - Charge Relay ? 6 - Fuel Pump Relay ? 7 - ECM Relay ? 8 - Wiper Relay Fuse & Circuit Breaker Identification ? 1 - 15 Amp (1991) ECM, Fuel Injection System ? 1 - 15 Amp (1992-94 2.6L) ECM, Fuel Injection System ? 1 - 10 Amp (1992-94 3.1 & 3.2L) Heated Oxygen Sensor, Fuel Injection System ? 2 - 20 Amp (1991-92) Fuel Pump ? 2 - 20 Amp (1993-94 2.6L) Fuel Pump ? 2 - 15 Amp (1993-94 3.2L) Fuel Pump ? 3 - 10 Amp (1991) ? 3 - 15 Amp (1992-94) Turn Signal Lights, Hazard Warning Flasher Lights ? 4 - 10 Amp Horn, Door Locks ? 5 - Not Used (1991 3.1L) ? 5 - 10 Amp Charging System, Charge Warning Light WARNING: Always disconnect battery ground cable before servicing "high- current fuses. It is recommended that "high-current" fuses be replaced by a qualified technician. Page 1 of 2 FUSES & CIRCUIT BREAKERS -1994 Isuzu Rodeo LS? 6 - Not Used (1991) (1992-93 2.6L) ? 6 - 10 Amp (1992-94 3.1L & 3.2L) A/T Interlock System ? 6 - 10 Amp (1994 2.6L) Heated Oxygen Sensor, Fuel Injection System ? 7 - 20 Amp Heater/Air Conditioning Blower Controls ? 8 - 10 Amp Air Conditioner Compressor Controls ? 9 - 10 Amp Right Headlight ? 10 - 10 Amp Left Headlight © 2008 Mitchell Repair Information Co., LLC.
62217_isuzfuse_1.jpg
Underhood fuse block swap out relay #7 thats the ECM relay.
Ground Circuits Using a DVOM, touch negative voltmeter lead to a good ground. Touch positive voltmeter lead to each ground terminal. With vehicle running, voltmeter should indicate less than one volt. If reading is greater than one volt, check for open, corrosion and loose connection on ground lead. See ECM GROUND LOCATION table for ECM ground location.
Page 1 of 1 SYSTEM/COMPONENT TESTS - 2.6L EFI -1994 Isuzu Rodeo

Mar 28, 2010 | 1993 Isuzu Rodeo

2 Answers

Where is the computer located in a 1992 isuzu amigo?


Because the ambient temperature is more likely to be tolerable for the semiconductors in your ECU, these4 are normally installed inside the passenger compartment, often under the dashboard.
It shouldn't be too difficult to locate, look for a box with a large number of wires in the connector(s) attached to it.

Oct 25, 2009 | 1992 Isuzu Amigo

2 Answers

92 Isuzu Amigo want stay running


It sounds like your accelerator pump has a leak.

Mar 21, 2009 | 1992 Isuzu Amigo

Not finding what you are looking for?
1992 Isuzu Amigo Logo

Related Topics:

252 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

70347 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...