Question about 2008 Mercury Sable

1 Answer

2008 Sable, 57k miles. When I turn on the ignition, there is a steady clicking noise that lasts between 15-30 seconds that originates from under the dash on the drivers side, near the accelerator. Any ideas on what the problem could be would be greatly appreciated.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My 2008 Sable, 22,000 miles. I have a steady clicking sound under the instrument panel and the car won't start. Right now, my vehicle was towed to the dealership, so I should find out something next week.

Posted on Mar 26, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Starting problems


may be the ignition cause your car hard to start.
_______________
super mb star update instruction

Apr 28, 2013 | 1999 Chevrolet Silverado 1500

1 Answer

2008 Ford Taurus, clicking noise that lasts about 15 seconds when turn on A/C or heat.


There may be something in the blower motor, that has either fallen into the defrost duct, or your fan may be going out. Remove the cab filter or remove the fan cover and investigate.

Apr 04, 2013 | 2008 Ford Taurus

1 Answer

I hear a click click click then a pause then click click click again when I go to start my 2008 mercury sable the clicking starts when the accessories are activated right before the motor turns over it...


This noise is indeed coming from the dash and it is caused by a part called the air temperature control blend door actuator motor. The noise is a tiny electric gear drive that moves the door and controls air temperature jumping teeth due to a defective sticking blend door inside the air ducting. To replace these parts requires the dash be removed from the car, a 12-14 hour job.

Jul 03, 2012 | 2008 Mercury Sable

1 Answer

I acnnot find how to reset the oil change required indicator light on my 2008 Mercury Sable


The following procedure will reset your oil change light. Thank you for using Fixya!

2008-2010 Sable
  1. Turn the ignition to run (one position before starting engine).
  2. Press and release SETUP to display "OIL LIFE XXX% HOLD RESET = NEW".
  3. Press and hold RESET for 2 seconds and release to reset the oil life to 100%.
  4. Turn the ignition off and then start the engine to verify the indicator has been reset.

Mar 04, 2011 | 2008 Mercury Sable

1 Answer

Engine oil light flashes on for fractions of a second then remains off for several minutes before repeating. started same time noise from engine began, noise follows rpm of motor. clicking like a valve...


the oil level may be good and quality may be good, but the oil pump may be going out considering the valve/engine noises. Have it checked quickly, before this engine locks up.

Feb 24, 2010 | 2008 Dodge Charger

1 Answer

Dead battery key stuck in place can't remove clicking noise under hood?


Open the hood and check to see what is clicking and jump start the vehicle to see if it starts.Once it starts then turn the ignition off and see if the key will come out.Also check your mileage and if you have under 36k miles then it is still under warranty.Take it to the dealership and have them check it out.Hope this helps.Good luck.

Jan 28, 2010 | 2008 Buick Enclave

1 Answer

When I accelerate I hear a vibration noise from under the center of the car, it only last a few seconds but happens just about everytime I accelerate.


You have a 100.000 mile powertrain warrenty on your Tahoe. You can take it to the dealership and have it fixed for free, as long as there is a true problem.

Dec 04, 2009 | 2008 Chevrolet Tahoe

1 Answer

I have an 03 malibu with 57K or so miles, it has just started stahling out and not starting properly. It will turn over like it wants to start, but wont.????


If the THEFT PROTECTION lamp is blinking, the VATS system has diabled your fuel pump. Turn the ignition switch to ON, leave it on till the lamp stops blinking. Turn the key to the OFF position, start the car.
Most likely you need to have the ignition switch replaced. Malibu and Impala are notorious for this issue.

Oct 13, 2009 | 2003 Chevrolet Malibu

1 Answer

2003 Mercury Sable - transmission jerking


This is a front wheel drive vehicle and has no power-train components in the rear of the car. The noise coming from the back is not related to your transmission. I would highly reccommend going to a ford dealership as these are typically trust-worthy and always use OEM parts. I also have an 03 sable with 101k miles it has always been reliable and has original transmission. It is possible something else is hard ****.

Mar 26, 2009 | 2003 Mercury Sable

1 Answer

Turning signal makes grinding noise when turned on.


this is the flasher unplug it and go get a new one

Jun 11, 2008 | 1995 Mercury Sable

Not finding what you are looking for?
Cars & Trucks Logo

359 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...