Question about 1995 GMC Yukon

1 Answer

Will a 5 speed chevy manual trans out of an 88 4wd bolted to a 6.5l diesel bolt up to my 95 gmc yukon with a 5.7 gas 4wd.....ik i can make everything else work just dont know if it will bolt up to the block??

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 65 Answers

No the 6.2 and the 5.7 had a similer bolt pattern but not the 6.5

Posted on Dec 30, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 GMC Suburban 6.5L diesel crankshaft harmonic balancer bolt tourque?


from 98 GM manual crank balancer bolt 270Nm or 200' lbs
crank pulley bolts 50Nm 0r 37' lbs

Copied from this site;
Harmonic balancer torque value Diesel Place Chevrolet and GMC Diesel Truck...

Hope this helps.

Feb 24, 2015 | GMC Cars & Trucks

1 Answer

I have a 95 chevy pick up with 6.5 diesel engine and converted to gasoline engine witch is 5.7 vortec engine and change all the wire harness inside the cab and engine compartment. Trying to figure out the...


Hi :) Check the wiring harness for a fuel pump relay that is on the firewall. The trans is computer controlled (shift points, firmness, ect). You would either need to run a TBI motor from a '92-95 3-4 or 1-ton truck and get the computer to go with it. Then the new gas computer can run the trans. You will also need to swap the torque converter to a gas unit instead of the diesel. OR get whatever motor you want, and then use a stand-alone controller for the trans. They cost about $600+ for the controller. Still need to do the torque converter. You could run the diesel TC but it just wouldn't perform to full potential.It will bolt up, but a diesel transmission is different from a gas transmission. Diesels shift way earlier and only go to 3500 rpm max. If yo u do the engine swap, you will need a new valve body in the transmission. I have a 700R4 in a 1935 Ford truck. It never shifted right unless I drove it manually. It always bogged down. I took the transmission to 5 different shops and no one could figure it out. After 6 years, I was telling a buddy about it and he had me bring it to his shop. He changed the valve body (was a diesel trans and I didn't know when I bought it at an auto swap) to a corvette valve body and now the truck runs great.

Mar 29, 2011 | Chevrolet K3500 Cars & Trucks

1 Answer

How do I change the starter on a 95 GMC Yukon?


there are 2 bolts holding it in place. disconnect battery, remove the 2 bolts than you will have a large and small wire which will need to be removed the large one goes to the battery and the small one goes to the ignition wiring, to install just reverse removal process

Jan 28, 2011 | GMC Yukon Cars & Trucks

1 Answer

How do I replace the main rear engine seal on 95 GMC Sierra


you have to remove the drive shaft, the cover around the bottom of the trans. Remove the torque convertor bolts,remove the bellhousing bolts from the trans. You may have to unbolt the exhaust bolts. Slide the tans back remove the flywheel to access the oil seal.

Mar 20, 2010 | 1995 GMC Sierra C1500

1 Answer

I have a 95 chery blazer transmission,came out of a s10. Will it fit in my 1996 Blazer Lt (s-10 same thing). Ive replaced before with a 96 astro van tranning and worked fine. I noticed the 95 tranning has...


It should work for you as long as there both 4L60E transmission, but take not there were a few changes to the transmission case and everything internal are the same. The key distinction of the Later 4L60-E (1997-2006) from the Early 4L60-E (1992-1997) or 4L60 (1990-1992) or 700R4 (1982-1989) is the six-bolt "hex" rear output or tailhousing / adapter pattern. The previous versions featured a four-bolt square bolt pattern at the adapter or tailhousing. Additionally, the removeable bellhousing is also another distinguishing feature. The Late 4L60-E transmission has a three piece case of cast aluminum alloy; bellhousing, main case, and tailhousing. GM shortened the package to 21.9" long - equivalent to a manual transmission of 15.4". Good luck and you should not have any problems swapping out the transmission.

Nov 01, 2009 | 1996 Chevrolet Blazer

3 Answers

Will a 1994 chevy 4l80e 4wd swap into a 1995 GMC


Yes they will swap out nicely, the years where they made the change is in 1997 and the only difference is the transmission end housing has a different bolt pattern but has the same internal parts. You may also want to swap out the servo's with a corvette servo. The cost is around $45.00 and can be done without dropping the transmission pan, this will make your transmission shift firmer and will have less clutch slip[ between gear shifts. Good luck and hope this information helps. 

Aug 19, 2009 | 1995 GMC Sierra

1 Answer

Swap 5 speed neon trans to 5 speed talon


Check the bolt pattern on both transmissions. they should be a match but may need a washer to make up for the depth of the neon trans

Jan 31, 2009 | 1995 Eagle Talon

Not finding what you are looking for?
1995 GMC Yukon Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...