Question about 2004 Chevrolet TrailBlazer

1 Answer

Lo beam headlights.not working is not fuse a What else could it be?

Posted by Anonymous on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Could be low beam bulbs need replacing.

Posted on Dec 30, 2010

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 132 Answers

SOURCE: Low beam headlight is out, doesn't look like a fuse

Check the Headlight Switch. If your headlights come on automatically check the headlight sensor and its associated relay.

Posted on Mar 26, 2009

  • 1 Answer

SOURCE: Jeep Headlights not working. High beam works

had the same problem on my 92....check under the hood on the drivers side,towards the front,there is a "junction box" with all of the lighting wires connecting from the switches to the lights.My wires were all corroded inside,so I cleaned the ends and bought a new box from the local electronic supply store.The problem has not come back.

Cheers

Posted on Jul 15, 2009

  • 14036 Answers

SOURCE: My headlights don't work on low beam, but will

SOUND LIKE DIMMER SWITCH PROBLEM.MAKE SURE LOW BEAM BULBS NOT BURNED OUT FIRST.

Posted on Oct 26, 2009

Testimonial: "I will know tomorrow if that's the problem. Just getting home now with the high beams on all the way. Thanks in advance."

  • 1 Answer

SOURCE: low beam headlights not working. High beams working. Fuses are OK

Have the same problem with my 05. Do you have fog lights as those will not turn on either. I thought it was the switch on the stalk but that worked the same when I changed it out. I did notice a bit of a melted spot. Relays and fuses good. I'm guessing a bad ground but WHERE

Posted on Mar 29, 2010

cool78259
  • 228 Answers

SOURCE: parking lights turn on, headlights

If you ran a separate wire to the lights, it's not a ground problem. looks like you may have a bad switch.

or bad wire. you can use an ohm meter to check the wire from the switch to the light. a test light is

easier. test for voltage at both ends of the fuse, at the switch and the wire before the light. check the

connection at the light, sometimes the connections get corroded and voltage will not pass thru. good luck!

Posted on Feb 13, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the right headlight low beam relay switch on a 2014 Honda Ridgeline


Hope this helps a little. There are fuses for left and right lo beams, did you use a test light and check voltage on proper fuse. If the lo beam works on the other side, the problem isn't the relay. might be the fuse or wiring circuit? Just my opinion.
headlamp relay-pb0tcqhf52srd3tgoe3vtevu-4-0.jpg

Mar 29, 2018 | Honda Cars & Trucks

1 Answer

Is there a relay for the low beam headlight on a 2007 Buick LaCrosse . And where is it located?


# 35 under hood fuse relay box
HDM BEAM Module
--
LF LO BEAM and RF LO BEAM Fuses

Mar 20, 2016 | Buick Cars & Trucks

1 Answer

2003 yukon XL one headlight is not getting power, how do i troubleshoot?


If low and high beam both are failing to work check the ground for that side . If high or low one works and the other does not check the fuse for that beam as it has 4 fuses one for each side and low and high. The fuses are in the underhood fuse block . Marked as LO HDLP LT, HI HDLP LT, LO HDLP RT and HI HDLP RT . They are 10 amp fuses .

Feb 04, 2016 | 2003 GMC Yukon XL

1 Answer

Jeep Cherokee sport headlights not working. High beams okay. Replaced headlights


i would check the switch first. have a helper with a testlight or voltmeter help you chase the voltage down. where the voltage stops is usually the problem

Nov 10, 2013 | Cars & Trucks

2 Answers

I have a 2005 buick lacrosse. The low beam headlights have stopped working again(2nd time) The first time, even though the warning light was on, nothing was found wrong in the system. The headlights just...


https://postimg.org/image/agdjusdgl/

Click on the link. What testing have you done. Did you check for voltage and ground at the lo beams? Use a test light. In the diagram, the top wire for low beams is voltage, the bottom wire is ground. There are lo beam fuses, check those. Check voltage at fuse with lo beams turned on. It might be possible to unplug the low beam relay and use proper jumper wire on proper terminals to see if lo beams will operate. If they operate with the jumper but not w/o, check the control side of relay.
Your head lamp switch and dimmer are both inputs to bcm. I can only help with testing. You have to do the testing.

Feb 19, 2018 | Buick LaCrosse Cars & Trucks

1 Answer

Low beam Headlights out. Not the fuses or the


Hi, check the low beam relay, relay's for the headlights should be either near the fusebox, or under the engine compartment, if not this may be hi/lo beam switch, hope this helps :)

Dec 26, 2009 | 2007 Isuzu Ascender 7 Passenger

1 Answer

1997 town car, low beam head lights don't work and the high beams only works on flash pull


Try headlight relay, could be fuse as headlight flash is on different circuit i think, or could be hi-lo beam switch, good luck

Dec 24, 2009 | 1990 Lincoln Town Car

1 Answer

I have a 1998 Chevrolet K2500 that the headlights are not working correctly on. When I turn the headlights on nothing comes on unless I turn on the high beams, only the high beams are on, no low beams. ...


Somehow the tan wire from the low beams has been cut from the hi/lo switch and is now attached to the brown wire from the headlight switch. Trace the tan wire from the headlights to the hi/lo switch to see what happened.

0996b43f80231a23-jnh1p0frnkt3q2fbcpfimq4v-1-1.gif

Aug 11, 2017 | 1998 Chevrolet K2500

1 Answer

Lo-beams not working


Hi manolonusa,

It may have something to do with your headlights, but my first thought is they are just a symptom of another problem.

I'd check on the alternator. If the ALT fails, a good battery will keep the car running for quite a while. Sometimes the first symptoms are the dimming of the headlights. So:
  • Make sure belts are tight.
  • Get a meter and test the output voltage while its running (be careful when doing this).
  • Check the voltage at the battery when stopped and when running.
  • Same thing with headlights on and off.
Get back to me with the results. Once the alternator is ruled out we can check a possible headlight problem. But this way, at least you won't be stranded somewhere with a dead battery.


Sep 05, 2008 | 2004 Mazda 6

Not finding what you are looking for?
2004 Chevrolet TrailBlazer Logo

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...