Question about 2002 Chevrolet Silverado 1500HD

1 Answer

What is normal oil pressure - 2002 Chevrolet Silverado 1500HD

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 36 Answers

40 psi after warm up is a good oil pressure. If it is getting below 20 psi, there could be some engine wear. This is my feelings and have seen oil pressures range up and down a lot.

Posted on Dec 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No oil pressure at idle speed but normal oil pressure at high idle


Bad sensor or switch. Put a gauge on engine confirm

Nov 28, 2015 | Cars & Trucks

1 Answer

Oil light on while running


Normally, the oil light indicates low oil pressure, usually due to lowe oil level. That being said, is you have a constant oil light with the engine running and you are not getting clacking noises from the valves, you may have a defective oil sender. Regardless, it is not worth destroying the engine to find out. You should immediately shut the engine and check the oil level. If it is very low, add oil and retest. If the fault persists, attach a mechanical oil pressure gauge to the engine. If the pressure is normal (usually 30-45 psi), then change the oil pressure sensor. If the oil pressure is less that 20 psi, you should investigate the oil sump and pump for problems.

Oct 04, 2015 | Cars & Trucks

2 Answers

High temp low oil pressure light comes on after driving for a few minutes, then off when engine at driving rpm. At stop light (idle or low rpm) light comes back on. Normal driving it goes out.


You need to find out why you have low oil pressure. It is normal that as engine rpm's increase, the oil pressure will rise- the oil pump is moving oil faster. Even though your light goes out, you could still have critically low oil pressure. There should be sufficient pressure at idle to keep the light off. The light will come on when your oil pressure is almost nil- I believe for some it's as low as 8 psi. Normally, oil pressure at idle is specified anywhere from 15 to 40 psi. You would have to check specifications for your Expedition. To verify oil pressure, hook up a mechanical gauge at the oil pressure sending unit on the engine block. Check with a local shop.

The causes run from easy, simple to budget busting ruin. Low oil level, wrong grade oil, real old oil, oil leaks, internal oil leaks, worn oil pump, worn crankshaft bearings. It was pretty common on older very high mileage cars to have a fluttering oil light at stops and idle. It was time for a rebuild, or time to look for another car.

Jul 06, 2015 | 2003 Ford Expedition

1 Answer

00 lincon navigator 5.4 oil pressure drop's low and light comes on , engine idles rough when pressure drops ,then pressure return s to normal range ,light goes out ,engine runs perfect. Is it my oil


Sounds more like an engine idle issue than a oil pressure issue. If the engine idle drops too low, the oil pump cannot provide sufficient oil pressure. If there is no oil light when the engine is idling normally, then there is no problem there.

Dec 25, 2014 | 2000 Lincoln Navigator

1 Answer

2001 Chevy Silverado c1500 pickup has very low oil pressure, what do I need to look at?


Do not drive the truck until the issue is resolved.

1. Make sure the oil is at the proper level in the engine with the correct spec oil for the pickup. Oh it is normal for the oil pressure to be a little low at idle and go up to the normal range as the engine rpm goes up to normal operating range.

2. It could be either a real problem or a problem with the oil pressure indicator. To verify which connect a mechanical test pressure gauge of the proper range say a 0-100 psig scale to the point where the oil pressure sensor is connected. After it is connected test run the engine for a short period. If the pressure shows normal replace the oil pressure sensor. If the gauge confirms the low oil pressure then you have a serious issue in the engine. It could be:

1. Bad oil pump or oil pressure relief valve

2. excessive clearance in the bearings due to high miles.

Nov 17, 2014 | 2001 Chevrolet Silverado 1500

2 Answers

Low oil pressure


Are you running oil of proper viscosity for temperatures in your area?

Jan 11, 2014 | Cars & Trucks

2 Answers

How can i fix the oil pump


see this tips and fix it. God bless you
The oil pump supplies oil to lubricate your engine. If the oil pump is worn or is not turning, the engine will suffer a loss of oil pressure, which may result in engine damage or engine failure.
The first sign of trouble may be a low oil pressure warning light, a drop in the normal reading on you oil pressure gauge (if your car has one), or the appearance of ticking or clattering sounds from your engine.
As a rule, most engines only need about 10 PSI of oil pressure for every 1,000 RPM of engine speed. Oil pressure will read higher than normal when a cold engine is first started because the oil is thick. Oil pressure will gradually drop as the engine warms up and the oil thins out. So normal oil pressure on a warm engine cruising down the highway is typically 30 PSI up to 45 PSI.
SYMPTOMS OF OIL PUMP TROUBLE
The first thing you should do if any of these symptoms occur is to stop your car, turn off the engine, let it sit for a few minutes, then check the oil level on the dipstick. If the oil level is at or below the ADD line, add a quart of oil to bring the level back up to the full mark. Add as much oil as is needed to raise the level to the full mark. Then restart the engine. If the warning light remains on, or the oil pressure reading does not climb back up to its normal range, or the engine noise does not go away, you may have a bad oil pump.
The other possibilities include a bad oil pressure sending unit, or a problem with the oil pressure warning light circuit or oil pressure gauge.
OIL PRESSURE SENDING UNIT
If the engine is NOT making any unusual noises and seems to be running normally, and the oil level on the dipstick is FULL, but you are still getting a low oil pressure warning light or low gauge reading, the fault could be a bad oil pressure sending unit.
The oil pressure sending unit is mounted on the engine block. On some applications, there is a spring-loaded pressure-sensitive diaphragm with a switch inside the sending unit. This switch completes the circuit to the low oil pressure warning light if oil pressure drops below a certain threshold. The unit may stop working if the diaphragm inside fails, if the switch is stuck, if the small hole that allows oil to enter the sending unit becomes plugged, if there is a loose, corroded or broken wiring connector at the sending unit, or there is a fault in the wiring circuit between the sending unit and warming light.
On vehicles that have an oil pressure gauge (electronic, not mechanical), the oil pressure sending unit has a small rheostat inside that sends a variable voltage signal to the oil pressure gauge when the diaphragm moves. A worn spot on the rheostat or any of the other problems just described for the simple pressure-type oil pressure switches can cause a problem.
FORD'S FAKE OIL PRESSURE GAUGE
On many Ford vehicles that were built from 1980 through the 1990s, the oil pressure sending unit has two switches, a low pressure and a high pressure. These vehicles also have an oil pressure gauge, but the reading on the gauge is not a true indication of real oil pressure. As long as the pressure to the sending unit is between high and low, the gauge will read normal. If oil pressure drops and trips the low pressure switch, the dash gauge will now read low. Or, if oil pressure goes up and trips the high switch inside the sending unit, the dash gauge will read high. Consequently, don't rely on the oil pressure gauge for an accurate reading in these vehicles. It is only a gross indication if the oil pressure is low, normal or high.
OIL GAUGE PROBLEMS
If the engine is NOT making any unusual noises and seems to be running normally, the oil level on the dipstick is FULL, and you have replaced the oil pressure sending unit but are still getting a low oil pressure reading on the dash gauge, the fault could be in the wiring circuit between the sending unit and gauge, or the gauge itself might be bad.
Check the wiring connections on both ends as well as wiring continuity between the sending unit and gauge. If no wiring faults are found, hook up a pressure gauge directly to the oil pressure port on the engine and check oil pressure with the engine running. If the engine-mounted gauge shows normal oil pressure but the dash gauge is reading low, the problem is a bad dash gauge.
On the other hand, if the engine-mounted pressure gauge reads low and you have done all of the above, chances are the oil pump is worn, or it is not picking up enough oil because of a restriction or blockage in the pickup screen in the bottom of the crankcase.
OIL PUMP PICKUP PROBLEMS
The pickup tube has a screen on the end to prevent large chunks of anything bad that ends up in the crankcase from being sucked into the pump. But we are talking BIG chunks of debris, not normal wear particles or carbon or dust or other microscopic-sized abrasive particles that can cause pump wear over time.

Sep 28, 2012 | 1996 Toyota Tercel

2 Answers

Oil gauge drops low at idle


Low oil pressure at idle can be caused by an engine with worn rod or main bearings due to (usually) high mileage . This however does not mean the engine is still not serviceable as long as the oil pressure is low only at idle. The pressure should at minimum get into the normal range at anything above idle speed.Not much oil pressure is really necessary at LOW speed. At low speed, as long as there is oil getting to the bearings, even at low pressure, you are OK. In a high mileage engine the oil pressure is often low at idle simply because the oil pump is turning slowly and cannot maintain higher pressure between the larger than normal crankshaft and bearing clearances. As speed increases the pump turns faster and supplies more oil and the pressure should go higher. Low pressure as long as it is only at idle is not a problem. However at higher speeds the pressure should be in the normal range. Such a worn engine can benefit from higher viscosity (thicker) oil such as 20W-50 in above freezing weather and 10W-40 in winter. That will increase idle pressure and the thicker oil film maintains a better film between the worn parts

Apr 08, 2012 | 2002 Jeep Grand Cherokee

1 Answer

Getting a "Low Oil Pressure" message on the dash board.."Turn off engine" any ideas of what the problem might be?


Hi. This issue has several causes, but the oil light indicator is a strong sign of low pressure in the engine. This will cause the engine lubrication rate to drop, thus, producing a illuminated oil light, and erratic Oil pressure readings. The necessary actions are to have a manual oil pressure test ran on this engine, asap. When running a manual oil pressure test, you will discover if the true oil pressure is low, or normal. If the test proves that the oil pressure is, indeed, low, this will confirm that the Oil pump is suspect.

Now, if the true readings given during the manual oil pressure test are indicating that the pressure is normal, this will be the result of a failed sending unit(oil pressure switch).

Jan 11, 2010 | 2003 Chevrolet TrailBlazer

1 Answer

Oil lite came on right after oil pan gasket


Hi. This issue has several causes, but the oil light indicator is a strong sign of low pressure in the engine. This will cause the engine lubrication rate to drop, thus, producing a illuminated oil light, and erratic Oil pressure readings. The necessary actions are to have a manual oil pressure test ran on this engine, asap. When running a manual oil pressure test, you will discover if the true oil pressure is low, or normal. If the test proves that the oil pressure is, indeed, low, this will confirm that the Oil pump is suspect.

Now, if the true readings given during the manual oil pressure test are indicating that the pressure is normal, this will be the result of a failed sending unit(oil pressure switch).

Dec 23, 2009 | 1985 Oldsmobile 98

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...