Question about 2008 Land Rover Range Rover Sport

Open Question

Where is the battery located on a 2008 Range Rover Sport

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

handybc70
  • 25 Answers

SOURCE: Where is the battery located in 2008 Equinox Sport?

Hiya...
If you stand at the front of the Equinox's hood that's open, look at the bottom-right corner area behind the headlight area, the battery is 'hidden' underneath the black box-like part that you need to remove clips or screws to lift it up to gain access to the battery cover to reveal the battery sitting onto the battery tray.
It's one of the common thing most people wonder where the battery is located.
The battery is secured into place by a large bolt/black rectangular shaped part onto the battery tray...just unbolt it and you're ready to pull it out.

Posted on Apr 05, 2009

  • 366 Answers

SOURCE: how to fit angel eyes to a range rover sport

you are not suppose to remove the lens cover, they are glued on, but if you really want to do it, you can try and use a diy blade and separate the cover and the lens, but it is not reccomended,

Posted on Jan 24, 2010

Testimonial: "ok thanx for your help"

  • 510 Answers

SOURCE: How do you reset the service mileage light on a

e mail barrycorrin@manx.net for download

Posted on Mar 27, 2009

  • 9 Answers

SOURCE: HOW DO YOU RESET SERVICE LIGHT ON A 2006 RANGE

reset service light. The SIA information is stored in the instrument cluster EEPROM and can only be reset by using T4. (Dealer tool)

Posted on Feb 25, 2010

  • 50 Answers

SOURCE: what is the procedure for oil change on 2009 range

Hi,

Never change your oil while the engine is hot! Let it cool for a few hours, oil can burn you badly.

Be sure you have a safe area to do your oil change. Level, solid ground is a must so that you can safely jack up your car. I also like to put something on the driveway or garage floor underneath the engine in case you spill. Cardboard or a piece of plywood are great for this.
Before you even start to do your oil change, be sure you have everything you need to get the job done.

What You'll Need

  • Ratchet or open end wrench
  • Oil filter wrench
  • Oil catch/recycle container
  • Funnel
  • New oil filter
  • New Oil
  • Clean rag
The first step in an oil change is to get the old stuff out of there. The oil drains out of the oil pan at the very bottom of your engine. The oil is held in by a drain plug that looks like a big bolt at the bottom of the pan.

Before you remove the oil drain plug, be sure that your recycling container is positioned underneath the oil drain. An oil change can be no fun if most of your time is spent cleaning up oil. When you remove the drain plug, let it drop into the top of the recycling container. There's a screen on top that will keep it from dropping into the muck.
Let all of the oil drain out, then replace the drain plug, tightening it to your cars torque specifications (or "snug but not too hard" if you are sans torque wrench.)
Put the cap on the oil recycling container so you can drop it off at a location that accepts used oil -- most full service gas stations accept it.

Next you need to remove your old oil filter. Using an oil filter wrench, turn the filter counterclockwise until it's free. Be careful with it, it's still full of old oil that can spill and make a mess. Some oil filters can be reached from the top, but for most you'll have to be under the car.

With the old oil out and the old filter out of the way, it's time to put the change in oil change. But before you install the new oil filter, you have to prep it. Before you screw the new oil filter into place, lubricate the rubber gasket on the end of the filter with some new oil. Next, fill the new oil filter with oil to about 2/3. It's ok if you go over that amount, it just means you might spill a bit when you screw it on.

Carefully screw the new oil filter into place. Remember, it has oil in it so don't forget to hold it upright. It screws on clockwise. You don't need a wrench to install the new oil filter. Screw it on as tight as you can get it with one hand. Overtightening the oil filter can strip its threads and cause a leak. Of course, not tightening it enough can cause a leak. So screw it on as tight as it will go with one hand, but no more.

Now you're ready to fill the engine with oil. Unscrew the oil fill cap and insert your funnel. I like to buy the 5-quart containers of oil (cheaper) but if you're using single quarts that's fine, too. Check your owner's manual to find out how much oil your engine holds. Pour a little more than 3/4 that amount into the engine. For example, if your car holds 4 quarts of oil, add 3 1/2.
If you're using a 5-quart container of oil, there is a guide on the side that shows how much oil you've put in.
You're not finished yet so don't drive off.

We didn't add all the oil because there may still be a little oil here and there we didn't account for. Check your oil and add more until you're at the right level.
Be sure to put your oil cap back on! Oil spray can cause a fire.

Best regards.

Posted on Oct 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 range rover sport v8td has a rubbing or knocking from rear end on slow pull away.


If it were the prop, you have vibration at high speeds/out of balance. Look at the back of both wheels. If one has oil around where the rearend meets the backing plate, bad axle bearings.

Jul 03, 2016 | 2008 Land Rover Range Rover Sport

1 Answer

How do you turn the airbag light off in a 2008 range rover?


why is it on? Is anyone sitting in the seat? If it is coming on itself while you are driving, something is wrong with the system and it must be looked at by a certified dealer. I need more information

Feb 12, 2015 | 2008 Land Rover Range Rover Sport

1 Answer

Range Rover Sport 2008 2.7 HSE diesel seperatine routing diagram?


there should be a belt routing diagram on a decal under the hood somewhere that shows this.

Aug 24, 2014 | 2008 Land Rover Range Rover Sport

1 Answer

Why battery keeps going dead even when driving


check the condition and tension of the drive belt. Have the alternator out put checked . Check that the rectifier pack is operational as 14.5 ac will not charge a battery

May 24, 2014 | 2008 Land Rover Range Rover Sport

1 Answer

Where is the fuse for the sunroof on a 2008 range rover sport supercharged?


Where is the fuse for the sunroof on a 2008 range rover sport supercharged?

Feb 21, 2013 | Land Rover Cars & Trucks

1 Answer

I need a manual for a 2008 range rover supercharged sport or answers to my questions


I'm also looking for a 2008 RR Sport manual. I was told that they only come on disks now and getting a replacement would cost $150...

Nov 30, 2010 | 2008 Land Rover Range Rover Sport

2 Answers

Range Rover display warning unknown


I have the same problem and I can't seem to find a solution. Help!

Feb 16, 2009 | 2008 Land Rover Range Rover Sport

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

2,079 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75005 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7712 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...