Question about 2006 Mitsubishi Colt

1 Answer

Where is the diagnostic point in a colt cz1 - 2006 Mitsubishi Colt

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 2,422 Answers

Under the dashboard in the steering wheel area all cars are in this general area and all connectors are the same 19 pin connector called the data link connector

Posted on Dec 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does the 2006 5 door colt 1.1 cz1 have a chain belt or a timing belt?


It has chain which is easily visible when you open Oil top up cap on the top of the engivne. .

Jan 08, 2014 | 2006 Mitsubishi Colt

1 Answer

Mitsubishi colt 1.1 czs 2008, my colt would not start so bumped it and started but for 5 mins or so engine made a whining noise. have now turned of and it now starts and runs ok, FOR NOW, is this a starter...


I has the exact Same happen to my 2008 colt cz1 Same 5min whin Everything. This was about 8 month ago now and has never happened again yet. Asking around told Do Not Jet wash engine Bay or get the cpu in the Bay wet as a common fault on These cars is water getting in to cpu which causes difficult Start up and rougth running. If is water damage it may dry out and Run ok or new cpu is expensive. Mitsubishi of corse Know nothing of this fault when it happens even though Most mechanics Know its the First thing to Check for on These cars and the smart for4 which has identical parts and identical problem. Hope this helps you it did me when Mine did the Same thing. Mine dryed over Time and now Starts and runs like new. It is not battery or alternator as any Tester will show. It happens again repost request and i,m Happy to help or Talk you through fix .matty b

Apr 11, 2013 | Mitsubishi Colt Cars & Trucks

2 Answers

My Mitsubishi colt CZ1 (07 plate) has problem with cental locking. I can manually central lock but with the remote it locks/unlocks all the doors except the driver's door. Please help. Thanks


Central locking works by way of little electric motors that engages and disengages the door lock. The drivers door has an additional set of contacts in the actuator which signal the controller when it changes position. The controller activates the servo motors when a signal is received from the receiver or from the drivers door servo motor. So in your case I suspect the motor part of the drivers door actuator is done for.
To replace you will have to remove the inner driver's door panel to get at the actuator. The actuator itself cannot be repaired and needs to be replaced as a unit.

Apr 29, 2011 | 2006 Mitsubishi Colt

1 Answer

Change timming belt. where marks have to be set? 92 dodge colt


I lost you, stupid computer. Anyhow there are 8 different engines for the dodge colt in the early 1990's I can only assume its the 1.4L, 1.5L or 2.4L. The 1.4L & 1.5L the timing marks are exactly the same. The Cam points to 3:00 marks ther. The crank points almost straight up, slightly to the right, mark on engine cover. The 2.4L has 3 marks, The crank has an alignment mark at approximately 10:00, the cam sprocket points straight up at 12:00 and the idler pulley (to the right of crank shaft pulley) points approximately 11:00. They should all have a notch or mark when aligned. The short secondary belt, the crankshaft should be in the same location 10:00 and the balance shaft (to the left) should be at 9:00. This goes on after of course. Rotate engine 2 full revolutions and recheck marks before starting engine.

Feb 02, 2011 | 1992 Dodge Colt

1 Answer

Mitsubishi Colt Cz3 1.3 2008 start problem in a cold seasons


This dosen't help but.........
I have a similar problem. Every 4 weeks or so the car refuses to start. Again battery is not a problem but if we use cables to jump start from another car it starts fine.
Mitubishi cannot find the answer, only suggestion was to spend £150 on a new key , however the problem has now occured with both of the keys !

Feb 03, 2010 | 2006 Mitsubishi Colt

1 Answer

Engine diagnostics


If the light says Service Engine Soon, you can go to Auto Zone and they are glad to hook up a diagnostic code reader and let you know what is wrong with the car. I hope that it is nothing major. My fingers are crossed for you.

Jan 12, 2009 | 1995 Dodge Intrepid

Not finding what you are looking for?
2006 Mitsubishi Colt Logo

Related Topics:

494 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...