Question about 2001 Chevrolet S-10

1 Answer

How to remove fan from 2001 chevy S10 - 2001 Chevrolet S-10

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,428 Answers

It depends on what engine you have and if it has AC or not. Some you unbolt the fan from the clutch 2.2 2.4 with on AC with AC you need to unbolt fan from pulley with the clutch 4;3 you have to remove fan and clutch at the same time by loosening the large nut that is threaded to the water pump shaft its right handed thread and thats with or with out AC

Posted on Dec 29, 2010

4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 187 Answers

SOURCE: how to remove tail light

Hello, if you open the tailgate, there are 2 screws, that hold the lamp in. If you remove these two screws, you can then remove the lamp, and have access to the bulbs. (Make sure you have a new bulb ready). Good luck...coop442000

Posted on Sep 25, 2010

  • 218 Answers

SOURCE: how do u remove the front axle on chevy s10 2001

been there doen this, remove the wheel, brake caliper and pad's, brake rotor, 4wheeldrive hub wheel bearing and abs asembaly ( this is all one unit, there are 3 bolts in the back side ot the spindle) upper and lower ball joints then finally the axel will come out, it will take alittle forse there is a snap ring on the diff end that takes a littel determination to get out, sound's like more work than it is, make shure u do one side at a time in case u foget how somthing goes and be carfull with the abs sensior wire and brake caliper hose! neither has to be diconected as long as u tie the componits up so thay are out of the way and won't fall any more proble fell free to ask i have owed s-10's all my life and curently have a 2001 s-10 blazer LT and a 1996 jimmy sle love them both and so does the wife! lol

Posted on Jun 05, 2010

  • 4399 Answers

SOURCE: How to install door latch on extended cab door

I can give you the steps.

Posted on Feb 19, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What would cause you to lose fuel pressure while driving.

Chevrolet S-10 Questions - Fuel System Loses Pressure ... > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ... > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...
Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...

Dec 10, 2015 | 1994 Chevrolet S-10

1 Answer

Door pin and bushing

If your S10 is a 2001, your best bet is likely to be a junk yard

Jun 27, 2013 | Chevrolet S 10 Cars & Trucks

1 Answer

Fan won't work on ac in 2002 chevy s10 truck

Check for any relay or fuse or seized fan.

Sep 10, 2012 | 2002 Chevrolet S-10

1 Answer

How to change ac blower motor on s10 chevy truck 2001

Go to your passenger dash . It should be accessible under the glove box. It probably has old papers from the glove box or tree leaves. remove 3 to 4 7mm screws that hold it in place. Drop the fan and re-install the new one or clean out the old.

Jun 26, 2012 | Cars & Trucks

1 Answer

1993 Chevy S10 Blazer Serpentine Belt replacement

You use a breaker bar to move the tensioner, remove the belt and use the tensioner to put it back. You draw the belt and pulleys on a sheet of paper before removing, otherwise there should be a small diagram of the belt and pulley positions on the fan shroud or radiator support.

Jun 25, 2012 | Chevrolet S 10 Cars & Trucks

1 Answer

How do you remove blower motor on 1998 chevy S10 pickup

Remove the coolant reservoir.
Remove the rear coolant recovery reservoir mounting stud.
Disconnect the cooling tube from the blower motor.
Disconnect the electrical connector.
Remove the 5 blower motor and fan assembly mounting bolts.
Remove the blower motor and fan assembly.
Reverse proceedure to install.

Jul 30, 2011 | Chevrolet S 10 Cars & Trucks

2 Answers

The fan is not working in my 1992 chevy s10. where is the fan located under the hood?

do you mean the engine fan.....?look through the front grill......

Jun 07, 2010 | 2001 Chevrolet S-10

2 Answers

Advice on how to take the fan clutch off

There is a special tool for removing the fan but sometimes it will come off by using an adjustable wrench.It has normal threads not reverse threads so to get it off go lefty loosey.What I do is tap the wrench with a dead blow hammer.This seems to help.Then remove the fan clutch from the fan.Reverse procedure for installation.Hope this helps.Good luck.

Feb 18, 2010 | 2001 Chevrolet S-10

Not finding what you are looking for?
2001 Chevrolet S-10 Logo

631 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides