Question about 2002 Jaguar Vanden Plas

1 Answer

I have an 02 vanden plas. the headlights wot come on. when i use the dimmer switch on the left of the column and pull for brights nothing happens. when i push it forward all four lights come on. i,ve replaced all bulbs still no head lights. can you tell me where to locate the fuses for the head lights to check? or whats next

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Jaguar Expert
  • 322 Answers

I don't know about this particular car, but you may have a relay problem as all the functions on main lights are done by relays due to the high current required, I would say your fuses are okay as you can get all the lights lights to work using a different control relay - if I have understood you correctly.

Posted on Jan 07, 2011

Testimonial: "thank you very much. perhaps you can tell me where and which relay that might be"

  • Raygin
    Raygin Jan 10, 2011

    I do not have the exact info for your car but normally the headlight control relays are found in the main fuse/relay box in the engine department. They will be shown in your handbook under electrical. sorry cannot be of further help. (you may find further info on a jaguar forum)

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turn signal/brights/wiper switch


you have a dimmer switch in the column along with the turn signal and headlight switch
the dimmer switch is usually mounted near the bottom of the column

Jun 28, 2012 | 1993 Buick LeSabre

2 Answers

Bright headlights won't turn on. We bought it use and we don't know how to turn them on. (They may not even work)


your hi/lo switch is mounted to the steering column under the dash. It operates by pulling on the signal wand--a rod going down the column pushes the switch off and on. If nothing happens when you pull back on the wand, check to make sure the rod is still in the switch and is moving down on the switch whenm you pull back on the wand. If that mechanism is good, the switch is probably bad. I have pasted a picture of the switch below. The cost is about $12 at autozone.

If the rod is not actuating the switch, someone will need to take the steering wheel off and take the column apart until reaching the actuating linkage to see what's wrong.
If you have more questions, please let me know.

jturcotte_18.jpgjturcotte_170.gif




jturcotte_171.gif

Nov 14, 2010 | 1992 Pontiac Bonneville

1 Answer

I removed the headlight switch and the markerlights stayed on and the left headlight oh the markerlight are on the left side to


Is the Wiring still disconnected from the switch?
If so, there is a contact of the Harness wiring when you left it loose. Not all models isolate accessory power suplies when the Ignition is switched off.
Regards,DT

Aug 28, 2009 | 1995 Jaguar Vanden Plas

1 Answer

Left side marker lights stay on and headlight on left side stays on very dim


you need to trace wires first cause there is a wire grounded over somewhere, could possibly be in the headlight switch

Aug 26, 2009 | 1995 Jaguar Vanden Plas

3 Answers

Need to get brights working on Corsica 1994


There is not a separate fuse for the high and low beam headlights. When you pull back on the dimmer switch do you hear it click? I am betting that you don't and this would lead me to believe that the dimmer switch is either defective or out of adjustment.

Apr 06, 2009 | 1994 Chevrolet Corsica

2 Answers

Xj8 instrument lights not on when headlights on


Make sure the dash lights aren't turned down first of all. I know that sounds basic, but I've seen it happen before. Believe the twist is near the knob to adjust the steering wheel which is lower steering column left hand side. Otherwise, I would check fuses to be sure. finally, the last thing I would do it pull the gauge cluster and check connections as well as bulbs.

Apr 04, 2009 | 2001 Jaguar XJ8

1 Answer

How do i change dimmer headlight dimmer switch on 1990 chev van


yul have to drop ur column down to get to it, not real hard to change just bolts to side of column. do not need to take column apart

Mar 28, 2009 | 1990 Chevrolet C1500

2 Answers

1996 ford ranger headlights not working


It's the dimmer switch in the column.

Jan 06, 2009 | 1996 Ford Ranger SuperCab

2 Answers

Headlights


Everything relating to do with the wiring is in the steering column, if someone has cut the wires going into the column and taped them back together in order to pull the steering column out for service the wiring needs to be replaced. the good news is if that is your problem it will cost you no more that about 30 dollars to fix it, the bad news is you have to pull the column to replace it. I hope that shines some light on it for you.

Oct 29, 2008 | 1998 Chevrolet K1500

2 Answers

1988 Jaguar Vanden replace headlight


What you need to do is remove the 2 screws on the top bezel from inside the engine bay, then underneath the outer corner of the plastic headlamp surround there is a philips screw, (put your head under neath car near from wheel) loosen the screw, do not remove it, now the headlamp plastic bezel/surround will come free enough so you can get a philips screwdriver in through the middle of the headlamp surround, there is a chrome retaining ring holding the headlamp in place, loosen the 3 philips screws (do not remove) The retaining ring will rotate and you can slide the ring out from the outer edge of the headlamp surround. The headlamp will then come out throught the middle of the surround, disconnect the 3 pin multiplug and reverse process for install.

May 18, 2008 | 2000 Jaguar Den Plas Supercharged

Not finding what you are looking for?
Cars & Trucks Logo

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...