Question about 1994 Acura Legend

1 Answer

1994 acura wont start unless i run the starter wire from starter to battery

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 750 Answers

CHECK SOELNOID,IF OK WILL BE THE IGNITION SWITCH.











TIM

Posted on Dec 29, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont starter turn over it is new?


Check battery and ground connections, they must be tight and clean. Did you run hot wire from battery positive to the starter solenoid on the starter? To the post with the small purple wire? That should have caused the new starter to operate, unless your battery connections are bad. If you cannot find the problem, may need to take starter off and have it tested. You may have got a defective one.

Mar 10, 2015 | 1994 Oldsmobile Cutlass Supreme

1 Answer

99 acura tl wont start. Replaced Nuetral safety switch, but still won't start. Lights work on dash, and head lights are bright. Any suggestions? Thanks.


Have you done the testing at the starter wiring your not receiving hot to the solenoid circuit on the starter when the key is turned over? Place a test light on the connector for solenoid hot and have some one turn the key if it lights check for constant voltage on the large wire connection from the battery to the starter. If that's all working your starter is bad.

Jan 14, 2014 | 1997 Acura TL Series

1 Answer

91 Acura legend won't turn over. Changed the starter relay and checked the starter, it's good. Now what do I do?


Power flows from Fuse 35 50A to IGN switch. Start by checking that fuse. From IGN switch to starter on black/white wire. Check for battery voltage on that wire at starter. If no voltage, check for voltage on black/white wire at IGN when turned to START. If no voltage, check for good power coming into the IGN switch on the the white wire from Fuse 35

Feb 04, 2018 | Cars & Trucks

1 Answer

1994 jeep, wont start, wont run


It sounds like you may have a bad connection somewhere. Start with your battery cables and then look at all of your ground wires as well. When you try to start your jeep see if the wires from the battery get hot.

Jul 30, 2010 | 1994 Jeep Cherokee

1 Answer

1994 NISSAN PATHFINDER WONT START I LIKE TO FIND OUT HOW CANT I BY PASS THE MANUFACTURE SECURIETY SYSTEM . BUT I HAVE INSTALLED A AFTER MARKET ALARM AND I HAVE A BRAND NEW STARTER, ALTERNATOR , BATTERY...


First thing you should have done was check and test.NOT REPLACE PARTS.Did you test the battery to determine it needed to go? Had the starter failed to turn the engine over? The Alt supplies current to run the vehicle ,and keep the battery at the proper state of charge. How did you decide on ign wires verus the other ign components? Did it start and run okey ,before you added the after market alarm? If yes, I guess you know where some of the issues are!

Feb 18, 2010 | 1994 Nissan Pathfinder

4 Answers

1994 buick regal wont start unlless a jump off,and then run good


Check the battery,have a load test done on the battery,now,it could be that the battery terminals,and battery cable ends are corroded,clean them really good,shining clean,this makes a big difference.Good idea to have the alternator checked also,while on the vehicle running,with the head lights on,and high blower motor,it should read at the battery,13.65 volts,to 14.25 volts.

Feb 09, 2010 | 1994 Buick Regal Gran Sport

1 Answer

Car wont start; jumped successfully once; wont start again; battery fine


1. Start solenoid stuck: remove minus battery cable. Remove starter. Remove solenoid and clean and lightly grease the slide.
2. Go to most Auto Parts Stores for a free test.
3. If the battery connections and Block Ground connections are not clean, make them clean.
4. Only clean the positive connection at the starter After removing the battery minus connection.
5. Use 150 grit sand paper to clean the small solenoid lead. If you must remove the small bolt be very sensitive of your applied pressure, these small bolts break and strip easily.
SAFETY: The last connection made is always the negative/minus battery connection for all starter related repairs. These wires will burn you if the battery is not safely disconnected and best when wrapped by a rag or paper towel.
Good Luck.

Jun 28, 2009 | 1994 Acura Vigor

2 Answers

I have a manual 1994 acura integra ls and it will not even turn over at all. All of the lights come on the dash and everything else works but it just wont turn over what could b the problem.


try to put your car in neutral with your parking brakes on, rev on the gas and start the car at the same time. if that doesn't work, your ignition coils may need to be replace.

Jun 08, 2009 | 1994 Acura Integra

1 Answer

My 89 Legend coupe 2.7 wont start


1st- find the short. If the previous owner said there is a short under the seat , look for it and repair it.
2nd -after repair check your charging system and battery to make sure its up to specs.

Note: I gather the under seat wiring is for seat control, maybe you could unplug it and see if the battery and alternater work ok. If it does and you can't repair wiring perhaps you can get a replacement wiring harness for that section( seat control?)

Good luck

Feb 16, 2009 | 1989 Acura Legend

Not finding what you are looking for?
1994 Acura Legend Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...