Question about 2006 Nissan Maxima

3 Answers

Snow on windows and wife turned on wipers and they didn't come on 20006 maxima ..

Posted by on

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 159 Answers

Before taking the wiper aerms and 'gear train' apart, listen for the wiper motor .. is it working ??? If not, chances are it's just the fuse ..

Posted on Nov 05, 2014

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 245 Answers

Make sure the wiper blades are not frozen to the windshield.

Posted on Jun 03, 2014

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,547 Answers

Wipers dont do very well in ice and snow after the snow and ice was cleared did they work again if not check fuse if fuse is good
First: is it the wipers, wiper arms or motor that is at fault? Most times it is the ball joint piece that comes off, disabling the wipers, and the motor is still good. This reauires replacement of the wiper arm mechanism that has the "socket" on the end, a plastic part. If it is the motor, read on... The motor is located on the passenger side, mounted on the firewall. It "connects" to the arms that move the wipers via a ball joint. The wiper arm has a plastic part that has to be "popped" off the ball of the motor to be able to remove the motor. It simply snaps back on. You facillitate this by removeing the black plastic air vent screen that runs across the engine are near the window. After removing this you will see the arms that control wiper movement. It helps to "undo" the ball/socket if the motor is loose also. Install is just the reverse.


Posted on Dec 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wipers Not returning to resting place


With ya'lls perty white heavy snow,it made your wipers get unaligned,you will have to remove and reset.It's not good to remove snow from wipers when windshield is loaded,get a scraper or blower and go at it.Wish we got snow.

Dec 03, 2013 | Acura Cars & Trucks

1 Answer

Windshield wipers stopped working with heavy snow cover


The windshield wiper circuit has an circuit breaker in it, under heavy load this breaker trips to protect the wiper motor, when the motor cools, the breaker resets automatically restoring proper wiper action.

Feb 24, 2012 | 2008 Kia Optima

1 Answer

Windshield wipers do not work. Car sat one day. Worked fine previously. 2004 Nissan Maxima. Had about 3" snow. No ice on car. Temp around 32 or 33 degrees. Brushed snow from car. Came off...


when you turn the wipers on do you hear any sound? If so, then you may have disconnected a ball joint in there behind the firewall - typically the top (black) panel (under the wipers/ at the back of the hood) comes off or you could find other access to inspect more thoroughly to be sure. If no sound, test the power to the wiper motor with a test light, if no power, check fuses, wiring, ground, etc.,
Best regards
Ck

Mar 06, 2011 | 2004 Nissan Maxima

1 Answer

During the last snow storm my windshield wiper motor for my 1997 nissan maxima broke and I had a new one ordered. I went through the process, but when it came to reataching the windshied wiper transmission...


Did you try removeing the wiper arms them selves . Then reinstall them on the splines so they will be in the correct pisition at park and won't travel to far in the opperating mode . You should be able to put them at any pisition you need to as long as the motor and interinal mechizem is functioning . I hope i understood your question correctly its a little unclear to me

Feb 23, 2011 | 1997 Nissan Maxima

1 Answer

Audi estate rear wiper not working


is the window snow or ice covered? if so, you'll need to scrape the snow or ice off of it. the wiper blade may only have frozen to the glass. after windows clear,try picking up wiper away from the glass and then turn it on. use your rear defroster to keep this from ocurring again. if none of this works, check for blown fuse under the dash. if this works,please accept my soltion and thank you for choosing fixya.com

Dec 30, 2010 | 2003 Audi A4 Cabriolet

1 Answer

Wipers wont work


is there snow or ice on window? if so, scrape the window clear of snow with a broom or ice scaper,and of course if it's ice use the scraper. your wiper blades may have simply frozen to your wind sheild, try lifting up on each one to free it them up. you may have to lift your hood up to get to them if they're recessed down below the hood. after you've lifted them up and down twice,turn them on. they should work then and never pour warm water on your windows to clear ice or snow,they can explode.if this does'nt work then check you fuse panel inside the car for a blown wiper fuse. thank you for choosing fixya.com and also if this helps please accept my solution. thank you!

Dec 30, 2010 | 1992 Chrysler Lebaron

1 Answer

A 2006 maxima wipers stop working due to the snow across the window...


clean the snow off the widows completely. they also may have frozen to the window. a very common problem. try lifting up on the wipers,each one to see if they will come on.if this does'nt help,look for a blown wiper fuse. hope this helps and never pour warm or hot water on your window to remove snow or ice!thank you for choosing fixya.com

Dec 30, 2010 | 2006 Nissan Maxima

1 Answer

2001 sonata wiper fuse keeps blowing


If the fuse blows as soon as you put it in and the wipers are off then you have a short between the fuse block and the wiper switch.

If the fuse blows only when you turn the wipers on then more than likely the wiper motor has shorted and burned out. This one is very likely if the snow storm was heavy and you was driving in it. Cause- Moving large amounts of snow and ice off the window puts a heavy load on the wiper motors.

Jan 19, 2009 | 2001 Hyundai Sonata

Not finding what you are looking for?
2006 Nissan Maxima Logo

258 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...