Question about 2003 Chevrolet TrailBlazer

1 Answer

Water pump fan loose dont know if its water pump

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Probably is. Get it fixed before it comes off and destroys the radiator.

Posted on Oct 07, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Leaking water behind fan


The water pump is directly behind your fan clutch. Most probably, it's the pump. Shaft seal is already worn out (maybe because of damage bearing). You have to replace the whole assembly or replace the shaft, seal, and bearing. These items are within the repair kit that you can buy in parts store.

Oct 23, 2012 | 1985 Cadillac Seville

1 Answer

Take the fan off the water pump


remove the 4 bolts holding the fan to the water pump it will come off

Sep 02, 2012 | 1997 Mercury Mountaineer

2 Answers

I have a 91 ply acclaim it over heats when in idle and when i stop i dont know why.


You may have a loose fan/water pump belt, a defective cluch fan, or a bad water pump, all these factor in to the reason why when you drive it doesnt over heat.
You see as you are driving the cool air is being forced through the radiator coils/fins and keeping the heat off the coolant in your radiator closed system cool thus no over heating, when you stop this principal theory stops as well and the water becomes hotter with nothing driving it through the radiator fins/veins to cool it off thus...over heating.
Check the belts first for being loose rotted or worn and repair as needed, next engine off of course grab the fan blades one hand on three o clock blade and other hand grasping 9 o clock blade and apply a pull sort of side to side movement to check if the clutch fan or the water pump has excessive side to side play, if so replace both parts that show signs of this side to side wobble/wear.
Be sure to top off any coolant that may have spilled out during operations of your engine.
Hope this helps, good luck!!

Nov 05, 2010 | 1991 Plymouth Acclaim

1 Answer

I am replacing a water pump on a 1999 dodge durango, 318 ci, 5.2 litre engine. i am already encountering problems, i started removing the water pump assembly, removed all the bolts, the whole things is...


ur supposed to unscrew the fan at that big nut and remave the cooling fan shroud first then youll have all kinds of room. snug the pump back to the motor and break that nut loose. i always use an air hammer and chisel in the left of the top flat on the nuts, it starts it in the right direction and then un threads easy. you have to hold the pump pulley and turn that big *** nut. you can borrow tools from parts store for it if you dont have anything

Aug 22, 2010 | 1999 Dodge Durango

1 Answer

NEED HELP WITH WATER PUMP PLEASE


Once you have all of the 8 bolts out of the water pump, there is nothing holding it on other than a gasket. So try using a hammer and a chisel to gently tap in the grove where the water pump separates from the block to break it loose.

Sep 13, 2009 | 1988 Toyota Pickup

1 Answer

My 1995 dakota is overheating, replaced water pump, thermostat, fan. What to do????


if the fan is working properly, the only thing left to check is the radiator...

i may be clogged or damaged so the water can't travel in it properly...

Apr 28, 2009 | 1995 Dodge Dakota

1 Answer

Remove water pump have removed outer plastic blades of viscous fan and the four small bolts behind the water pump it seems loose but will not come away, is it just the internal impeller blades dont want to...


what's up led, the large viscous nut is loosened in the clockwise direction. after you remove the 4 nuts on the water pump, you should see one hole on each side of the water pump body. if you take 2 bolts out of the thermostat housing, you can use those to thread in the pump body holes.slowly tighten each bolt equally and the pump should come out. to install a new pump, lubricate the o-ring on the new pump and just push in by hand.

Mar 21, 2009 | 1996 BMW 318

1 Answer

Vehicle information center


1997 jeep Grand Cherokee 5.2 liter V8. Water Pump. When I remove the big nut to remove the clutch fan. Will that lose the pulley that's attached to the water pump? I don't see bolts holding pulley wheel to the water pump? Is it pressed on or will it become loose when I remove clutch fan nut?

Oct 19, 2008 | 1997 Jeep Grand Cherokee

Not finding what you are looking for?
2003 Chevrolet TrailBlazer Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...