Question about Hyundai Santa Fe

1 Answer

Washer pump working, no washer fluid reaching window, refilled washer bottle already

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 784 Answers

Sounds like the water hose is kinked or the outlet ( inside the reservoir ) is blocked. also check to see if the spouts are blocked with dirt and stuff,, ( could be a blockage at the 'Y' fitting ). if you disconnect the line from the pump you should be able to blow air through to check flow to the spouts/sprayers.


Posted on Dec 29, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Want to empty screenwash bottle how?

Unfortunately the washer reservoirs are not equipped with drains, you have to suck the fluid out or run the washer until it is drained. IF what you put in is not washer fluid or water then DONT run it through the pump. Since you didn\'t say what you put in, I\'m left to assume it really shouldn\'t be in there. Get yourself an antifreeze tester and a suitable length of hose to reach the bottom of the reservoir (or sacrifice a turkey baster) and suck out the fluid. Now for the hard part - you\'ll have to wash out the remains. If the bad stuff is water soluble (antifreeze is), pour some warm soapy water in and run it through the pump. If the stuff is not water soluble (like power steering fluid) then you\'ll be best to replace the plastic bottle. If the stuff hasn\'t gone through the pump, it can be transferred to the replacement bottle.

Apr 07, 2014 | BMW X3 Series Cars & Trucks

1 Answer

Not enough pressure to pump fluid to the windshield

I just fixed one today that had scale on the inlet of the washer motor suction inside the washer bottle. I have poured vinegar inside the bottles and dissolved the scale so you could pump it out.

Oct 02, 2017 | 2009 Pontiac G6

1 Answer

Window washer does not work

the pump is located on the bottom of the washer bottle that you filll with washer fluid.look at the bottom of the washer bottle there should be an electrical plug and a rubber/plastic hose this is the pump they are attached too.disconnect the electrical connector and the hose.if you have fluid in the bottle have it drain into a container or remove the bottle from the truck and turn the bottle so the fluid won`t run out it.then change the pump.and reassemble.

Jan 08, 2012 | 2006 Dodge Dakota

1 Answer

Where is the rear window washer bottle

There is only 1 washer fluid bottle. If your rear washer is not working, it is probably because of a bad washer pump motor (There are 2 of them) or a bad rear washer switch.

Feb 23, 2011 | 2000 Hyundai Accent

1 Answer

Windsheild washer quit working

Locate the bottle that holds your wiper washer fluid first check for fluid in bottle.Second check to see if small pump on bottom of bottle is working. If not check voltage at pump or replace pump.And last check for plugged hose between bottle and nozzles. Good luck

Oct 09, 2010 | 1998 Toyota Corolla

1 Answer

My window wipers work but my window washer fluid doesn't work is there a fuse for it and if so were is it cause I can't find. Also under the hood fuse box has CMH on it but when I opened it up there was...

It sounds like the seal in the washer pump has worn and let washer fluid into the little motor, causing it to corrode and seize. Pump is usually located on bottom of washer fluid bottle.

Aug 20, 2010 | 1990 Toyota Pickup

1 Answer

How do I refill the wiper fluid for rear window?

That van only has the one washer bottle. You fill the front bottle and there are two pumps inside that bottle. If you don't have any fluid coming out the back end then check to see if 1 the pump works. If you turn it on and it you hear the noise then the pump works. 2 check to make sure that the rear line has not popped of the one way valve at the back.(you can seee the one way valve if you remove the body to gate rubber). 3 check to see if there is anything plugging the lines or rear nozel

Nov 10, 2009 | 2000 Oldsmobile Silhouette

1 Answer

My window washer fluid leaks totally out when

Generally.....3 things happen.
The washer fluid plastic bottle may be cracked....not likely.
The pump (and or gasket at the pump) may be leaking ......30%.
The rubber hose pushed onto the pump to direct the washer fluid up to the window may have popped off........70% ......most likely.

Aug 13, 2009 | 1997 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8732 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides