Question about 1992 Buick Regal

1 Answer

How to properly bleed brakes on a 1992 buick regal gs

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 136 Answers

Loosen bleeder screw connect one brake bleeder tool from autozone and other shops similar. Keep posing it untill all bibles and air comes out of the brake line. Remember to refill while bleeding.

Posted on Dec 29, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Had both front wheel calipers off and did linings. Now I have no brake pedal to speak of. Tried bleeding old fashioned two man way and did not work. Car is a 1998 buick regal LS


Do you have an electronic brake pressure pump for brake assist that you may want to make sure works properly. When turning ignition on, you should hear the motor run, also when you press the brake pedal.

Jan 02, 2017 | 1998 Buick Regal

1 Answer

1999 Buick Regal GS Anti-Lock light turns on and the car will not start.


GO TO THIS WEB PAGE AND PROCEED ACCORDING:
http://www.ehow.com/how_7685322_repair-antilock-brakes.html

God bless you

Jun 21, 2012 | 1999 Buick Regal

1 Answer

Battery is going dead every night with a 1.5 - 3 amp draw on my battery. I have a 1992 buick regal gs 3.8L


You need to eliminate some possibilities.
While reading your amp draw, you can start by pulling fuses. Make sure you don't have a glove box, trunk, or hood light on.
I have had an alternator issue that had a constant draw. I removed the large wire on the alternator and the draw went away. You can do this for your starter also.
Pulling relays may also help, just go one at a time.

Dec 24, 2010 | 1992 Buick Regal

1 Answer

I replaced rear calipers bled brakes brake on on dash and abs light is on replaced all park brake cables no rear brakes how do i adjust rears and bleed properly, do i have to do something with computer


When bleeding brakes always bleed the wheel furthest away first and then finish at the left front. if you don't get rear brakes after several attempts...chances are your master cylinder will be bad...On the brakes...check the sensors at the rear and make sure the wires are all connected and the sensors are clean/tight. The do sometimes go bad...but not that often. Are you bleeding the brakes properly? Two person or a one person with or without a one man assist unit? The easiest is the two man bleed. Have someone in the car and to gently pump the brakes until you get a nice firm pedal then have them hold down the pedal very firmly...Loosen the bleeder quickly so it pushes/flushes out the lines of dirt and air...about 8-10 times would be common for the back before a good flush/bleed is complete. When the valve is cracked open the pedal should go to the floor and should be held there until the bleeder is completely closed again...then repeat the pedal procedure until you get a nice clean stream of brake fluid and no air in it flowing from the bleeder. NOTE about every three or four times make sure you top off/check you brake fluid in the master cylinder to keep it from running out and getting more air into the system.

Dec 18, 2010 | 1992 Buick Regal

1 Answer

Need to replace stoplight switch on a 1992 buick regal


You need to crawl under the dash and look up at the top of the brake pedal arm. you will see a switch with a plunger and 2 wires that is attached to the brake frame so the plunger moves when the brake pedal is pressed. That is the brake switch.

Jul 23, 2010 | 1992 Buick Regal

1 Answer

'95 Buick Regal GS 3rd brake lights don't come on.


my 02 has 2 nuts in the trunk then it will lift out of the cat walk

Apr 19, 2010 | 1995 Buick Regal

1 Answer

Belt routing diagram for 98 Buick Regal GS


if serpentine, then it should be on the fan shroud or the radiator cover...

Mar 25, 2009 | 1998 Buick Regal

1 Answer

1999 buick regal gs drags in reverse


sounds like the hand brake is binding on, after you've reversed it back say 200yd's if possible feel for heat in the centre of the rear wheels, if they are warm/hot it's most likley you'll need to strip the brakes down before you'll be able to fix the fault

Jan 08, 2009 | 1999 Buick Regal

1 Answer

Brake lights


Bad ground RR tailamp ***'y,whether broken wire or corroded lamp socket. Start there as these can be tricky to trace. Look for the obvious first then seek a good electrical diagnostics tech.

Jun 22, 2008 | 1996 Buick Regal Olympic Gold

Not finding what you are looking for?
1992 Buick Regal Logo

Related Topics:

240 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...