Question about 2008 Pontiac G6 Sedan

1 Answer

How to remove door panel 2008 pontiac g6

How???

Posted by on

  • jayslater Mar 29, 2009

    Remove several screws and plastic pin/clips.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 1 Answer

2008 g6 sedan i want to remove drivers door panel?Curt.

Posted on Mar 29, 2009

  • lakeland119 Mar 30, 2009

    removed all visable screws only one and 1 pin clip there must be more hidden ? can't find them without damage thanks the lower part of panel has several pin clips which i got loose but middle of panel won't move is there a bolt under the arm rest or under the switch panel?

×

5 Suggested Answers

blubanshee
  • 48 Answers

SOURCE: need to remove door panel on a pontiac g6 to

I found a great write up on your door panel I think will help you out allot Click Here Its a great sight for any G6 owner. If this was helpful please dont forget to rate me.

Thanks and have a great evening

Posted on Jun 11, 2009

  • 15 Answers

SOURCE: 2008 pontiac G6 DOME LIGHT DOES NOT WORK WHEN

is the selector for the light (on, door, off) on door?

Posted on Mar 07, 2009

polarcycle
  • 1392 Answers

SOURCE: how to remove interrior door panel pontiac G6 and replace broken

Remove any bolts/screws you can see then get a plastic crowbar and pry it off. Should have little plastic push pins holding it to door. Make sure you remove all screws though.

Posted on Mar 06, 2009

HansPP
  • 2510 Answers

SOURCE: how to remove the passenger

To remove the door panel, remove any screws that are in the vicinity of pull handles and door pockets. These screws will be under little trim covers that you need to prise off to get to their heads. Look for the screws around the edge of the panel and also the screw in the latch release handle recess.
The lock knob, if there is one there, will have to be screwed off and then carefully work your way around the door, freeing the panel's clips from their holes in the door frame. (Doot panels are brittle and clip break out easily).
Finally the panel will probably have to be lifted out if the window slot. (If the panel does not come off, work out what is retaining it and remove that screw or slide it off the clip that is still holding the panel. Disconnect any electrical plugs behind the panel. Under the panel you will find a plastic dust sheet that is stuck to the door frame, remove this carefully, you will have to replace it before replacing the panel.

Posted on May 22, 2011

  • 1 Answer

SOURCE: 2008 pontiac g6 rear door locks dont lock or

My manual says the rear doors are not equipped with power locks. Manual page 2-10.

Posted on Aug 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

09 pontiac g6 3.5 car dont crank over .crank over manual


Car won't start Pontiac G6 - YouTube

? 0:39
https://www.youtube.com/watch?v=9R-No-b27H8
Mar 21, 2015 - Uploaded by Roland Weeds
Pontiac G6 2008 won't start Battery is ok. ... Car won't start Pontiac G6 ... Communication fault 09 Pontiac G6 - Duration: 29:43. ... 2008 Pontiac G6 GT Start Up, Engine, and In Depth Tour - Duration: ... Mobile Mechanic Tips: Why your 2008 Pontiac G6 will not start, turn over or crank issue - Duration: 2:30.

Pontiac G6: my car turns on but will not turn over please

www.justanswer.com > Pontiac
Question - Pontiac G6: my car turns on but will not turn over please - EE. Find the answer to ... Does the starter not engage at all when turning the key to start? Ask Your Own ... it is a pontiac g6 gt 3.5 liter. Dave Nova .... Diagnostics. http://ww2.justanswer.com/uploads/testedtuff/2009-09-26_170108_pictures.jpg John's Avatar ...

Car won't turn over. Power is good. : MechanicAdvice - Reddit

https://www.reddit.com/r/.../car_wont_turn_over_power_is_good/

RedditDec 27, 2012 - I own a 2008 Pontiac G6 GT 3.5L. Okay, so the problem started after

Jan 28, 2016 | Pontiac Cars & Trucks

1 Answer

Where do I find the fuses for front turn signals on 2008 pontiac g6


Should be on the extreme left side of the dashboard. Open the driver door and loo on the end of dash. Remove the cover (should say Fuses on it)

Jun 02, 2015 | 2008 Pontiac G6 Sedan

1 Answer

Where is the power window fuse located, and what number is it


Instrument Panel Fuse Block
25714179-gpkehlvyb00pzwahyaepcp3y-3-0.png
The instrument panel fuse block is located on the passenger side of the vehicle, on the lower portion of the instrument panel console near the floor.
Remove the console cover to access the fuse block, then remove the fuse block cover to access the fuses.
http://www.vadengmpp.com/owners-manual/pontiac/2008-Pontiac-G6.pdf

May 26, 2015 | 2008 Pontiac G6 Sedan

1 Answer

2008 pontiac g6 rear door locks dont lock or unlock


My manual says the rear doors are not equipped with power locks. Manual page 2-10.

Jul 30, 2011 | 2008 Pontiac G6 Sedan

1 Answer

My pontiac G6 fail to start after a minor accident


There is a fuel shut off switch that needs to be reset. Most common places for this switch is in the trunk or behind the passengers side kick panel by the door. Your manual should tell you where it is and how to reset. usually just push the button back in

Jun 19, 2011 | 2008 Pontiac G6

3 Answers

Y there is svc tire monitor in 2008 pontiac g6?


Hi, check all tire pressures, they need to be as close as possible to what the door panel/jam list for recommend inflation psi. If not this service tire monitor will light on dash.

May 17, 2011 | 2008 Pontiac G6 Sedan

2 Answers

Back doors do not lock or unlock with key fob or buttons?I have to unlock by pulling up on the lock manually? This is 08 Pontiac G6 Gt


Change the battery in the remote fob. Go to Best Buy or any place that sells watch size or similar batteries.

Feb 08, 2010 | 2008 Pontiac G6 Sedan

1 Answer

Mirror housing replacement on 2008 Pontiac G6


there is a plastic cover on inside of the door you must carefully remove it to access the 13mm hex bolt,that holds the mirror to the car door.if it is a power mirror you must remove the door panel to unhook the wire connector.it would help to know if it is the driver or passenger mirror.

Feb 04, 2010 | 2008 Pontiac G6

1 Answer

Need to remove door panel on a pontiac g6 to replace broken door handle?


I found a great write up on your door panel I think will help you out allot Click Here Its a great sight for any G6 owner. If this was helpful please dont forget to rate me.

Thanks and have a great evening

Jun 11, 2009 | 2006 Pontiac G6

1 Answer

How to remove interrior door panel pontiac G6 and replace broken


Remove any bolts/screws you can see then get a plastic crowbar and pry it off. Should have little plastic push pins holding it to door. Make sure you remove all screws though.

Mar 05, 2009 | 2006 Pontiac G6

Not finding what you are looking for?
Cars & Trucks Logo

1,433 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...