Question about 1991 Cadillac DeVille

1 Answer

-dawghaus510new ignition wire was installed, because car would just not start at nite or after shutting off. 1 day aafter replace ignation wire, same thing. all elec stuff works, security lite shows and will not start. both keys, tried washing them. , nothing

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 3,113 Answers

You need to replace the ign. lock cylinder and chip key. The tiny white wires have broken common problem.

Add a comment

Posted on Dec 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No ignation on plug wire . have no Ignition


Assuming this is on a ram 50 with a 2.4l mitsubiishi engine? No spark on only one cylinder or all cylinders?

Oct 09, 2013 | 1988 Dodge Ram 50

1 Answer

98 s-10 won't reliabliy start new gas tank 2 fuel pumps , fuel filter,relay,ignation module, ignation coil ,5 crank sensors .yesterday I started out 5 am. weather cool60 started & stopped 4 times no...


I experienced a similar problem on a customers 98 S-10. After much research and probing of electrical wiring, it was a faulty ignition switch. This may not be your problem but it might also? Read on it and test it by hooking a test light to the output side after the switch and if the light dies out when it dies, there is your problem. Here is a tip. Put a fuel pressure gage on the vehicle, route it up under the windshield wiper so you can see it, next hook up a timing light to any ignition wire, run the cords so you can have the light in the vehicle (so you can see it flashing not to set timing) drive the truck and as it dies what quits? Fuel pressure or ignition? At least you know what direction to look further into.

Sep 05, 2013 | Cars & Trucks

1 Answer

Radio will not go off when truck is shut off and key is removed. 2005 Tundra


Hi !
There are 2 ways to connect the radio..
1... directly to the battery... which is in your case.
2... connect through the ignation switch.... which will put off the radio every time you switch off the ingation key.

All you have to do is re-wire the power connection through the ignation..

Regards
Berry

Feb 07, 2010 | 2007 Toyota Tundra

2 Answers

1998 tl 3.2 won't start. only a 'tak' sound can be heard


it culd be problem with solinoied switch of starter, or with ignation switch, to find out, when car wont start some one have to check supply at starer solinoid small nut mounted wire, if supply is there then you can go to check if any relay is there before ignation switch if relay is fine you can replace ignation switch.

Jan 17, 2010 | 1998 Acura TL

2 Answers

My 94 accord works well in the day, but jerks at nite


Have your charging system checked. It's likely that you have a bad diode inside your alternator, resulting in a partial charge. About the only difference between day and night driving is that at night you have your lights on (using more power) that may be depriving the ignition system of full voltage. How does it run in daytime if you turn the lights on?

Jun 05, 2009 | 1994 Honda Accord

1 Answer

Low power to ignation switch


Check battery voltage with a volt meter. Voltage at ignition switch should match that of battery less 1% due to built in loss at connections and wire resistance. If not, check connections on the way to the switch, beginning at the battery to see where power drops off. Check all grounds as well.

Jun 02, 2009 | 1999 Jeep Cherokee

1 Answer

My ignition fuel starter fuse blows 2 to 3 times a day on my 98 dodge stratus!


sorry this is not going to make you happy but its a wire shorting out to the negative side of the battery it could be anywhere under the hood, look for any wire that look chaffed, hope this helps regards John

May 15, 2009 | 1998 Dodge Stratus

2 Answers

2008 Land Cruiser Ignition, shut off problems


im not sure if its helpful but you need to make sure that the led on the ignition button is green. if its yellow you should wait until it turns green. 

Aug 08, 2008 | 2007 Toyota Land Cruiser

Not finding what you are looking for?
1991 Cadillac DeVille Logo

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...