Question about 1999 Daewoo Lanos

1 Answer

Ofter fev min of engine run rpm slow down and engine sops running it starts again but stops in fev sek or min.Kontrol "engine check" light appears.During drive engine stops and starts again. It appears that is running ok on over 200rpm but not always. Mechanic check coil pack, computer and pick up sensor but it not help. I suspect it is some electric wiring problem. Hope i will get some help.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 870 Answers

Might be fuel pump that cuts from sending fuel to the engine. But the check engine light should give you a Code when its on then this will help locate the problem. Good luck

Posted on Dec 29, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2005 Sebring runs fine until I spend more than 10 min in stop and go traffic, then engine light comes on and engine stumbles as soon as it hits 2200 rpm, will not exceed that rpm driving or in park....


Scan the engine computer for trouble codes, and go from there. with the light on, there will be a code or more to follow. Some stores, like Autozone, will do code scans for free. If you get a lot of codes, first attend to those that indicate the problem you are having.

Mar 14, 2015 | 2005 Chrysler Sebring

1 Answer

I have a grand caravan sport 2003 and recently the car shut down on its own while I was stopped. Started it and it all went well for like 3 hours when I parked infront of a store and it did it again. 5...


Did you by any chance get gas before this happened? If you overfill your gas tank sometimes it affects the engine but when the gas goes down some in the tank everything normallizes

Oct 19, 2014 | 2003 Dodge Grand Caravan AWD

1 Answer

2007 chevrolet impalahave a 07 impala runs great till ur rpm meter goes past 4000rpm then drops down to 0 runs bad after shut down engine for around 10 mins then runs good again check with scanner no


It needs a scanner on it to find the problem while driving it. Several things can cause this. At 4000 rpm's in park the ecm will suppress the engine. this would be the Neutral safety switch. So going from there, if not the switch, it could be wiring or a bad buffer in the ecm.

Oct 16, 2014 | 2007 Chevrolet Impala

1 Answer

Ford Excurtion will start normal, but stall when putting in gear (reverse) or braking. When re-starting it runns ok until next braking.


Have the catalytic converter checked at your local muffler shop...clogged...worn out...Hope this helps.

Mar 12, 2014 | 2005 Ford Excursion

1 Answer

I changed the engine oil, filter and spark plugs in my 1999 Volvo 940 (1996 cc). Upon starting up, the engine runs at lower rpm and "hiccups" at idling.


Engine stalls or RPM fluctuates at idle up and down.

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control


Oct 15, 2012 | Cars & Trucks

1 Answer

1994 f150 6 cyl engine shuts down every 10 min restart after 5 min


Sounds like the module inside the distributor. Have to be replaced.

Sep 29, 2012 | Cars & Trucks

1 Answer

My engine won't start.


The oil light began to flicker beacuse of low oil pressure with the lower RPM I expect. Four things for your engine to run: 1, Spark, 2, fuel 3, compression and lastly the timing.
While running at higher RPM how well (or poorly) does the engine run?
This may be as simple as a clogging fuel filter, low pressure = poor fuel stream which = poor performance.
May be the fuel pump failing too.
Other ideas; starved for air, very dirty air filter?
Also corld be crank, cam or MFA sensor too. Sart easy with the fuel filter and work from there.

If I may be of additional help, please let me know.
Tom

Apr 25, 2010 | 2001 Mitsubishi Eclipse

Not finding what you are looking for?
1999 Daewoo Lanos Logo

139 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76070 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...