Question about 2006 Pontiac G5

1 Answer

How to put transmission fluid in a pontiac G5 4 cylinder

Posted by on

  • d_desertmama Dec 29, 2010

    we can not find where to fill it. we had to replace the pan it was cracked. so all the fluid flooded out. is it a closed system, or is there some where u can poor in the fluid after the pan has been replaced. Or do we have to take off the pan again and fill the pan and then attach it?. Someone Please HELP

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

When you remove the tranny fluid level plug the fluid should be level with the bottom of the plug. Remove the pan, clean out bottom of pan for debris, fill with GM new fluid to bottom of plug line. Ensure vehicle is on a flat surface when doing so.

Posted on Dec 28, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What kind transmision fluids for pontiac G6


I do not know what year your car is ? A 2007 pontiac g6 with a 4 cylinder engine, the transmission uses Dexron VI. It is a synthetic type of fluid.

Aug 29, 2014 | Pontiac G6 Cars & Trucks

1 Answer

I have a 1997 Pontiac Sunfire that has problems shifting into gear. (manual trany). Have to force into 1st, 3rd, 4th, 5th and especially in reverse. Will grind going into reverse. Have to turn off...


Sounds like the clutch is going out. I would check the operation of the clutch slave cylinder. Also check the clutch master cylinder fluid level.

Oct 18, 2010 | 1997 Pontiac Sunfire

1 Answer

2004 Sunfire: what type of transmission fluid do i put in my 200...


You can use dextron 3 or dextron III ATF  transmission fluid.You can get this fluid at any local car parts store in your area.
Thanks. you can rate this solution and show your appreciation.

 

May 18, 2010 | 2004 Pontiac Sunfire

2 Answers

What kind of transmission fluid goes in a 1999 pontiac montana


Recommended GM DEXRON® VI, Low viscosity transmission fluid.
Note: make sure you don't over fill transmission and the Montana's transmission are know for failures due to high fluid retention caused by high viscosity transmission fluid from additives or dirty transmission oil and filter.
Thank you for using Fixya and good luck.

Mar 20, 2010 | 1999 Pontiac Montana

1 Answer

How do i check the transmission fluid on a 2008 Pontiac G6 6 cylinder?


There are quite a few types of cars on the road with sealed automatic transmissions like your Pontiac. Yours will have a plug screwed into the front of the trans near the coolant lines. It has an 11 mm [7/16] head. Unscrew it then check the level by finding if the fluid is to the hole. It's topped off by removing a cap on top of the trans and adding fluid until it starts to run out the hole, with the engine off. Your owner's manual will list all this.

Nov 02, 2009 | 2008 Pontiac G6 Sedan

1 Answer

Transmission fluid


transmission fluid goes in the dipstick hole unless it is a sealed unit then it needs to be drained and filled with correct ammount of fluid

Jul 13, 2009 | 1997 Pontiac Sunfire

1 Answer

Adding transmission fluid to 98 pontiac sunfire


There is a plug located on top of the transmission under the brake master cylinder. It is held in place by a bolt on the side of the transmission near the firewall. Remove the bolt, then remove the plug. Fill it until the fluid comes out of the hole.

Jun 17, 2009 | 1998 Pontiac Sunfire

1 Answer

How do you replace the engine and transmission in a 1987 Pontiac 6000. It's a 4 cylinder.


Unhook wires at harnesses, unhook hoses after draining fluids, jack front end up, put jack stands under 2 front wheels under the body and position the jack under the main frame that the engine and transmission that the engine and transmission is mounted to, take bolts out of the strut towers on each side, remove 6 main frame bolts, lower jack and roll engine, transmission and frame from under car, you may have to raise back up to fully get it out

May 13, 2009 | 1987 Pontiac 6000

1 Answer

I needto know where the transmission fill is.


check the side of tranny for a plug,a master cylinder is a black dinner plate sized cylinder opposite your brake pedal it should have a fluid resiviour on it.

Jan 15, 2009 | 2005 Pontiac Grand Am

Not finding what you are looking for?
Cars & Trucks Logo

997 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...