Question about 1994 Pontiac Grand Am

1 Answer

1994 grand am no blower fan, picked up blower resistor, now i need to know where the blower motor is, can someone please help, with diagram

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

If you look on firewall passenger side there should be a plastic cover that says cut to remove motor behind that is blower motor

Posted on Jan 21, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 grand Cherokee lmtd


Had the same vehicle.. It's in the fuse box under the hood.. Take the cover off and look underneath the cover for the diagram..relay marked blower..

Nov 06, 2016 | Cars & Trucks

1 Answer

Heater fan does not work


check fuses. see if u get voltage to blower motor. if u do then u need a blower motor resistor. if u dont u need blower motor.

Feb 27, 2011 | 1994 Jeep Grand Cherokee

2 Answers

01 grand.prix ac fan switch only works on high. has a duel temp controller when you turn fan off the only way fan comes back on is to move the temp controller levers


Hi!!
When the Blower Motor Resistor (controls blower speeds) goes bad, the blower motor works only on HIGH SPEED. REPLACE IT.
BLOWER MOTOR RESISTOR Removal & Installation
  • Disconnect negative battery cable.
  • Remove right lower instrument panel insulator panel.
  • Disconnect blower resistor connector located behind right side of dash.
  • Remove blower resistor screws and blower resistor.
To install, reverse removal procedure
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa!!

Feb 18, 2011 | 2001 Pontiac Grand Prix

1 Answer

WHEN I TURN THE ENGINE OFF THTEHEATER/FAN STILL RUNS, WHAT CAN BE DONE/


Your heater fan has a resistor/relay that has failed. It will need to be replaced. Look in the fuse panel to find the fuse for the Blower motor and remove it. That will stop the blower motor from running and killing your battery. The fuse panel cover should have a diagram of the fuses that will tell you which one it is. If the fuse diagram isn't on the panel cover, look for the fuse diagram in youe owners manual.

Dec 28, 2010 | 1994 Jeep Grand Cherokee

1 Answer

The fan will not come on to blow the heat or anything on my 1997 jeep grand cherokee. PLEASE HELP


Go under the dash on the passengers side.The blower motor and blower motor resistor are located under there.With the switch on just tap the blower slightly and if it goes on then replace the blower motor.If not then follow the wires that go to the resistor and check the resistor.They like to heat up and melt the connectors.So you might have to replace the resistor and the connectors which you can get from the dealership parts department.Make sure you have checked the fuses first.let me know if you have any questions.Good luck.

Dec 08, 2010 | 1997 Jeep Grand Cherokee

1 Answer

1994 Jeep Grand Cherokee After disconecting the battery for recharging and reconnecting the battery the blower motor runs continuously. Went through the ATC diagnostics illustrated in the Haynes man. and...


Switch ,relay resistors or motor is shorted to ground.
Start with the switch and remove each one until it stops . test the item and it will probably be the culprit. Now remember most vehicles while running will have blower motor run at a low speed all the time.
The only time this should not happen is when the ignition is off.

Apr 08, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Need a wiring diagram for 2002 jeep grand cherokee limited blower motor resistor


Review this links:
- WJ Section 24 Heating Air Conditioning ewj24 (page 32 and next)
- WJ Section 08w Wiring Diagrams ewj8w
* page 19 Index
* page 221 Blower Motor - Diagram 8W-42
- Blower Motor Repair

I hope help you with this (rated this help) Good luck.

Sep 30, 2009 | 2003 Jeep Grand Cherokee

2 Answers

Heat/AC Blower fan speed only works on High


hello, this sounds like a bad blower motor resistor!! its cheap and easy to change..if you need more info on locations let me know,, good luck.....marty

May 27, 2009 | 2005 Jeep Grand Cherokee

1 Answer

Blower speeds


Since some speeds are still working you probably need to replace your blower motor resistor. This is usually located on the engine compartment firewall or inside the ductwork near the blower motor. I'm not sure where on your vehicle.When you go to pick one up ask your parts man he may know the location.

Oct 15, 2008 | 2000 Pontiac Grand Am GT

Not finding what you are looking for?
1994 Pontiac Grand Am Logo

Related Topics:

162 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...