Question about 1990 Dodge Ram

1 Answer

Leaking water behind water pump seems to be a housing bolted behind the pump,thats where the water is coming from....does it come off with the pump?" dodge 360" is the timing belt here behind pump? help please!!!!!!!!!!

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 235 Answers

The Water is coming from the diaphragm . It may seem like its coming from the bolts but it isnt. Unless water pump was recently installed with a bad seal .

Posted on Dec 28, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a water system diagram available for a honda ballade 150 luxline 1998?


There is definitely no valve there - the only pressure relief valve would be inside the radiator cap. What you see is leakage from a water pump bolt or from the water pump itself. You could try applying a waterproof sealant to that bolt, but it's tricky - allow the engine to cool FULLY, then remove the bolt and hold your finger over the bolthole while a helper applies sealant to the bolt threads. Quickly put the bolt back in the hole so you don't lose very much coolant, tighten the bolt again.

If that doesn't do it, then the leak is really coming from the front seal of the water pump - meaning the water pump needs to be replaced.

Aug 12, 2014 | Cars & Trucks

1 Answer

Where are the freeze plugs located on a 99 malibu 6 cylinder


underneath the exhause manifold side of the block. Look lihe round silver plugs.

Jan 25, 2013 | 1999 Chevrolet Malibu

1 Answer

Replaced water pump and dripping water still from somewhere underneath..Can't find where it is coming from


Check your freeze plugs also if it looks like it's still the water pump leaking it could be the timing chain cover housing this is the aluminum housing that you bolted the water pump to also make sure all the bolt are tight going to the water pump. Did you clean all the water pump bolt's and use sealant on the threads when you reinstalled them it can leak their also.

May 15, 2011 | 1991 Ford Aerostar Extended

1 Answer

Behind the water pump it leaks antifreze its not the water pump but the hose from the radiator hook up to this metal tube and goes to the water pump that join is leaking does it have a gasket in between or...


you talking about water pump bypass heater pipe the metal elbow piece to the water pump hosing.the metal elbow piece is held in place by small bolt or bolts you should have either gasket or o ring betwween where metal elbow mounts to water pump housing.replace the hoses also.some times the hose will be leaking not gasket or o ring at the metal elbow.make sure screw or screws not loose or missing to the metal elbow pipe.

Apr 17, 2011 | 1997 Geo Metro

2 Answers

I have a water leak. the hoses all seem good as does the "weep hole" on the water pump. The oil and trans fluid look normal and the car runs fine. The only thing I see is below the alternator...


Not all water pumps leak from the weep hole, if the water pump casket becomes worn then it will leak from behind the water pump. You can also have a leak coming from the thermastat housing. To find out exactly have a pressure test performed on your car.

Feb 28, 2011 | 2002 Chevrolet Impala

1 Answer

Ford mondeo 2002 Zetec 2.0 motor ..Have a small or slow water leak comming from front of motor behind water pump area ,above air con unit, where water hose goes into the motor ..very hard to see where it's...


Starting from the top down dab every joint and seam with kitchen paper towel. Between each dab and press examine the kitchen towel for dampness. It is vital that you find out exactly where the leak is coming from. You could be lucky and the leak might be fixed buy an extra half turn on a jubilee connector on a hose union or a quarter turn on the water pump or thermostat housing bolts. If the leak persists you may require a new gasket . If the leak is from the water pump shaft seal behind pulley you will see a tell tale stain on the 'chin' of the pump body. This will require a replacement of the pump.

Sep 02, 2010 | Ford Focus Cars & Trucks

3 Answers

I have a slow coolant leak that appears to be coming from the water pump area but i cant locate it. it does not seem to be leaking from any hose.


check the corners of your intake manifold with a light and small mirror i bet you have a blown intake gasket

Jan 14, 2010 | 1999 Chevrolet Lumina

2 Answers

Are there any water pump bolts behind the timing belt cover, on a 1999 vw Jetta 2.0 4cyl engine with air cond. and do i have to take the top and bottom covers all the way off the engine. Thanks for the...


Yes,but only if you want to remove the complete water pump including the thermostat housing. If you only want to replace the water pump(front section only) the part that leaks water from the small hole in the housing behind the pulley you only have to remove the 10mm bolts running in a circle!!

Regards
Phillip

Sep 12, 2009 | Volkswagen Jetta Cars & Trucks

1 Answer

Water/coolent leaking from behind the timing cover


Water pump is on the left side of the timing belt in the cover and spins on an O-ring to adjust the belt. Their is a coolant pipe to the the thermostat housing behind the timing covers backing plate also. Be sure to replace the timing belt with the tensioner/ oil seals along with the water pump. Remove the timing covers back plate and you will find two bolt to the pipe as mentioned. It has a large o-ring behind it. Have fun with this one. From: Ronnie Wrench

Apr 07, 2009 | 1991 Pontiac Sunbird

Not finding what you are looking for?
1990 Dodge Ram Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...