I had the same problem until I adjusted (carefully!) the throttle stop. It is a Torx screw that the throttle rests against at stop/idle. Apparently after a while, enough slop develops in the throttle cable & connectors that the throttle actually goes past "TDC" when the engine is turned off and it takes quite a bit of pressure to get it to move, creating a dangerous situation of sudden acceleration. The adjustment is not enough to affect engine idle speed.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
? 0:46 https://www.youtube.com/watch?v=5mjg_Ps1Ctg
Dec 13, 2012 - Uploaded by Brendan Doyle
Aurora 4.0 Exhaust Leak and Water Pump Whine. Brendan Doyle ... How to Install a Waterpump on a Cadillac Northstar engine. ...How to access spark plugs on a 2001 Oldsmobile Aurora 3.5L Engine - Duration: 3:19. Dennis ...
Depending on climate location, if in really cold weather you may want to use 5w30, but usually 10w30 is the best for year round use. All oils are pretty much the the same, but I use Castrol in my cars and I use an additive called Lucas oil treatment which really helps the parts stay lubricated.
2002 Oldsmobile Aurora V8-4.0 Replace Crankshaft (Sensors) A and B This car has 2 sensors 1- Raise and support car. 2- Remove the oil filter adaptor. 3- Remove crankshaft sensor electrical connector. For specific CKP sensor identification. 4- Remove the crankshaft sensor retaining bolt. 5-Remove the crankshaft sensor. NOTE= Inspect the CS sensor o-ring for wear or damage, if problem is found replace it also. 6- Lube O-ring with clean engine oil. 7- Install theretaining bolt TIGHTEN to 10 N.m (89lb in) 8-Install the CS sensor electrical connecror. 9- Install oil filtor adaptor. 10- Lower car. 11- Operate engine and inspect Cs sensor for oil leaks 12Perform the CKP system variation learn procedure.