Question about 2003 Chevrolet S-10

1 Answer

Chevy s10 broken vacuum line

I have a broken vacuum line at a valve behind the abs. there is a smaller line that goes to a plastic line in the wiring harness i can not find where the the broken one goes. Need vacuum diagram for 4.3l v6

Posted by on

  • Anonymous Mar 17, 2014

    Honda accord v6 vacuum lines

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I have the same problem, did you get a solution or a diagram?
gonefishn55@yahoo.com

Posted on Jul 31, 2008

1 Suggested Answer

cgtotty
  • 1 Answer

SOURCE: chevy s10 broken vacuum line

The plastic line in the wiring harness goes to the heater controls; and believe it or not , the other end goes to the vacuum tank - but its in the FENDER !!!!! behind the ABS, kinda under the drivers side hood hinge - great place to put one ain't it ? No wonder GM is going broke !! Good Luck

Posted on Dec 25, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1996 chevy s10 pickup blows hot air all the time. even with everything turned off.


In my case (1995 S10) it was as simple as the temperature control potentiometer. The pot contacts were crushed, God knows what breaks and shorts happened there. Replaced the pot and all works like a charm. 3ffe43e2-1688-4bb5-ad86-58f1c719150e.jpg

Oct 21, 2012 | 1996 Chevrolet Blazer

1 Answer

How many wires are on the starter in a 97 Chevy S10 4.3 pickup?


check the wires behind the alternator i had the same issuse it was a small eyelet wire or you could try a line from battery to power strip

Jun 16, 2012 | 1997 Chevrolet S-10 Pickup

1 Answer

Ac not working


You didn't mention WHICH ENGINE your Explorer is equipped with. However, I have fixed a bunch of those that are equipped with the 4.0L engines. The vacuum line for the heater shutoff valve is a plastic line that goes up to the front part of the engine on the passenger side. The plastic line likes to break there. ( Actually, this is the line to the vacuum reservoir, but it is the main source for the entire climate control system.)You can "mend" the plastic line by using a short piece of rubber vacuum hose and push the broken ends inside of it.

Apr 18, 2012 | 2002 Ford Explorer

1 Answer

My 2000 Chevy S10 shakes alot while idling, and the check engine light is on and blinking. I think it might be the fuel injector, I changed the wires and spark plugs but it's still doing it. And oil or...


Check the vacuum line under and in front of the throttle body...with engine idling. It is located under where the air filter snorkel attaches to the engine. Then check all vacuum lines at the intake manifold. Check vacuum lines at distribution block on firewall and check the large brake booster vacuum line from one end to the other. You'll find it!

The age of your vehicle guarantee's a vacuum leak. It may sound silly but the truth is rubber grommets and hose's shrink and dry out over time and the harsh environment under the hood makes it worse. Check all vacuum lines and fittings attached to the intake manifold, valve covers(pcv valve), and be sure to check for a vacuum fitting on top of the intake just behind the throttle body. Does it fit tight in the hole? You can seal loose fittings with a high-temp RTV (Red) silicone sealant/adhesive. Several small leaks add up and your engine, heat/AC, will be all to glad to tell you about it.

Aug 17, 2011 | 2000 Chevrolet S-10

2 Answers

Brake line on chevy silverado broken,need diagram to follow line back to box in middle of truck


Brake line diagrams dont exist like wiring diagrams do. If your truck has ABS, that's the ABS controller, and if not it's just the proportioning/metering valve.

Apr 27, 2011 | 1999 Chevrolet Silverado 1500

1 Answer

Chevy s10 turn signal switch


All the wires will be in the steering column, be sure that you got the correct switch, you may have the wrong one.

Nov 09, 2009 | 1996 Chevrolet S-10 Pickup

4 Answers

A/c comes out of front defroster. I also found a vacuum hose lose near the front firewall and I cant find out where it goes.


I tried to give you a vaccum diagram but the manufacture will not release that info to outsiders. you need to find where the hose goes to.if you loose vac to the controls it goes to defrost mode.

May 27, 2009 | 1999 GMC Safari

1 Answer

Loose vacuum line, need to know where it goes


vacuum drops at a higher rpm..ac system does have vacuum line goes to a small plastic ball it stores vacuum ..either that ball is broken or the one way check valve in line is bad

May 20, 2009 | 1997 Chevrolet S-10 Pickup

3 Answers

Chevy s10 broken vacuum line


The plastic line in the wiring harness goes to the heater controls; and believe it or not , the other end goes to the vacuum tank - but its in the FENDER !!!!! behind the ABS, kinda under the drivers side hood hinge - great place to put one ain't it ? No wonder GM is going broke !! Good Luck

Aug 03, 2008 | 2003 Chevrolet Silverado 1500

Not finding what you are looking for?
2003 Chevrolet S-10 Logo

889 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...