Question about 1995 Oldsmobile Cutlass Supreme

2 Answers

Rear brakes sticking

The abs light comes on and the rear brakes start to stick. ive all ready replaced the rotors calapers and pads once. can i disable the abs?

Posted by on

  • 2 more comments 
  • Anonymous Mar 18, 2014

    I have a 2003 gmc sierra. Been having problems with the brake either trying to stick or lock up. Not sure whats going on with it. I press the brakes when im getting ready to stop and then I accelerate and the abs light cuts on and the emergency parking brake cuts on and so I accelerate fast to try to get them to unstick and it kind of jerks and somethimes they unstick. I replace all my brakes and rotors and still does it.

  • Anonymous Mar 21, 2014

    Abs light on how to reset after replacing rotor

  • Anonymous Mar 22, 2014

    bleeded brakes light still comes on

  • Anonymous Mar 31, 2014

    I replaced the rear brake drum on my 1998 bravada. and the idle arm also. when I started the vechile the abs light came on and also the check engine light came on. the code I got for the abs was co246. I dont know what that means

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Oldsmobile Master
  • 1,224 Answers

I wouldnt do that it would be really dangerous your brakes hardware needs to be serviced and no you cant disable the abs this a saftey factor built by manufacture for your saftey and others take immediatly to brake mechanic

Posted on Jul 07, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 58 Answers

Yes

Posted on Jul 06, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Will wraped brake rotors cause them to get hot


sounds like they a warped because they got hot are these the rear rotors ? i would check for collapsed rubber lines, sticking calipers, sticking pads in the mounting brackets frozen e-brake cable the same can be checked on the front minus the e-brke cable

May 16, 2016 | 1999 GMC Jimmy

2 Answers

My brakes are scrubbing and antilock light comes on, also when ever i back up, my front left wheel makes a very loud noise. kind of like rubbing metal. whats wrong?


the noise is probably the ware sensors on the brake pads making noise the noise lets you know that the brakes are getting thin are are ready to be replaced.if you let this go to long you can damage the brake rotors, make sure you check to make sure the caliper is not sticking on the left side being this side is making more noise ,a stuck caliper can cause premature brake pads ware .

Mar 05, 2011 | 1997 Chevrolet Lumina

1 Answer

My abs light is on and when I turn slightley to the right it sounds like my tire is scraping against metal what could that be.


Sounds like a Brake Pad or Brake Pads is worn out and metal is starting to scrape metal instead of Brake Pad. A Caliper sticking will wear one Brake Pad sooner than the other one. Check for grooves forming on the Brake Rotors.

Feb 26, 2011 | 2003 Ford Expedition

1 Answer

When applying the breaks on my 2005 Chevy Cobalt it shutters and the abs light comes on .. what is the solution , do you think ?


Your brake calipers may be sticking to the brake rotor causing your abs sensor to come on. If it sticks to the rotor for an extended period of time, it could cause the caliper to actually weld itself to the rotor. I am assuming it is doing this in the front. If this is the case, you will need to replace both brake calipers, both rotors and a new set of brake pads. It is more economical to put the better parts back on it, if you can afford it.

Nov 15, 2010 | 2005 Chevrolet Cobalt

1 Answer

The front left brake is doing all the braking and is heating up. brand new caliper on both sides and new rotors and pads. Had to repair yesterday because the pad on the left was sticking to the Rotor...


ABS LIGHT ON COULD BE A BAD WHEEL SENSOR CAUSING ABS UNIT LOCK UP THAT WHEEL OVERHEATING OR YOU COULD HAVE FAULT IN THE ABS UNIT.TAKE VECHICLE TO GARAGE OR DEALERSHIP.LET THEM SCAN THE ABS BRAKE SYSTEM TO SEE WHATS CAUSING ABS LIGHT TO COME ON.

Sep 23, 2010 | 1999 Oldsmobile Alero

1 Answer

I just replaced the rear brake pads on my 03 Silverado 1500. at first it drove fine, but Ive noticed lately that the rear (disk) brakes are dragging and causing excessive heat. There is a noticable shimmy...


Your calipers are sticking and causing your brakes to drag.Did you clean and lube the caliper slides before you reinstalled them and did you have the rotors turned?I have had this happen to me after doing a rear brake job.One or both of the calipers would stick and I had to replace them.Which means you will have to bleed the rear brakes.(Rear only)Hope this helps and let me know if you have anymore questions.Good luck.

Aug 25, 2010 | 2000 Chevrolet Silverado 1500

1 Answer

Chevy Cavalier 2001 ABS Brake problem


You don't say what brakes.

I have had many cavys and worked on them. Great cars.

Your problem sounds like a **** rear wheel cylinder and bad drums/rotors and abs sensor wire.

My car just did everything you describe, I put in new wheel cylinders, drums, brakes, rotors, and 2 new rear brake lines. For less than 200 bucks the car is like new again and has well over 100k.

You can do it yourself. Doesn't take special tools. I followed online how-to's.

Apr 16, 2009 | 2001 Chevrolet Cavalier

1 Answer

Wheel sticking on peugeot 406 on a p reg


The brake hose maybe bad replace it. They can claps on then self inside the hose. One work to check is have someone push the brake paddle down and release it if the rotor is hard to turn, open the bleeder vale if fluid comes out and the rotor turns freely that you problem.

Mar 05, 2009 | Peugeot Liberte Cars & Trucks

2 Answers

98 caravan no abs


sounds to me if you replaced all of that than the power booster is sticking

Oct 12, 2008 | 1998 Dodge Caravan

2 Answers

Rear brakes way too hot. replaced the pads and very difficult to turn in, in fact had to releive pressure at the hose to get it to go in at all. Is it possible that the master is at fault? I don't want to...


it seems to me like they are rubbing all the time when in use this has got to be due to the pistons in the calapers are sticking once brake is applied, i've had the same problem but that was on my motorbike.

Jul 25, 2008 | 1991 Isuzu Trooper

Not finding what you are looking for?
1995 Oldsmobile Cutlass Supreme Logo

552 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...