Question about 2002 Jeep Liberty

1 Answer

Changing the starter

I have changed starters before but not in my jeep. Its usually pretty simple but i cant find it. My husband is in tech school with the Air  force and he is not able to help me right now. I just need to know where to find it. After that I'm good to go. Please help. Thank You.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert who has answered 20 questions.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

  • Expert
  • 45 Answers

changing the starter - 0900c15280044484.jpgThis is the 3.7 V6. The 2.4 is on the same side and the 4.0 is on the passenger side.

Posted on Aug 12, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Intermittent starting

Yes. When was the last time you had the starter changed? Has anyone crawled under the vehicle to check for a loose starter? If the starter does not engage it may be the starter solenoid ( the thing that drives the gears into contact before the starter actually turns ). This might not be ramming the gears together properly and that will cause the grinding noise, as well as an intermittent start.

Nov 07, 2013 | 2002 Jeep Liberty

1 Answer

Starter relay 2006 jeep liberty

or just go advance auto parts its only 13 and some change.

Nov 13, 2012 | 2006 Jeep Liberty

1 Answer

I need to know the best way to change the starter myself ( husband)

All it shows i "Oldsmobile" for your vehicle, so it will depend on which vehicle you have , but if you have located the starter whether it be on the under side of the motor, or side driver, it should be only 2 or 3 bolts to remove, and you will have to disconnect your battery before removal. The starter will have either a plug, or a nut with wires attached depending on the year make and model, but its a pretty cut and dry pull and replace procedure. Once its out, place the new one in the same way, put your wires back together, and reconnect your battery. Pretty simple. Thanks.

Mar 15, 2011 | Oldsmobile 98 Cars & Trucks

1 Answer

I drove to school and it ran fine. When I left class and tried to start it, the key turned freely with no resistance at all and nothing happened, it did not try to start at all. the battery read good and...

suggest a bad starter or a bad connection to starter, sometimes you can tap on the starter with a hammer and get it to start one last time.make sure cars in park with emergancy brake on!! have some hold key over in start position and you tap on starter with hammer to see if it even clicks, sometimes they will either click or even start, depaending on how bad the colenoind is on the starter. be very careful when tapping as not to cross out and hit the positive cable on the starter. hope this helps!!

Nov 10, 2010 | 1993 Jeep Grand Cherokee

1 Answer

I need to change the starter on my 95 cherokee sport, what are the procedures to take it off and what tools do I need.

Pretty much a simple job...Make sure you have any security codes and radio re-set info before you begin...disconnect the battery cable from the battery (+) . unbolt starter from the engine, disconnect the wires on the starter (mark their positions if you need to). Reverse procedure to install. Of course, you have tested the system and have determined that the starter is actually bad, correct?

Oct 23, 2009 | 1995 Jeep Cherokee

1 Answer

Change out starter 2004 Jeep Liberty

Starter should be pretty simple but they always put them down below in hard reach areas and pain the *** get out back in . Only has few connection dis connect the battire so you dont shock the hell out of your self.
It be two main bolts that hold into place and few nuts hold wires on.
Get hanes book it help you out some.
Hope this helps you out give thumbs up if it helps you out

Jul 29, 2009 | 2004 Jeep Liberty

2 Answers

I just bought a 92 jeep cherokee ran beautiful . now it just sits there cant get it to start . battery was dead replaced still wont start . cant tell if its the ignition or the starter.

I'm assuming the starter is not turning the engine...check the small wire on the starter for 12v with key turned to start. If no voltage there, check ignition switch and neutral start switch. (voltage in, voltage out)

May 09, 2009 | 1992 Jeep Cherokee Sport

1 Answer

My jeep won't start (1987 Jeep Cherokee)

Your starter needs a "makeover". try to clean or change the brushes in the starter.

a cheap and simple solution, is to make the cables on the starter longer, and attach them to a button in you car. If you choose that solution, you just have to turn on the ignition, and then push the button you have connected the starter cables to.

Apr 11, 2009 | 1987 Jeep Cherokee

3 Answers

Wont Crank

im thinking its the starter..i would take it out and brin it into like an autozone they test them for free..

Oct 24, 2008 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
2002 Jeep Liberty Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides