Question about 2000 Toyota Corolla

1 Answer

2000 20valve rsi limited


I am at my wits end gentleman, i drive the car mentioned above. I have had problems with the vehicle before but this is taking the cake.

My car is burning to rich i can smell the fumes. The car is also not performing as it use to. I also am experiencing the car is having difficulty in idling. I have done a diagnostic test myself and the fault codes was 22 and 41. I need the car to at its ultimate performance potential.


Posted by on

  • Anonymous Mar 27, 2014

    ''I have an acura cl 98' 4 cylinder, it stalls out (just dies) when idling or well driving every once in a while 'sporadically'. the car has no lack of performance and I had a diagnostic test done and nothing was wrong or malfunctioning according to it. ???



1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 20 Answers

The fault codes for your vehicle are probably make specific. Can you list what you OBD tool specified the problem to be?

In most rich running instances the fix is attributed to:

Dirty Mass air flow sensor (clean with brake cleaner as it does not leave residue like carb cleaner does)
Dirty O2 sensor (replace with a generic for under $30 if you can do the labor yourself)
Bad spark plugs or oil around ignition coils. You may way to pull and test each coil with a volt meter. You are looking for between 100 - 150 ohms to be within spec for this car. The ignition coils are what we used to call ignition wires or spark plug wires but now run without a distributor to be more efficient.

Posted on Aug 17, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Does a Tri Glide Ultra have a limited slip differential or is it just a single wheel drive

I am not familiar with the bike and specs don't mention the detail you request. I suspect if there was a limited slip diff fitted it would appear in the list.

It might be a single wheel drive but in the case of narrow track rear wheels it could be two wheel drive with no differential. A wider track vehicle has been equipped with a twin belt drive and performed admirably without a diff.

It could alternatively be fitted with a standard diff.

Feb 06, 2017 | Cars & Trucks

1 Answer

Hi i need the big ends and mains torque settings on a mercedes c180 2001 16valve 4cylinder please

MAINS renew bolts
stage1- 55 NM
stage 2 - 90-100 degrees

BIG ENDS renew bolts
stage1 - 45 NM
stage2 - 90 degrees

Aug 17, 2016 | Cars & Trucks

1 Answer

When im driving the tracking active keep coming on. Do you know whats causing this problem?

Depends on conditions you are driving in ...If there is ice, slick road, or driving fast near beak away limits. The system will apply brakes, decrease speed and tighten steering so you remain in control of your vehicle. If your suspension , brakes or steering components are worn or bad, the vehicle may sense that there is a skid or unusual condition and activate the tracking system. If it is coming on under normal conditions have the mentioned components checked.

Mar 11, 2015 | 2004 Cadillac Escalade

1 Answer

Tapping/ticking noise when rpm goes above 2000 with check oil warning on my chevrolet lumina ls 2005 model

You will have to take an oil pressure reading and compare to specifications. It could be that the pick up screen is plugged. Do not drive the car as damage to engine will occur.

Jan 14, 2013 | Cars & Trucks

2 Answers

Exhaust pipe glowing red hot

you have a sticky valve it is letting raw gas into the exhaust

Dec 07, 2012 | 2000 Kia Sportage

1 Answer

Hi i'm driving 2002 fiesta rsi when the engine is cold ie in the morning i'ts fine,wait untill it get's hot, the driving is such a pain, it looses power you can't push it hard it gives

The engine and automatic transmission (If equipped) in this vehicles drive train are fully electronically controlled by a computer called the PCM (Power Train Control Module). Whenever a problem like this occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM

Aug 29, 2012 | Ford Fiesta Cars & Trucks

4 Answers

Why is it that when i put my truck in four wheel drive it only turns one wheel up front and one in the rear? This is on my Ford F150 4x4 1989

The gears in the axels are open type - meaning they drive the wheel with the least amount of traction, most often right rear and left front wheels. Some of the rear axels were fitted with a limited slip type that would drive both wheels.

Feb 01, 2011 | 1989 Ford F 150

1 Answer

The back end of my 1997 GMC Safari starts to shake and growl when I get it up to speed about 50-60 mph. It gets louder and louder. The right tire rim even gets hot to touch

hi from the symptoms you calearly describe may i suggest that b4 you drive vehicle any further you must 1st raise and support the wheel you mention that gets hot ? make sure you chock front wheels then release park brake now check suspect wheel by rotating it to see/feel/hear ? any undue noise or stiffness most of all try rocking wheeltop to bottom i am suggesting you problem may well be the wheel bearing is shot and the heat is due to eithe the bearing run dry thus allowing the brake drum to tilt and resulting in brakeshoes to contact and cause friction /overheating of drum and transferring to actual wheel rim hope you understand above ?

Feb 27, 2010 | 2000 GMC Safari

1 Answer

I am always replacing front tires due to alignment issue. i get the alignment done - then a month later the front end bounces at 60-65 mph. Now I find this week that my back tire is leaning inward at a...

It sure sounds to me that the gentleman or lady in charge of aligning your vehicle wasn't doin the job properly.The entire vehicle's suspension needs to be checked for visible damage or worn out parts before the alignment.Had this been done then they would have seen why the back tire is leaning in like it is.I suggest that you take the vehicle elsewhere.....just for your safety alone.You do not want to be driving a vehicle whose suspension may fail at any time and put you in harms way....HOPE I COULD HELP!!!

Nov 18, 2009 | 2005 Hyundai Santa Fe

2 Answers

2000 2.0 vw shutt down after running 20 min

Replace the fuel pump relay, it's easy and cheap.

Jun 08, 2009 | 2000 Volkswagen Jetta TDI

Not finding what you are looking for?
2000 Toyota Corolla Logo

Related Topics:

602 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8729 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides