Question about 1983 Ford Fairmont

1 Answer

Inhibitor switch Where do i find it I have an XF1989 Ute with a 351 auto. On gas

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 19 Answers

Hi there it will be on the transmission itself behind the gearshift selector

Posted on Sep 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need to obtain a car manual for my subject ute?? any ideas pls..


auto spares shops
technical auto shops autodata publications
why do you say subject ute and not the make and model

Oct 04, 2015 | Cars & Trucks

1 Answer

Engine will not crank in park or neutral starter is ok


check or isolate auto inhibitor switch and see if that works.if it does,get a new inhibitor switch

Mar 18, 2015 | Cars & Trucks

1 Answer

My Mazda 6 auto transmission wont start. Dashboard wont display gear selection. What could be the problem?


It could be. The inhibitor switch is like a park/neutral switch, part of the starting circuit.

Feb 08, 2014 | Mazda Cars & Trucks

2 Answers

I have a 92 sentra lights come on but when i turn key nothing happens. Starter good ,relay good, head lights don't dim when you turn key . Car won't turn over at all


If by lights, you mean the dash lights come on, then ignition switch must be getting power. If dash is not working with key on, check the 30 amp fuse link which powers the ignition switch.
If switch is good and starter is good, the start wire from switch goes to, if automatic, to inhibitor relay (the park/neutral function) and then to starter. There is also an inhibitor switch on the shifter or on the transaxle that turns on the inhibitor relay when key is on and shifter in park or neutral. The inhibitor switch is powered by a 10 amp fuse D.
If you have a manual transmission, the start wire from ignition switch goes to the clutch interlock relay and then to the starter. This relay is turned on by the clutch interlock switch on the clutch pedal.
You can check for power on either relay, the inhibitor relay or the clutch interlock relay, with a test light. Pull the relay out, have the key held in start position. Now both relays would have power showing on two terminals where the relay plugs in. If inhibitor relay only has power on one terminal or no power at all, either ignition switch is not sending power or fuse D is out or the inhibitor switch is not working right. If clutch interlock switch does not have power on two terminals either the ignition switch is not sending power or the clutch interlock switch is bad.
If the relay checks are good, check for power on the small wire to starter with key held in start. If you have power there, the starter solenoid must be out.

May 08, 2013 | Cars & Trucks

1 Answer

Starting problem


SOURCE: Kia Technician Times
TITLE: A/T Inhibitor Switch
APPLIES TO: 95-00 Sephia
SERVICE TIP:
CONDITION
Some 1995 thru 2000 Sephia Automatic Transmission equipped vehicles may exhibit the following inhibitor switch concerns: - The vehicle may not start intermittently in park or neutral. - The vehicle TCU may intermittently lose the gear position signal from the inhibitor switch and go into failsafe mode (third gear). If the inhibitor switch signal returns while driving, the TCU will return to normal transmission control. The vehicle will then upshift or downshift abruptly depending on vehicle speed. - The TCU will set a pending OBDII code and then after two key cycles, the MIL light will come on and the O/D light will flash.
CAUSE
Corrosion/dirt on the inhibitor switch connector terminals or internal contacts.
CORRECTIVE ACTION Replace the inhibitor switch with P/N KFW35-21-444 and carefully adjust per procedures in the applicable service manual.
Note: The 1998-2000 Sephia Service Manual has an error on page 42-104 inhibitor switch inspection/adjustment. The connector terminal chart should show terminals 5 and 7 having continuity in neutral. The correct inhibitor switch terminal locations are shown below.

I Hope this Info Corrects Your Problem Please Don't Forget to RATE Me ! Thank you

Feb 09, 2009 | 1999 Kia Sportage

2 Answers

Inhibitor switch


eh , Automatic transaxel Range (TR) switch , can also be referred to as the Inhibitor Switch , personally i would call it the neutral safety switch , anyway you can find the "inhibitor" switch on top left side of transaxel , it goes over the shifter shaft coming out of the trans where the shifter cable bolts onto . Looks like a 1/4 of a circle . cheers mate

Jan 13, 2009 | 2003 Kia Spectra

1 Answer

Where is the inhibitor switch


yes its on the transmission so you cant stat in drive reverse ect

Aug 19, 2008 | 1995 Jeep Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...