Ok your proplem is that there is to much gas getting into the motor so pull your whole motor apart and u will see a screw it will be the screw near the clutch titen that then put your motor back together and start it keep ajusting that and i will be as good as new thx
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Check your sidestand switch. Sometimes it sticks due to road grime and when you release the clutch to ride off it thinks the sidestand is still down and cuts the engine off. It is located close to the swivel point and spring of the stand under the bike. WD40 or other brand should clean it.
if you pedal is soft/bleed again.If the pedal go slowly down/replace master cylinder.If the pedal is normal hard remove the caliper and try again to push slowly. Make sure the cylinder don't come out,just a little and retrieve .clean the slide and lubricate with high temp. anti size
1.if your bike screaming at high rpm and didint go fast.check 1.is your pulley is fix the same as it was before? 2.your drive belt in the wrong directional way 3.clean and check your carb and also dont forget to check your fuel pump 4.lack of cooling system or malfuntion can lead to engine stall
I have a 49cc cateye mini bike it starts idles fina dn every thing but when you ride it it goes fine i can reach around 55 almost 60 with the stock engine but it seems to quit on my after about 15 mabey a little less sometimes and then will not start for about another half hour