a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
There is usually a relay control center under the hood. Look for a black box, it will have a cover on it, should say on lid Relay center, the diagram will either be on outside of lid or under side of lid, it will tell you which one is the pump relay
o canada! there is a video or two on youtube showing how to pull out the radio and climate control unit. the procedure is almost identical on every saturn made 91-99 so it need not be an SL. you snap out the decorative oval, remove some screws and there it is in your hand, but find and watch the video. if you break the oval cosmetic piece there are plenty more for sale on eBay. when you have the control in your hand you will see that those sliders move jacketed cables. if the hang up is not in the control head then you are going to have to work back and find the other end of the cable, buried in the dash. while you have the dash out, again find a video, do yourself a favor and replace the heater core and the wiper motor before reassembly. What i did on aboot 3 of the 4 saturns i owned was to experiment and find the best position for defrost, pulled off the knob and taped it down forever so no one else would ever jiggle it. the winter defrost is the most important function for all seasons.
problem is usually the resistor, but switch may be going bad too. The resistor is next to the blower motor, above the passenger's feet. You may have to take the glove box out to get to it. See picture below. Also, please see my tip athttp://www.fixya.com/cars/r6234839-doesn_t_heater_or_air_conditioner_blow for additional diagnostic info. Please get back to me if you have any questions. REMOVAL & INSTALLATION, Climate Control Panel
Remove the center console trim fascia.
Remove the radio to allow access to reach behind the control panel.
Remove the control panel attaching screws.
Remove the center console bracket, if necessary, to allow for easier removal.
Separate the control panel from the trim panel.
Unplug the harness connectors and vacuum lines from the control panel.
Plug in the harness connectors and vacuum lines from the control panel.
Install the control panel into the trim panel.
Install the center console bracket, if removed.
Install the control panel attaching screws. Do not overtighten them, as they are screwed into plastic.
Install the radio.
Install the center console trim fascia.
Operate the climate controls and check for proper operation.
removed the panel below the radio, clips hold it in and you have to yank it out without damage. then there are two 8mm head bolts behind that panel facing up. they hold the whole frame for the audio and climate controls. then push on that frame with your fingers to pop out the whole panel that the radio and the climate controls are mounted to. then simply disconnect the harnesses and remove the climate controls(three screws and the dials pop off). now you can get to the four 8mm bolts that hold the audio unit in.
if the older ford expedition are the same as my ford truck take jack handle insert just above license plate
there is a place close to tire that is oval shapped
the hook part of the jack handle insert into the oval then from memory turn counter clockwise to lower tire to ground until you can remove catch from center of tire
Tools required: Phillips screwdriver, small flatblade screwdriver, rachet with 6 inch extension & 10mm socket.
1. Remove negative battery terminal (for stray voltage & airbags.)
2. Remove gear shift trim
3. Remove cable attached to lighter socket.
4. Remove center climate control knob and screw beneath it.
5. Gently pry both bottom corners of climate control face (up then towards the rear) until clear of lock.
6. Pull entire climate control console rearward until clips release. Leave all wiring attached.
7. Remove 4 bolts under radio (10mm.)
8. Gently pry between dash and AC ducting panel (both sides) and pull out.
9. 4 clip hold radio to ducting panel, gently pry while pulling radio out the back.
The rest should be easy...
9. 4 clips hols radio to