Question about 2000 Nissan Maxima

1 Answer

Help to disconnect my alarm

I have an 2000 nissan max an my alarm system goes off everytime i get n my car,when i cut my car off how can i disconnect this problem because i dont need this headache thanks

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 45 Answers

It sounds to me like you dont have a key less entry remote on the vehicle, I would check the small switch located behind the driver door lock tumbler (were the key goes in) and to do this
you need to remove the door panel, this switch knows when you
insert the key into the door and turn it to disable alarm, some times they break off - when the alarm goes off try unlocking the
vehicle on the passenger door.

Posted on Aug 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can I shut or disconnect my security alarm on my 94 Nissan maxima the doors lock and alarm goes off the drivers side door key don't always work to shut alarm off


You'd have to find a wiring schematic for your car and locate the wires for the alarm. Either unclip them or cut them. Usually are located in the wiring harness under the dash, above the pedals.

Nov 22, 2013 | Cars & Trucks

2 Answers

Temporarily disengage alarm on 2000 honda accord ?


Under the dash on driver side the alarm box is usually placed there. You should be able to unplug it from power there.

Dec 24, 2011 | 2000 Honda Accord

3 Answers

1992 Nissan Maxima Alarm System goes off with key entry


Opening the trunk with the key (not the valet key) will shut off the alarm.

Can't offer help on permanently disabling the alarm.

Sep 20, 2009 | 1992 Nissan Maxima

1 Answer

New battery -alarm sounds- have to disconnect the battery-


The sounding alarm maybe a security system installed by in the truck. Disconnecting the battery will only temporarily solve your problem, but will resume once you reconnect the battery for electrical power.

You must find the keychain/remote of the security system and disable it. If you are unable to locate this, you can have it disconnected by a qualified automotive electrician.

Word of caution though, if you are using the keyless entry system with the security system, this will be disabled until you install a receiver with such function.

Hope this helps.

Jun 29, 2009 | 1999 Nissan Pathfinder

1 Answer

Same Here


Disable it. You gonna need the schematic diagram for it.

Jun 29, 2009 | 2000 Nissan Frontier

2 Answers

The alarm went off in my 1993 nissan maxima and now my radio,lights,etc, come on but my car wont start..it wont even make a sound..what do i do?


Remove the aftermarket alarm or if it's a OEM alarm try unhooking the battery cables for a few minutes to clear the computer.

Feb 21, 2009 | 1994 Nissan Maxima

1 Answer

Alarm system on hyundai xg350


disconnect the the alarm speaker by taking one end of the speaker inside engine compartment, it looks like horn, follow wires and look for one of both (any) and cut it or disconnect if You find terminals, Your Relay is the problem, or your switch

Feb 10, 2009 | Hyundai Motor 1998 Accent

2 Answers

My car alarm is blinking but the remote doesn't work. I already replaced the battery to the remote so I know that's not the problem. If I open the car the alarm goes off and doesn't allow me to start the...


You need to first look under the drivers side dash area near the hood release/fuse panel area and see if there is a valet switch. The switch will look like a little toggle or a push switch. After you locate it, turn the ignition switch to the on position(dont start it) and flick the valet to the opposite position it is in now. If done correctly in most cases the red system light will stay a constant instead of off or blinking indicating you are in valet mode. Next try to start the engine. If this doesnt work you need to remove the alarm system and repair the ignition switch wiring or replace the electrical portion of the ignition switch. The aftermarket alarm cuts into the ignition switch wires and bypasses the start circuit through the alarm module. When disarmed the alarm completes the circuit and allows the car to start. Good luck hope this helps and please rate this.

Nov 05, 2008 | 1997 Nissan.5 Altima

1 Answer

Alarm system


if you are just annoyed with the noise, i could suggest that you just disconnect the speaker wire inside the engine compartment.

your alarm has an immobilizer and that would be a great help in case some one wants to steal your car.

but if you really want to remove your alarm, it would be just a matter of locating your alarm and disconnecting the fuse that powers it. it would normally be a red wire and there is a fuse in series with the wire.

you can trace your alarm by tracing back where the speaker wires came from. that box would be the alarm.

tnx 4 using fixya,

drcool

Sep 07, 2008 | 2002 Nissan Pathfinder

Not finding what you are looking for?
2000 Nissan Maxima Logo

564 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...