Question about 1997 Buick LeSabre

3 Answers

Car want start a light comes on it say securty on 1997 buick lesabere

Posted by on

  • cjm13mitch Jul 17, 2008

    i have 1997 buick le sabre and i have the same problem,i turn the key and it won't say nothing,but i have full power and my starter is fine!

  • mrlinks Sep 17, 2008

    My problem is that my 97' Buick Lesaber will not turnover, not even a clicking sound I turn the key over & over and still no crank. What could the problem be?

×

3 Answers

I have a 97 buick lesabre and the security light always comes on, I think you are just noticing it now

Posted on Jul 13, 2008

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

You might want to have your ignition swith replace. It could be bad wiring

Posted on Jul 10, 2008

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My problem is that my 97' buick lesaber will not turnover no matter how many times I turn the key my battery is fine & starter, what could the problem be?

Posted on Sep 17, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Put a new lock switch in securty light is on does not start


With a new switch comes a new key. Gm has a relearn procedure. You must do this 3 times. Turn the key on, engine off, wait ten minutes, turn the key off for 5 seconds. After the third time start the car. remember to turn the key off after the third time or you will have to start over. just a note , if you have daytime running lights , pull the fuse or relay to save the battery. It would be marked DRL

May 07, 2011 | 1993 Buick LeSabre

1 Answer

What size belt can i use to bypass my a/c compressor on a 2000 buick lesabere


Your going to have to remove the compressor and replace it with part #2100034 bypass pulley. No way to route with a shorter belt.Recover refridgerent before dissassembly and tape up lines to compressor for future use.

Feb 13, 2011 | 2000 Buick LeSabre

1 Answer

Securty light flashes and keyswitch want crank eng


the car immobilizer is not allowing the car to start have u got a spare key to try in it as the one you are using could have lost its code

Dec 26, 2010 | Buick LeSabre Cars & Trucks

3 Answers

GM '97 Buick Le Sabre Climate Control flashing display


I did the exact thing with my '98 buick LeSabere. I am certain that the dealer would have to look at the components and relays and fuses. I had problems with Precision tune mechanics telling me there is nothing wrong with the electrical system, even though I still get a Flashing temp gauge and do not get FULL heat even when it's blasted to 90ºf . [Precision Tune got heat on the windshield and floor.] Moreover, the car is possessed with glitches; I am not getting heat on the windshield and the floor is not hot enough to warm the cabin.

Sep 21, 2009 | 1997 Buick LeSabre

1 Answer

97 buick skylark not starting


sound like powertrain control module is not powering up everytime

Aug 09, 2009 | 1997 Buick Skylark

1 Answer

Car will crank over but will not start


leave a battery charger on the car place keo key on engine off for roughly 10mins or until light goes out if light doesn't go off after30mins you need to repair securty problem first ie. pass lock sensor faild replace it first if you don't have proper diag equipment. if light goes out after 30mins start engine. you can also try disconnecting battery for 30mins and then hold pos and neg cables together with the battery still disconnected for 1sec to reset pcm /bcm. then relearn securty. good luck

Mar 23, 2009 | 1997 Pontiac Grand Am

1 Answer

Replaced battery securty light came on power no start


Here is something that the emission wiz helped me with


PASS LOCK RESET GM CARS 1999 UP
1) Put the key in the ignition and turn to the "ON" position. Leave it that way for 10 minutes. After 10 minutes turn the key and take it out. Repeat this process (2) more times (3 times, 30 minutes total) This should reset the passlock system to recognize your key
.

Mar 14, 2009 | 1997 Chevrolet Venture

2 Answers

1997 Buick Le Sabre will not start somtimes


My wife has a 96 we had a similar problem. I believe that the connectors on the chip that is in the ignition key are worn out. The manual said that it is a safety feature on the car if someone tries to use a different key in the ignition or tries to punch it, it disables the car for like 3 minutes. We had a spare ignition key and switched to that and haven't had the problem since. Hope that solves your problem.

Nov 21, 2008 | 1997 Buick LeSabre

Not finding what you are looking for?
1997 Buick LeSabre Logo

Related Topics:

528 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...