Question about 2003 Toyota Camry

1 Answer

Power seat I moved the driver power seat all the way up to clean now it is stuck and will not move either way

Posted by on

  • Anonymous Mar 19, 2014

    Drivers seat won't move back

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

It sounds like the motor may have jammed. I would remove the seat (only held on by 4 bolts) and loosen the motor and then see if it will move.

Posted on Jul 14, 2008

6 Suggested Answers

  • 88 Answers

SOURCE: Power seats won't move

YOU WILL BE LOOKING AT ANOTHER POWER SEAT MOTOR.

Posted on Dec 26, 2008

  • 1 Answer

SOURCE: Drivers electic seat will not adjust

I just had the same problem. When the seat is powered all the forward, one of the worm drives reached the end of its travel and jammed against the threaded block that it passes through. To fix this the seat has to be unbolted and tipped back. There are four tiny 6mm bolts that hold the motor plate in. Remove these and the motor will come out. The worm drive is bolted in at one end and has a set pin at the other. Remove the worm drive and use a couple of vice grips or equivalent to loosen the threaded block from the worm drive.

Posted on Jun 21, 2009

  • 1 Answer

SOURCE: Driver's seat unable to move forward or backward

I have the same problem. I removed the motor assembly that powers the seat fore/aft and found a stripped plastic gear on the right-hand side of the driver-side seat track. It looks kinda like a speedometer gear. I was able to remove it, and hopefully Infiniti sells just the little gear.

Posted on Jun 28, 2009

MNfisherman
  • 11896 Answers

SOURCE: driver's side front seat won't move

It is likely the gear on the motor came off track with the seat. The seat will have to be removed and bottom panel disassembled.

Posted on Jul 06, 2009

egstriker23
  • 44 Answers

SOURCE: pt cruiser seat adjuster problems

You might have a problem with the wiring under the seat. The best thing to do is to reach under the seat and move some of the wires away from the track that the seat moves along. Most likely there is a short to ground because the wires are rubbing against the seat track as it is moved back and forth. You need to grab a flashlight and look under the seat for wires touching the seat tracks. When you find them, you can most likely use some electrical tape to wrap the exposed wires and keep those wires from touching each other and that area from touching the seat track. Make sure you route the wires away from the seat track tight enough to the seat's underside, but loose enough to allow the wires to move with the seat as it travels the full length of its track. The fuse for the seat has probably blown so you would need to replace the power seat fuse AFTER you wrap and reroute the wires to prevent blowing the new fuse.

Hope this helps!

Posted on Sep 07, 2010

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Driver side electric seat is stuck in the far forward position and won't move. How do I move it manually or fix the motor.


Auto Repair: How to Replace a Power Seat Motor - YouTube

? 1:44
https://www.youtube.com/watch?v=EDh-0rs5Fjo
Oct 26, 2010 - Uploaded by automdvideos
Auto Repair: How to Replace a Power Seat Motor ... 2007 - 2008 Ford Expedition/Lincoln Navigator Driver Bottom Install Video ...2003-2006 Chevy/GMC Seat Cover Install 1 of 3 - eBay Ready ...2000 Ford Explorer Front Seat Track Stuck Motor Repair - Duration: 4:39. by cubmancan 4,959 views. 4:39.
Drivers seat is dead! No power seat or heat. - TheDieselGarage.comwww.thedieselgarage.com/.../96465-drivers-seat-dead-no-power-seat-hea...Mar 22, 2010 - 2003-2005 Chevrolet Avalanche, Silverado, Suburban, Tahoe 2003-2005.... Power seat on driver side didn't work.....passenger did! Neither ...DANG electric seat ' Chevy Truck Forum ' GM Truck Clubwww.gmtruckclub.com/forum/threads/dang-electric-seat.2990/Apr 27, 2006 - 10 posts - ‎7 authors'03 Tahoe My driver seat just stopped, of corse not where I need it, the ... I have a 2003Tahoe and both heated seats are not working. ... with my seat heater on the drivers seat in my 03 Avalanche, it turns ... The driver's side on my Silverado gets way warmer than the passenger side. ... Frozen New Member.Power Seat Problems?? - Tahoe Forum - Che

Dec 29, 2015 | 2003 Chevrolet Avalanche

1 Answer

I moved the drivers power seat to it's full forward position and it will not move.


if you look real close at the underdash fuse panel theres gonna be one labeled "power equipment group" that's the one you want to replace , but i'll tell you if you try and move the seat again its most likely gonna go again as I replace lots of power seats that have something (any object) stuck in seat track jamming up the motor

Jul 29, 2015 | 2005 Mercury Montego

1 Answer

Driver seat stuck


Shoot lots of penatrateing oil on rails Like liqued wrench or blaster let soak over night apply more in morning than work on moveing seat. if they are electric check fuse , check for power at motor if power exists replace motor if seat is manuel and you still cant move it unbolt seat and replace from local junk (recycleing)yard.

Apr 19, 2014 | 2008 Ford Taurus SEL

1 Answer

Passenger side seat moves. Drivers is stuck there is nothing blocking it. and my gauges from my dash are acting up also.


Hello, you didn't mention if the seats are power or not. If power, do you hear any clicking when you push switches? If not blown fuse for drivers seat. If not power seats than cable for locking mechanism broke or came off and won't unlock seat from current position. Your sending unit inside your tank is faulty, most likely. It is due to faulty or bad connections on sending unit which in probably attached to fuel pump inside tank. My gauge moves alot when I drive and I replaced my
pump/sending unit 5 times already. It's just the way they are making them. The only time I get an accurate reading is at a stop or smooth road.

Jan 16, 2013 | 2001 Chevrolet Blazer

1 Answer

DRIVER POWER SEAT LUMBAR BUTTON STUCK. SEAT DOESN'T MOVE


Remove the button & resolve that part of the issue,
so it either works or if tests bad-- replace it

Dec 07, 2012 | 2010 Chevrolet Silverado 1500

1 Answer

Driver's power seat is stuck and would not move.


Hello,
First check the fuses. Then I suggest you remove all the bolts - lean the seat up - and tap on the electical motor if the fuses are good.

Also - call the local dealer and ask about any reaclls - have the VIN handy

Apr 01, 2010 | 2005 Nissan Murano

2 Answers

2003 Toyota Camry drivers side power seat stuck


This is not necessary...as many have stated...use a hammer with switch in reverse position. Hammer the seat back...it will catch...

Aug 25, 2009 | 1992 Toyota Camry V6

Not finding what you are looking for?
2003 Toyota Camry Logo

619 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

70365 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6878 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...