My window will go down, but it wont go up. When i hit the switch for it to go down, i can here it clicking, but when i hit it for it to go up, it doesnt do anything. No sound no movement nothing

door windows are powered by an electric motor that is connected to the window regulator( that part connected to the glass) and that connection can be cable or flexi drive
In a large number of cases , that cable or flexi drive is broken

Qsmoma:

If the window closes when you play with the switch, the switch is probably ok. The window may have jumped out of the track or the track is damaged. Pull the inside door trim and check the track and mechanical arms that extend from the bottom frame of the window.

There is no track to come off of

Usually the Window Regulator Assy breaks

Could be a bad door switch or wiring issue

Hitting a door is not a diagnostic technique

Have you replaced the passenger side switch or just the driver side one ????

IF YOU CAN HEAR THE WINDOW MOTOR CLICKING WHEN YOU TRY TO CLOSE IT, IT'S PROBABLY THE PLASTIC GEARS (COMMON PROBLEM) I PICKED ONE UP FOR $25. IF THERE OS NO NOISE WHEN YOU HIT THE SWITCH IT IS EITHER A SHORT OR THE MOTOR ITSELF $90. IT'S THE SAME MOTOR AS YOU FRONT DOOR WINDOWS.

You may have a dirty contact in the window switch, or a loose connection at the switch or window motor in the door.

i would suggest pulling the door pannel so you can see if the motor is running, or if maybe the window is out of track. I had that problem on a f-150 and just had to adjust the window into track.

sounds like the igntion switch has failed, not the key cylinder but the actual electrical switch, a common problem on these earlier honda's, the bit about when the windows work is the dead give away

First check your fuse panel. Other than that...Perhaps moisture has gotten in the door panel and messed with the connection. I would take the panel off and investigate..make sure everything is plugged in.

If other windows work, it won't be the fuse. Probably switch on door, wiring at door hinge area, or motor. Did you try banging on the inside of the door panel about half way down while hitting the switch, or pulling up on window while someone pushes the switch? That's providing you can get a grip on the glass. Sometimes motor will hit a dead spot & sharp blow to panel, will get it moving again until better fix can be done.