Question about 2002 Ford Thunderbird

1 Answer

Thunderbird Windows How do you reprogram the windows on a 2002 Ford thunderbird. The window lowers a fraction when doors are opened so that the window does not hit the rag top rwhen door is closed Thanks Ron ronlorrain@gmail.com

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

There is a complete series of instructions in the 2002 owner's manual about how to reprogram the "glass drop". I don't have the manual available at the moment, but I did mine and it was easy. You raise the glass and HOLD the button for 2 - 3 seconds and then drop the glass and do the same routine on the close... or something like that. It';s all there in the manual on the section about the side glass.

Posted on Aug 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Door handles wont open door on 1997 ford thunderbird


using a "slim-Jim" any tow truck guy could open it.

Mar 31, 2013 | 1997 Ford Thunderbird LX

1 Answer

96 thunderbird. electric widows motor works but windows won't move


The motor is shot...it still runs but is about to go out, it no longer has the power it needs..replace the motor, or the entire motor regulator assembly and you will be fine.

Dec 03, 2012 | 1996 Ford Thunderbird LX

1 Answer

2002 thunderbird window won't go up or down replace swith still wont work fuse are ok does the switch get power


The master switch connector does have circuits that have power on them. The Master switch is not directly connected to the window motors. The switch sends a signal to the Front Electronic Module and the module controls operation of the motor on the driver side. The passenger door window motor is controlled by a different module

Nov 28, 2012 | 2002 Ford Thunderbird

1 Answer

96 ford thunderbird power windows


YOU NEED TO CHECK THE CUIRCUT BREAKER USUALLY LOCKATED IN THE FUSE BOX

Apr 11, 2012 | 1996 Ford Thunderbird LX

1 Answer

How do I fix the power window in my 1997 Ford Thunderbird the passenger side works but the driver side don't work. What do I need to do? I already changed the fuse.


Open the door pannel check the window regulator by pushing the up and down button. If no noise herd replace the motor but before replacing make sure the window is set in the window track properly

Mar 12, 2012 | 1997 Ford Thunderbird LX

1 Answer

My drivers door sticks when the window is up...won't open or close properly....due to the window.....The window used to click down a fraction before closing...but, now it doesn't....how can this be fixed.


These cars have a learn procedure for these windows. First get in the car run window all the way down making sure to hold the switch down not to let auto down take place. Hold this till window is all the way down keep holding down for at least 3 more seconds then hold hold the up till it stops and hold for three more seconds, this will teach the computer the full down and up stops. repeat for other side. Anytime you take out the battery or it goes dead you have to do this for the windows.

Apr 29, 2011 | 2002 Ford Thunderbird

1 Answer

How do you remove the door panel in a 1996 thunderbird to replace the speaker?


use a flat head screwdriver and pop it off where it meets the door. Be careful when it comes loose. If it falls it can rip the wires from the power windows and locks.

May 13, 2010 | 1996 Ford Thunderbird LX

1 Answer

How to remove the drive side window on 96 tbird?


You have to pull the door panel, loosen the track/window framework and door opening/unlocking rods and remove the motor assembly. You then lower the track all the way down and the window is free and lifts up at an angle out through the window opening. Expect about an hour and a half to replace..

Nov 05, 2009 | 1996 Ford Thunderbird LX

1 Answer

How to remove the door panel on a 96 Ford Thunderbird?


Carefully pull front door trim panel finish panel away from front door trim panel.
Disconnect wires from front door lock switches, outside rear view mirror controls and window regulator control switches, if equipped. Remove front door trim panel finish panel.
Remove front door trim panel retaining screw through front door trim panel finish panel opening.
Remove interior lamp lens cover.
Remove screw through interior lamp opening.
Slide front door trim panel upward to disengage hooks.
Rotate top of front door trim panel away from front door and lift bottom hooks from front door.
Disconnect window regulator jumper wire
Remove front door trim panel.

Feb 21, 2009 | 1996 Ford Thunderbird LX

1 Answer

2002 Ford Thunderbird


Hi!

You will need to open the door panel by looking for screws near the corners of the door and also on the inside handle, then look for any disconnections in motor that is used for the power windows operation. Also, see if the wire coming to the motor is fine and nothing is blocking the window to open.

Do rate the solution.
Thanks
Rylee

Feb 08, 2009 | 2002 Ford Thunderbird

Not finding what you are looking for?
2002 Ford Thunderbird Logo

Related Topics:

258 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...