Question about 2001 Chevrolet Impala

1 Answer

My 2001 impala 3.4 engine turns about 3/4 turn then locks up

My 3.4 engine on my 2001 impala turns about 3/4 of a turn then locks up i don't if it a rod bearing or a timing chain

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,039 Answers

Remove our fan belt just to make sure you dont have a jam pulley or alternator today i had 3 car with jam alternator 2 japonnize and a dodge the japon one had small belt so the belt burn but the dodge is like ours its wide so it might our problem hope it FIXYA our problem thanks pierre

Posted on Jul 04, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a chevy impala 2001,i took it to the chevy house and they ran a dynostic and they told me it needed the ignition control module and the ignition swith,so i replaced them both but the car shows to be...


try this install the new key in the ignition switch. turn on the ignition switch to the on position for 10 minutes.when the system led lock light disappear.turn off the ignition switch for 5 seconds.then start the engine.still dont start.try this procedure few more times.if car still dont crank and you see the pad lock symbols.the dealership will have to reprogram the new key and body control module.

Apr 15, 2011 | 2003 Chevrolet Impala

1 Answer

Turns over but not starting is there a kill switch on 2001 impala


it could be your security system that locked itself up these cars are bad for that, the way to see is to turn the key on and see if the security light flashes on and off if so it is locked, the way to unlock it is to turn the key to the on position until all the lights come on and let it sit for 10 minutes and then turn the key off for 3 seconds and then it should start. if this doesnt help then it could be the fuel pump. hope this helps.

Jan 08, 2011 | 2001 Chevrolet Impala

1 Answer

Ignition switch stuck on 2001 chevy impala


sounds like stuck pins

insert key tap the end of key with malet untill it turns
once it turns drive to lock smith have them remove and repair the ignition cost will be 50 - 75 bucks verses dealer at 200 bucks

Jan 03, 2010 | 2001 Chevrolet Impala

1 Answer

2001 Impala TPMS reset, radio and headlight options DONT WORK


CHEVY IMPALA &
MONTE CARLO

On a Chevy Impala or Monte Carlo with indirect TPMS, a totally different reset procedure is required. You can use the light switch or radio to reset the system. With the light switch procedure, turn the ignition on (engine off), the turn the light switch from OFF to parking lamps three times within five seconds. With the radio technique, turn the ignition on (engine off). With the radio off, hold the DISP button until “SETTINGS” is displayed. Use the SEEK button to scroll down the menu until you see “TIRE MON.” Press the PREV or NEXT buttons until “RESET” is displayed. Then press the DISP button again. You should hear a chime and see “DONE” to indicate the TPMS system has been successfully reset. Use the SEEK button to scroll through the menu until “DONE” is shown, then press DISP once more to exit from the learn mode.

Dec 24, 2009 | 2001 Chevrolet Impala

3 Answers

2001 Impala will not start


I have the same car, I had my car fixed at the dealer. The problem is the ignition lock cylinder (where the key goes). It cost me about $340 (parts and labor). What has happened is that the cylinder is not sending the info to the starter to start the car. I guarantee you this is your problem too.

Jul 12, 2009 | 2001 Chevrolet Impala

2 Answers

Tempature Gauge is not working on my 2001 Chevrolet Impala LS.


Sounds like a bad coolant temp sensor. Do you have a check engine light on?

Mar 24, 2009 | 2005 Chevrolet Impala

3 Answers

2001 Chevy Impala won't start


If the battery has gone dead, it could cause the security system to go into full lock-up mode. If it has locked up the accessories will work after the battery is charged back up , but the power to the starter will be cut off and it wont turn over. You need to do the 30 minute learn procedure. A GM dealer will print it out for you and you can do it yourself. It's very simple if you follow the procedure exact. hope this helps and good luck.

Feb 21, 2009 | 2001 Chevrolet Impala

1 Answer

Key coding a 2001 Chevy Impala


Yes! After installed, trun key on (engine not running) for 30 mins.,trun off and back on for 10mins., turn off and back on for 10 mins. more; flashing light will go off turn off and try starting engine. Good luck! it's GM's reset for that.

Oct 20, 2008 | 2005 Chevrolet Impala

Not finding what you are looking for?
2001 Chevrolet Impala Logo

162 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61292 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...