I need help pulling the door panel off of my 2006 audi a4

InInside the drivers door in the back of the storage compartment is the switch to open the fuel door.

Hi,
You have 2 screws on front and rear of door panel (on the sides / top) and where door handle is , take ouut that screw , than Pull handle shell downward out of door trim. Remove bolts (2x).Lift door trim up and out of door shell.
Let me know, if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Pull back the weather seal and you'll be able to see what the cause of the noise is

Here's how:

First, take out the two screws at the top of the door panel, screwed into the top corners and pointing toward the middle of the door panel.

Second, inside the door pull (where you pull the door shut) is one screw pointed backward - remove that. Then force the inside "lining" of that pull downward and remove it.

Third, remove the screws you have just uncovered (two on the front door, one on the rear door).

That's it - just lift the panel upward and it'll be off.

Not sure if they've changed it but this is what i do for my 99 a4

First remove the screw in the handle pull, it should be next to where your fingers go.
Pull down on the black piece of plastic and remove the screw form the door
Then remove the screws on either end of the door, one near the door jam on top and one near the other side, same place.
Finally pull up then out and the door panel should come out

Hope that helps

FIRST CHECK THE CABLES THAT RUN INTO THE DOOR BECAUSE THEY CAN GET CUT THOUGH COMMON PROBLEM (JUST WERE THE DOOR HINGES INSIDE RUBBER BOOT.) DOOR PANEL REMOVAL...... PRIZE OUT THE TRIM PANEL AT THE BASE OF ARMREST UNDO TWO SCREWS (DRIVERS SIDE) OR ONE SCREW ACCESSIBLE THROUGH THE ARMREST UNDO THE SCREW AT THE BASE OF THE DOOR TRIM IN THE CENTRE. STARTING AT THE FRONT EDGE CAREFULLY PULL THE TRIM PANEL (ABOVE THE INTERIOR RELEASE HANDLE ) AWAY FROM THE DOOR TO RELEASE THE CLIPS, THEN SLIDE IT TO THE FRONT TO UNHOOK THE REAR EDGE OF THE TRIM PANEL.UNDO THE 4 SCREWS IN THE TRIM PANEL RECESS NOW PULL THE DOOR PANELAWAY FROM THE DOOR FRAME RELEASING THE RETAINING CLIPS, SOME FORCE WILL BE NEEDED PREPARE FOR SOME CLIPS TO BE BROKEN THEN LIFT THE DOOR PANEL UP SQUARELY NOW YOU CAN EASILY GAIN ACCESS TO ELECTRIC MOTOR.HOPE I WAS SOME HELP TO YOU THANKS STAN

CHECK FUSES BEHIND FRONT PANEL (DRIVERSIDE) IF THEY ARE GOOD.CHECK IF THERE IS POWER GETTING TO THE DOOR UNPLUG CONNECTOR ON A PILLAR AND TEST FOR POWER SUPPLY.IF THAT IS GOOD.COULD HAVE A BROKEN WIRE INSIDE THE DOOR JUST LIKE MY AUDI A4.(POWER CABLE CUT JUST AS IT WENT INTO THE DOOR) HOPE THIS WILL BE OF SOME HELP TO YOU....

LOOK UP MY SOLUTION TO REMOVE DOOR PANEL FOR A4 ,THIS WILL HELP YOU GET STARTED.THEN GET BACK TO ME IF YOU NEED MORE HELP!!!

Open the driver's door and look at the side of the dashboard. You'll see a funky-shaped panel on there. It has a finger-pull cutout in it. That's the fusebox cover. Pull it off and you'll see your fuses.

Open the driver's door and look at the side of the dashboard (where the door mates up when it's closed). There's a funky shaped panel on the end of the dash - pull that off and the fuses are beneath it.