Question about 2000 Nissan Sentra

2 Answers

2000 nissan sentra

No power going up hills cuts out while driving mostly over 40mph. first code was for fuel level sensor. now getting codes for maf o2 vss and heater circuit sensors. car just started not starting tightenened loose neg cable but just noticed second half of cable where they meet with clip has broken wires help

Posted by on

  • Anonymous Mar 19, 2014

    I got the p0650 the p1574 and the p0462 Fuel level sensor circuit low input can any one help on these codes?

×

2 Answers

You prpbably need a new ECM/computer. Nissan had a problem with the ECM box and the foam inside the box. The glue, which Nissan used to attach the foam onto the box EATS up your computer internaly. The vapors from the glue it self damage the ECM/computer. Nissan actually has a campaign to remove the foams out of the ECM box. By the way ECM has 80000 mile warantee, so if your car has less than that, Nissan will replace it for free. I see it all the time. Sentra with heater circuit code
needs an ECM 95% of the time.

Posted on Jul 17, 2008

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 20 Answers

Fix the broken wires their probably the problem then if problem still present check fuel pump.......... you can bench test it by putting power and ground to the right wires don't be scared you wont hurt anything

Posted on Jul 03, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why does my 2000 nissan maxima looses power while driving


Sounds like the maf sensor. Im assuming its throwing a check engine light? Get it read at AutoZone and look up the code. Go from tjefe

Jun 03, 2014 | 2000 Nissan Maxima

2 Answers

Well my sentra has about 122k on it. When I drive it, it starts to **** and pumps and ends up loosing power. My mechanic seems to think its the distributor, but from what im reading it looks like it...


the MAF sensor wold make since there is a small wire inside of your intake that is the MAF sensor if it gets a lot of dust or anything on it it could make your car run like that.you can find the sensor by finding the plug and weirs sticking out of your intake tube. if you take it apart and clean the wire you could see results.

Mar 30, 2011 | 1998 Nissan Sentra

2 Answers

Nissan sentra 4cyld


Hi, you have provided trouble codes p0100 AND p1605.


Trouble Code: P0100


Mass Airflow Sensor Circuit Malfunction
Possible Causes:



Air Intake leaks located after the MAF sensor assembly MAF sensor signal circuit is open, shorted to ground or power MAF sensor has failed PCM has failed


Trouble Code: P1605

A/T Diagnosis Communication Line Malfunction

Possible Causes:


TCM communication line circuit is open or shorted to ground TCM communication line circuit shorted to VREF or power (B+) TCM or PCM has failed TSB 01-004 (01/01) contains information related to this code
For the P0100, check the connector on top of the MAF sesnor for looseness or corrosion. Connector is on top in piocture below. jturcotte_361.jpg

Mar 25, 2011 | 2000 Nissan Sentra

2 Answers

What is code PO462?


code p0462 is low voltage on fuel level sensor possible causes are fuel was low more more likely is you filled up while car was running this is a common problem sometimes setting this code. you can check the seal around the gas cap and make sure there are no cuts and its sealing good. i hope this helps

Feb 13, 2011 | 2004 Nissan Sentra

1 Answer

2001 nissan sentra code po171


ok the fuel pressure is very good , and you replace maf sensor too,
i think 2 probable throubles, one , the catalyc converter clogged , to check remove exhaust pipe section before catalyc and run engine, its very loudness, other is tps fault, tps is throttle position sensor, located on acceleration body

Jul 30, 2010 | 1996 Nissan Sentra

1 Answer

I have a 1997 nissan sentra that wi have a 1997 nissan sentra that wont pass emisions fuil system lean bank1 p0171 code so i changed the maf sensior,fuil pressure reg, pcv valve, and all four fuil...


Have you checked your fuel pressure at the fuel rail? The problem could be a clogged fuel filter, pinched fuel line, or under-performing fuel pump (either faulty part, or not receiving enough voltage).

The only other thing I can think of that would cause the loss of power symptom and failing e-test would be a plugged catalytic converter, but that wouldn't likely cause the lean running.

Jun 27, 2010 | 1997 Nissan Sentra

1 Answer

2000 Nissan Sentra 1.8 with P071 trouble code, too lean bank 1


do you mean P0171??
If so, then it means your MAF sensor may be dirty and needs to either be cleaned or replaced.
It could also mean there's a vacuum leak downstream of the MAF sensor

Oct 12, 2009 | Nissan Sentra Cars & Trucks

2 Answers

Hey


Most times when you have a cut in power when the RPM's are high that's most likely a "SPARK" problem. However it can also be a "GAS " problem. Does check engine light come ON if it is or even if it NOT ON there can still be a Code stores in your computer. My first thing would be a BAD CRANK sensor/CAM sensor. This is my recommendations you should have this vehicle place on a code scanner/computer AUTO-ZONE does this check for free then get the codes if any is present and get back to me asap. I strongly thing it would be a crank sensor but if not there is a 20% chance its a FUEL PUMP can meet the demand when you hit the gas therefore then engine starves and dies. LEt me know how you made out. Good Luck and Thanks for using FIX YA

Jan 23, 2009 | 2003 Nissan Sentra

1 Answer

Poor idle, power loss off idle then takes off if you give it more throttle like a quarter more pedal, engine code says bank 2 is to lean


You need a new MAF (mass air flow sensor or air flow meter as its called). and you will also need a new air filter, since you most likely used aftermarket one and that's what killed that MAF sensor/meter. Aftermarket air filters dont sit right in the box and are not oil soaked, which helps to catch any debris and dirt coming into your engine. Replace you air filter with Nissan filter and install a new MAF/air flow meter. If your air box is dirty, clean that out too. MAF sensor will run you about $500 and the air filter about $17. Common problem on a Sentra if you are not using Nissan air filter.

Aug 02, 2008 | 2002 Nissan Sentra

1 Answer

No power up hills


If you had a bad mass air sensor, it should register a fault code. Ditto for oxygen sensors. I'd change the fuel filter for sure, as well as spark plugs (make sure they're gapped correctly), and run a bottle of Seafoam through the gas tank. If that doesn't do it, change your cap, rotor, and spark wires (all told you're under $100 for everything).

Jul 21, 2008 | 2003 Honda Civic

Not finding what you are looking for?
2000 Nissan Sentra Logo

609 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

64034 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...