Question about 1996 Mitsubishi Eclipse

1 Answer

The interior roof liner has come loose ....

How do i reatatch it ? without ripping it or taking the edges loose?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 68 Answers

Well in short , you dont. ther is a glue they sell at walmart you can buy to reattach it but you will have to take it out prb to do a good job. to have the head liner redone is about 60 bucks. Let me know

Posted on Jul 03, 2008


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2000 plymouth neon sunroof will not work and has a good fuse in it what is the problem

Could be the switch. Could be the roof module or regulator. You can pull the head liner down a bit and look. If you see loose cables, its the regulator. Remove the head liner. The module is in front center of the window. I have removed them without taking out the head liner. You have to be careful though. Pull the headliner down to much and it will crack.

Mar 24, 2016 | Plymouth Cars & Trucks

1 Answer

How do I go about fitting a headliner to a mk2 ford consul

Start with the first, front supporting wire / rod & feed it through the lining hoops & roof mounts, then work your way back along the roof doing the same for each rod. This rods fully support the liner & do most of the work.

When all the rods are fitted, start loosening any trim where required, push the liner under & re-seat the trim. Use a blunt tool to lift the edge of any window seals & run it slowly along the seal, inserting the edge of the liner as you go

Dec 10, 2014 | Ford Cars & Trucks

1 Answer

How to remove the roof liner of a 2006 Honda odyssey to find where leak is orginating?

You need to remove most of the interior panels that prevent the liner from coming out. Than you have to carefully bend it slightly and go out the back door with it.

Aug 31, 2014 | 2006 Honda Odyssey EX

1 Answer

Moon roof won't open on my 2002 bonneville sle

The motor and module is in front of the moon roof window, under the headliner. You can pull the liner down to work on it, but be careful not to pull it so far that it breaks. If the cables are broke or really loose, you have to remove the liner. Replace the regulator. Most times it is the module. It can be replaced without removing the liner.

Aug 31, 2014 | 2002 Pontiac Bonneville

1 Answer

Roof liner pieces coming loose in avalon

if you pick up a can of spray glue at you local hardware store, spray the underside of the roof liner and the roof, wait a couple minutes for the glue to cure and press them together starting from where its stuck natural and rub it into place.
let me know how you make out

May 11, 2009 | 2007 Toyota Avalon

1 Answer

How to replace the drivers sun visor

remove trim at edge of liner and look above the liner ti reval a connector.

Apr 14, 2009 | 2003 Buick Rendezvous

3 Answers

My 1988 buick lesabre has the felt ceiling material fallen away from the roof - how do I get the felt material stuck back up to the ceiling?

It's pretty hopeless to get it stuck back up right. It has a sponge backing that tears off when you glue it. The only right way is to get a new ceiling liner and put it up. But I assume your car is too old to want to do that.

I have tried spray on adhesive. I took the liner off from the dome light to provide a hole for me to poke my arm up through and spray the adhesive. But hot sunlight made the glue come loose.

The only partially effective remedy I found was to take off the doorway trim and tape the edges of the liner up tight and hold that in place with the doorway trim. It still sagged, but I could see out the rearview mirror.

I tried a hot iron to melt the glue and stick it up. It worked for about ten minutes.

You might try stiff strips of thin wood on the outside of the liner, wedged against the doorway trim and pressing up against the liner.

You might try some quite thick glue, so that it would soak through the sponge backing and penetrate the fabric. That would show spots on the ceiling, but it might hold it in place.

Good luck!

Jul 31, 2008 | 1997 Buick LeSabre

Not finding what you are looking for?
1996 Mitsubishi Eclipse Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides