Question about 1999 Porsche Boxster

1 Answer

01 boxster electrical

When i unlock the driver's door using the keyless entry, my trunk pops open as well.I shut the trunk door and drove off, but it poped open again by itself.Can somebody help?

Posted by on

  • Anonymous Mar 16, 2014

    poped the trunk to get something out now trunk will not close again

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

HELO FARSHID ITS JP THIS IS A SECURITY AND LOCKING MODULE THAT IS DEFECTIVE, IT SEATS BELOW THE DRIVERS SEAT . CHECK FOR WATER DAMEGE SOME TIMES WATER OR FLUIDS RUN DOWN THERE AND DAMEGES THIS MODULE, IT HAPPENS FREECUENTLY ,HOPE TO BE OF SOME HELP . JP

Posted on Jul 18, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When i use the combination for the door the trunk also opens


Please review the keyless entry instructions. This unit has numerous locking patterns, and perhaps the trunk was programmed to unlock with the door.

Mar 17, 2015 | 1998 Lincoln Continental

1 Answer

Keyless entry will not open passenger door or trunk.


I would replace the remote, this remote is very prone to this type of problem.

Oct 11, 2012 | 2004 Saturn ION

1 Answer

Bought from dealer with no keyless entry. alarm activates when doors are locked with power doorlock system. alarm sounds when we open the door. how do we de-activate the alarm before unlocking the door?


Opening the drivers door with the key is supposed to shut down the factory security but the drivers key cylinder usually goes bad. You will have to unlock the rear tail gate lock cylinder with the key and that will shut down the factory security, before opening the drivers door.Your other option is to have an aftermarket keyless entry system installed, which will open the doors remotely while shut down the factory security at the same time.

Jan 25, 2011 | 1996 Jeep Grand Cherokee

1 Answer

What would you do when your 1996 lincoln town car doors won't lock with the key. And the trunk won't open.


How can a lock not lock or unlock with a physical key? Maybe the cylinders are frozen? Try squirting a little oil into the locks.
1996 Town Cars have keys and keyless entry. The physical keys are two, an ignition key and a door key. You can't use the door key in the ignition, nor the ignition key in the door. They aren't interchangeable.
The default key code for keyless entry is posted on the right trunk hinge, inside the trunk.

Jul 19, 2010 | 1996 Lincoln Town Car

1 Answer

Help with finding keyless door pad codes and resetting


Open the trunk and up under the package tray where rear speakers mount,on the passenger side you will see the module.It will be black and have 3 connectors to it.It will have a sticker on it with a 5 digit code.It will also have a sticker on one of the trunk hindges with this code if someone has not removed it.Here is how the system works:

Keyless Entry Keypad To unlock the driver front door (20124), and disarm the anti-theft alarm control (19A366) (if equipped):
  • Enter the permanent factory code.
  • Enter the owner's alternate code.
To unlock the passenger door(s), press the 3/4 button within five seconds of unlocking the driver front door or luggage compartment door (40110) . To unlock the luggage compartment door, press the 5/6 button within five seconds of unlocking the driver or passenger door(s). To turn on the interior lamps (13776) and light all illuminated components, lift either front door handle (22404) and press any button on the keyless entry keypad (14A626) . To lock all doors, press the 7/8 and 9/0 buttons at the same time. (It is not necessary to enter the key code first.) This will turn off courtesy lamps. To program a temporary code:
  • Enter permanent code.
  • Within five seconds of pressing last button of permanent code, press 1/2 button.
  • Enter any alternate five-digit code within five seconds of pressing 1/2 button.

Apr 15, 2009 | 1995 Ford Taurus

1 Answer

Car will not unlock.


To get inside the car .... Use the key in the lock cylinder, unlock the drivers door to get inside. You shouldn't have to reprogram the fob unless it or the keyless module was changed. There may be a blown fuse that supplies the keyless control module (check the owners manual for location). or wires that lead into the Drivers door may be damaged ... The keyless module is located inside the drivers door at the bottom behind the door panel ... do the unlock/lock and trunk release switches on the inside of the drivers door operate the locks and or trunk release? If so it is not the fuse ... and not the wires to it ... And it could be your BCM body control module, located in the dash board to right of your gas petal. Because the number entry keypad (code for that is on the inside of the right passenger trunk bracket arm) also doesn't work I assume it's not the key fobs themselves. Your 98 manual is correct for your car.

Apr 02, 2009 | 1998 Mercury Grand Marquis

1 Answer

2004 FORD TAURUS


Sounds like the keyless entry system is on the fritz. You will probably have to get a new brain for the keyless entry system.

Mar 26, 2009 | 2004 Ford Taurus

1 Answer

Program my remote


Program your factory keyless entry functions
For 2001+ Tacomas equipped with a factory alarm or keyless entrymag-glass_10x10.gif, here are some programming options that allow you to adjust the way your locks work.
The first programming option allows you to set the entry unlock to: (A) unlock the driver door with one push, and the remaining doors with a second push OR (B) unlock all of the doors with a single push.
  • Open the driver's door. Remove the key from the ignition switch.
  • (Complete these steps within 40 seconds)
    1. Insert the key into and remove it from the ignition switch 2 times.
      (IN - OUT - IN - OUT)
    2. Close, then open the driver's door 2 times.
      (SHUT - OPEN - SHUT - OPEN)
    3. Insert the key into and remove it from the ignition switch 1 time.
      (IN - OUT)
    4. Close, then open the driver's door 2 times.
      (SHUT - OPEN - SHUT - OPEN)
    5. Insert the key into the ignition switch and leave it in.
    6. Close the driver's door.
    7. Turn the key from LOCK to ON 4 times, ending at LOCK
      (LOCK - ON - LOCK - ON - LOCK - ON - LOCK - ON - LOCK)
    8. Wait for the locks to stop, then remove the key from the ignition switch.
  • On the key fob, press and release both LOCK and UNLOCK buttons at the same time.
    1. [For all doors unlock] press and release the UNLOCK button.
    2. [For driver door unlock] press and release the LOCK button.
  • Open the driver's door. The programming is complete. If programming did not occur, start over.

Jan 13, 2009 | 2001 Toyota Tacoma

2 Answers

Trunk won't open -1993 audi 90S


if you can drop back seats you can get in and manually flick the lever when it is open you will have to go to dealer to see if you can get a key to match or you might get 1 in a junkyard. if this helps please rate me

Nov 21, 2008 | 1993 Audi 90

6 Answers

Keyless entry stopped working on 05 cobalt now i have to unlock door with the key and when i do that the alarm goes off. Help


Lock all the doors from the inside (with all the doors closed), unlock your driver's door by manually lifting the lock, then press it back down after you are out - this will prevent the alarm from sounding when you use the key to unlock the door.

Aug 02, 2008 | 2007 Chevrolet Cobalt Coupe

Not finding what you are looking for?
1999 Porsche Boxster Logo

237 people viewed this question

Ask a Question

Usually answered in minutes!

Top Porsche Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21981 Answers

yadayada
yadayada

Level 3 Expert

63291 Answers

Dave  C
Dave C

Level 3 Expert

1050 Answers

Are you a Porsche Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...