Question about 1995 Chevrolet Camaro

3 Answers

Won't start!!! :( need help! fast please!

Note: i only have 130k on my car. i was driving and i was about to pass this car in front of me..and i was just oging around them and i had to push the petal down & it was about to "kick in" when it made a loud popping noise.
and started shaking pretty bad...i could still drive but i didn't want to with it shaking like that. So i pulled over and it was still shaking...i turned it off and popped my boyfriend checked my oil and it was fine and didn't smell burnt. I did need an oil change but i wasn't that many miles overdue. so he told me to try to start it again and it just clicked.
everyone says my engines locked up but my friend could turn the belt. so i dont know
but if it is how much would an engine cost?

thank you SOOO much. because i really love my car.
& if i get it fixed do you think it will continue to have problems in the future? because i know nothing about cars and if camaros are known for problems then i don't want one.

Posted by on

  • Anonymous Aug 02, 2008

    My car starts fine and seems to run okay except when you want to get on it or go up a hill it almost comes to a complete stop and it takes forever to get the power to make it up the hill we have changed the module packs checked the radiator changed plugs checked transmission I am at the end of my rope please help.



3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.


    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 95 Answers

Hers the thing camaros are known for some p[roblems you really have to baby them as far as parts and lubrications are concerend however they are a powerouse on wheels...if the car would not start back up and only clicked but didnt actually turn over then yes the flywheel is locked up. but if keep tryingf to start it you will blow the bendix in yer starter...what is the current stais of it now?

Posted on May 18, 2009

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Check vaccum lines i had the same problem ,, there is also a possibility of blown headgaskets

Posted on May 03, 2009


Please check the water in the radiator?? you havent mentioned if the radiator has water in it... sounds like a blown radiator hose to me.....and the motor has overheated...


Posted on Jul 14, 2008

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Won't pass smog due to OBD

Find someone with "VAGcom" or VCDS cable and software.

Nov 16, 2017 | 2001 Audi TT

1 Answer

I have a 2000 yukon xl, 4wd won't engage, rebuilt transmission and transfer case. the vehicle is on hoist, put in drive and engage 4wd, cannot turn front drive shaft by hand, seems in gear, new...

Check the 4x4 wiring ground (directly behind the left front tire, mounted to the body). If the front axle actuator is still good, this is usually the source of frustration. Put some RTV Gasket sealer on the nut and bolt after you replace them to help keep it from corroding as fast.

Sep 25, 2017 | Cars & Trucks

1 Answer

Truck idles fast. when you step down on gas it starts popping and won't go into passing gear

it could be a number of thins.
1. the timeing is off.
2. needs new spark plugs and wires
3. distibuter and button
4. or the cattlittic converter is stoped up and the back preasure is causing it to pop when you put the gas to it.

Jun 15, 2011 | 1994 Chevrolet K1500

1 Answer

Hi, I bought used Audi A6 Quattro 130K miles. For the first several days, it run without any problem. Early this month, I was driving a rather hilly highway and the car start to drive rough,hearing some...

I would check to see if the catalyic converter is clogged. Drop the tail pipe at the manifold. Start and drive it for a block you will be able to tell real quick. It should run smooth and have good power. It will just be noisy. Or you could have coil problems.

Jun 13, 2009 | 1999 Audi A6

1 Answer

2003 nissan se-r spec v POWER LOSS

sounds like a computer module problem . have the computer diagnostic scan done at your nissan dealer. good luck mister bill

Jan 23, 2009 | 2003 Nissan Sentra

2 Answers

2003 Nissan Sentra SE-R Spec V

I have the same car and I know there was a TSB for the ECM . I know the ECM issue has cause some cars to stall while driving

Jan 22, 2009 | 2002 Nissan Sentra

1 Answer

Won't start! really need advise!

If you are talking about not able to turn the key, then move the steering wheel back and forth while you are turn the key. That should unlock your steering column.
If you are talking about car not starting after you turn the ignition, then it could be the starter. If it's the starter, you would hear a clicking sound but no cranking

Jul 02, 2008 | 1995 Chevrolet Camaro

Not finding what you are looking for?
1995 Chevrolet Camaro Logo

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides