Question about 2000 Honda Civic

1 Answer

Honda civic on my deshboard yellow light isconstntly on, please let me know how to remove it. thank you

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

An intermittant check engine light ( MIL, malfunction indicator lamp) usually means the system has noticed some trouble that has either corrected itself or has been compensated for. You can have a shop check the DTCs ( Diagnostic Trouble Codes), or for pending codes ( problems noticed but not enough to store a fault code)

Posted on Jul 14, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1997 Honda Civic 4 door my dash lights are out and the dinging to my headlights is not coming on and I checked every light bulb and every fuse I don't know what to . Is is the dimmer switch


HONDA ILLUMINATION NOT WORKING * HOW TO FIX ...

? 3:24
https://www.youtube.com/watch?v=oOHwDWjmYWU
Feb 28, 2011 - Uploaded by vehix411
No lights,cant see the dash lights,bad bulb,how to change bulb clucter ... i have a 2001 honda civic i installed a new radio andmy cluster lights are ... I just bought the computer or (multiplexer whatever) for my 1997 accord because my back tail lights won't turn on but I ... Martin Nikolov 4 months ago (edited).

Removing a Honda Civic instrument cluster - YouTube

? 4:01
https://www.youtube.com/watch?v=kzp1VqdlmU0
Oct 28, 2012 - Uploaded by mike937739
George L 4 months ago ... I used it to fix my burnt out check engine light bulb in my 97 civic. ... I have no light on my dashboard I already replaced the fuse but still nothing? so I'm ....2005 Civic cluster in 1997 Civic working!

1997 Honda Civic Instrument Panel Lights Problem ...

? 1:26
https://www.youtube.com/watch?v=mYVt93Rao6g
Mar 26, 2013 - Uploaded by fockyoumang


Dec 16, 2015 | Honda Cars & Trucks

1 Answer

I have 1998 honda civic lx , th srs light was come on , i just the reseted from youtube , but i got wrong wire for reseting, after reset the angine doesnt run , start , fueses everything is ok, only no...


What was your reset procedure? It should have been done with the yellow 2 pin check plug for SRS. The SRS system is isolated electrically from the rest of the vehicle systems, perhaps you got something loose under the dash while looking for the SRS plug, it is around a bunch of wiring. Also, if the light came on there is a failure. You should be getting the code read, it could be important. If the failure is a seat belt, they are covered by Honda on a lifetime warranty, at least in the USA. Did you check fuses in all the fuse boxes, under hood and under dash?

Jul 21, 2014 | 1998 Honda Civic

1 Answer

Changed the brain box on honda civic but the srs light still remains ?


The SRS light can be caused by a faulty switch in the drivers seat belt. Make sure that the switch is functioning properly. The SRS lamp can be cleared by removing the yellow plug in the circuit board under the dash (just under the steering wheel). Here's a pretty good link to a repair. http://www.youtube.com/watch?v=PYYzt04o5MU The car in the video is newer that 2003 but the repair is the same. Good luck

Jun 25, 2014 | 2003 Honda Civic

1 Answer

2002 honda civic SRS light on how do i reset it?


The SRS light comes on when there is a fault detected with your seat belts. You will need to scan the SRS system to get the trouble codes. you will need a high end scan tool for this. Once you know the codes you will have a much better idea of what to do next.

Aug 10, 2012 | 2002 Honda Civic

1 Answer

Where can I find a diagram for the timing chain of a honda civic 1.6 vtec


Hi, look here: http://www.2carpros.com/diagrams/honda/civic/1998 and please let me know if you have any questions.

Thanks for using FixYa.

Jan 23, 2011 | 1998 Honda Civic

1 Answer

I want to know how can I replace the dome light for my honda honda civic 04??


Welcome to Fixya

Here's the process on how to remove the dome light.

  1. Carefully pry off the lens (A) with a small screwdriver.
  2. Remove the two mounting screws.
  3. Disconnect the 3P connector (B) from the housing (C).
  4. Disconnect the 8P connector (D) from the ambient light (E).
  5. Install the light in the reverse order of removal.
Thank you for using Fixya!

Dec 20, 2010 | 2004 Honda Civic

1 Answer

I dont know how to put in the tail lights in my 93 honda civic


Remove the panel covering the light from the inside of the trunk.Remove the nuts from the tail light studs and remove the light.Twist the socket to remove it and then put in your new bulbs.

Nov 12, 2009 | 1993 Honda Civic 4 Door

1 Answer

My 2002 HOnda Civic DX yellow engine light indicator located on the left side of the dashboard is constantly on when the engine is working what do I need to do? thank you. Chris


you need to bring it somewhere to have a computer put on it to retrieve the code there is something wrong prob a sensor i dont know were you are but auto zone does this for free and can tell you what you need

May 09, 2009 | 2002 Honda Civic

2 Answers

Bulbs not working on a/c and recirculation buttons


The switches have to be removed and the bulbs are on the back of the switch. they look like a grey plastic screw. the bad news is that they are a dealer only item.

Jan 09, 2009 | 2000 Honda Civic

Not finding what you are looking for?
2000 Honda Civic Logo

358 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...