Question about 2007 Toyota Camry

1 Answer

Location of fuel filter

Can you tell me location of fuel filter and which fuse to remove to take presure of systm

Posted by on

  • vuesunset Jul 02, 2008

    Thank You

  • kpatel228 Mar 28, 2009

    i would like to know where i can find it as well

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,010 Answers

It is located behind the intake manifold on the firewall. fairly easy to change, but it is down low so remove the intake boot to give you greater axcess. hope this helps

Posted on Jul 02, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No presure from the fuel line but pump works


Check your fuel filter, might be clogged. Usually located underneath the vehicle along the side of the tank, inline with your fuel lines. you will need fuel clamp remover. You can find the whole set of clamp removers at your local autozone for about 10 bucks

Jun 25, 2012 | 2002 Nissan Altima

1 Answer

Not getting gas won't start


Will it start on starting fluid if so check your fuel rail for presure No presure check your fuses if fuses are ok Check your fuel filter Do you hear the pump running you may have a bad fuel pump

Feb 27, 2011 | 1990 Ford Econoline

1 Answer

How do I changethe fuel filter on my 2004 mercury van? i have located it.is there a fuel cut off or just take it off and the fuel wont flow?


Remove the fuel pump relay then try to start vehicle, this will relieve presure in line. Some fuel will still leak out when you remoe filter. Have a pan to catch the gas, also the filter will be ful of gas.

Aug 12, 2010 | 2004 Mercury Montery

1 Answer

Fuel presure regulator


behind the intake manifold or on the bottom of the upper intake manifold close to the fuel injector rail

Apr 21, 2010 | 2000 Dodge Durango

1 Answer

How install 2000 fuel filter on a lincoln navigator. how to bleed off presure on fuel line ?? after installing does it need to be represurized or does it need to be represurized. car has a 5.4 engine . can...


Yes, before removing the fuel filter go ahead and pull the fuse out for the fuel pump. The location of it can be found inside your owners manual. After pulling the fuse out then start the vehicle. After it stalls then you can remove the filter. Still wear safety protection to protect yourself from the gas, have a small drain pan ready, and a couple of rags, no sparks or open flame. After the new filter is in place then cycle the ignition key on and off to prime the filter. After you start the car remember to check for leaks.

Apr 21, 2010 | 2000 Lincoln Navigator

1 Answer

2004 150 new fuel pump, enigine starts but dies, wait 5 mins. starts dies, unhooked fuel line very little gas


check the fuel presure reg but first check fuel ammount place fuel line un hooked in 1 galon glass jar turn ignition to run position container should fill quickly mesure fuel amount from single cycle call dealer ask what flow amount should be with single purge cycle
this will tell you if pump or filter are problem it will allow you to see if fuel filter is pooched and **** is bypassing also or if it is pluged

if results proper or close to dealer spec check fuel rail for bad fuel presure regualor if reg bad there will be little or no fuel presure even during purge cycle if flow high and finger cant hold presure if is usually fine and reg is bad pick up new reg from salvage it will cost 5 - 20 bucks and if a likely culprit

Jan 22, 2010 | 2004 Ford F150

3 Answers

Fuel filter Location


it is on the firewall down low below the master cylinder. Follow the fuel lines from the fuel rail down to the filter.

Jan 14, 2010 | 2004 Nissan Sentra

4 Answers

Where is the fuel filter located on a 1998 gmc safari


The filter is on the left side on the inner frame.About where the drivers seat area.Hope this helps.Make sure to relieve fuel pressure before removing the fuel filter or it will spray all over.You can do this by removing the fuel pump fuse and starting the vehicle and let it run til it dies.Do not turn the key back on til you are done.Make sure and reinstall the fuse.Hope this helps.Good luck.

Dec 31, 2009 | 1998 GMC Safari

2 Answers

Injectors not getting fuel


i have an 88 chevy truck, not getting gas to come out of injectors.. getting gas all the way through the lines all the way up to the tbi but not out of injectors. pressure gage check done! new fuel regulator done! . u can put gas in the throttle body and it fires right up.??

Nov 16, 2009 | Ford Cars & Trucks

1 Answer

My honda maccord wont statr without having to pump gas pedel


if you have a 95 accord you dont need tp pump the throttle it is a fuel injected car the problem does lie in the fuel system the filter is a good place to start but i woud check the fuek injectors and the fuel presure regulater. and to let presure out you got to loosen the bolt on the fuel filter witch is located on the fierwall. if you have any other honda questions please let me know

Brad Ross

Nov 15, 2008 | 1995 Honda Accord

Not finding what you are looking for?
2007 Toyota Camry Logo

Related Topics:

456 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...