- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The camshaft position sensor is located on the rear cylinder bank in front of the exhaust camshaft. The camshaft position sensor extends into the rear cylinder head and is sealed with an O-ring.
Hi Rusty, There's two links below showing the position of 2005 Ford Explorer Crankshaft Position Sensor and the 2008 ford edge camshaft sensor location. It seems like they're all in the same position, I hope this helps.....CHEERS
.. 2005 Ford Explorer Crankshaft Position Sensor Location
Camshaft Position Sensor
The camshaft position (CMP) sensor detects the position of the camshaft. The CMP sensor identifies when piston No. 1 is on its compression stroke. A signal is then sent to the powertrain control module (PCM) and used for synchronizing the firing of sequential fuel injectors. The Coil On Plug (COP) Ignition applications also use the CMP signal to select the proper ignition coil to fire. The input circuit to the PCM is referred to as the CMP input or circuit.
There are two types of CMP sensors: the three pin connector Hall-effect type sensor (Figure 25) and the two pin connector variable reluctance sensor
and next the location of 2003 ford focus camshafts position sensor
EOBD II Error Code:P0117 Fault Location:
Engine Coolant Temperature (ECT) Sensor (G62) - Low Input Possible Cause:
Malfunction Indicator Lamp (MIL) Triggered on first occurrence.
Wiring short to earth.
Engine coolant temperature (ECT) sensor.
EOBD II Error Code: P0340 Fault Location:
Camshaft Position (CMP) Sensor A (G40), Bank 1 - Circuit Malfunction Possible Cause:
Malfunction Indicator Lamp (MIL) active.
Wiring from/to Camshaft Position Sensor (CMP) faulty.
Camshaft position (CMP) sensor faulty.
Timing misaligned. Possible Solutions:
Check Wiring from/to Camshaft Position Sensor.
Check Camshaft Position Sensor.
EOBD II Error Code:P0500 Fault Location:
Vehicle Speed Sensor (VSS) - Circuit Malfunction Possible Cause:
Malfunction Indicator Lamp (MIL) Non Emission Fault - No warning light.
Vehicle speed sensor (VSS).
Engine control module (ECM).
camshaft position sensor location on the V6 engine located at the front of the engine block below the power steering pump. the 4 cylinder engine camshaft position sensor location below ignition coil cover where coil cover say 2.4L TWIN camshaft sensor in that location below coil cover. you will see red or red white wires connected to it.