Question about 1993 Saturn SC2

1 Answer

Door panel ive tried to get the outside door panel off but it stays stuck on even though ive removed all the screws on the inside of the door

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 37 Answers

You have to pull up the outside window molding and it is connected underneath should just lift off........also be sure to disconnect the door handle....lift it up and it is either a bolt or a little stopper that has to be pulled out .....also take off the side view mirror ...it may be connected under that as well

Posted on Jul 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Door stuck closed


The door has the child safety on possibly try opening from outside with a little leverage if not successful remove door panel to unlatch from inside with a small screwdriver on the latchy

Jul 22, 2014 | 2002 Jaguar X-Type

1 Answer

2006 Chevy Impala drivers side rear door stuck from outside and inside. How do I remove door panel with door shut?


here is a picture of the door panel components:acceptwha619.gif
those numbered 2 and 4 are screws 7 and 8 are plastic fasteners that should just pull out the door frame with an a little force outward on the plastic door panel.

May 03, 2011 | 2006 Chevrolet Impala

1 Answer

Replace outside door handle


you need to remove the inside door panel first. there will be a screw at the inside door handle and two screws for the armrest in the center of the panel. look around the outside edges of the panel for any other screws or clips to remove. the rest of the clips are behind the panel and snap when you pull on the panel. once off with the window up you can see the door handle screws. two of them. remove the connecting rods first.depending on which door you may have a lock rod also. then remove the screws and the handle will come out. good luck

May 22, 2010 | 1998 Toyota Corolla

2 Answers

Door wont open from inside or outside


I have just fixed mine. You have to remove the rear seat then remove the side panel that the door is jammed on.Now looking at the door post you will see two screw heads that are crome in colour. I took a small grinder and took of some of the length of the screw These two screws is what holds the door latch to the body which holds the door closed I then drilled a hole threw the bracket and the screws both screws then broke the bracket loose,pushed the screws in and the door opened.Had to buy a new lock assembly from a wrecking yard and took out the to screws I drilled out.of the same car I got the lock assembly Good Luck It worked for me

Jan 19, 2010 | 1998 Volkswagen Beetle

1 Answer

I cannot open my passenger door from the outside even though it is unlocked. I lift the handle but nothing happens. I can only open the passenger door from the inside.


The outside door handle operation rod has either fallen off or the outside handle is broken, you will need to remove it to find out which one, you will have to remove the interior door panel to access it. Hope this helps, let me know

Dec 14, 2009 | 2004 BMW 3 Series

5 Answers

Can't open tailgait on 2002 Mitsubishi Montero.


I have the same problem with a 2001 Mitusbishi Montero XLS. Door handle is stuck and feels mushy when trying to open it. Is there a safety from the inside panel to open the cargo door? At this point, until its repaired, all I want to do is to be able to release the lock and open the door.

Sep 29, 2009 | 2002 Mitsubishi Montero

1 Answer

How to remove rear outer door handle


Though I am not entirely familiar with the audi vehicle, mostly when trying to remove the outside door handle, you need to first remoce, the inside panel where the handel is located. Once this has been done, look to where the door handle comes to the inside of the door from the outside of the car. It should have some sort of a clip/ pin/ screw or other fastening mechanism, which holds it to the car from the inside. Remove that fastening mechanism and the handle should come off.

Jul 15, 2009 | Audi Q7 Cars & Trucks

1 Answer

2002 Silverado outside Door Handle


yes. you should remove the inside door panel.

to do this, remove all the screws you can see. One in the door handle, one by the mirror, then remove window crank/buttons

the take a flathead screwdriver and CAREFULLY pry the panel off. it is best to pry where the plastic pins are holding the panel on.

reverse procedure to reinstall.

Apr 01, 2009 | 2002 Chevrolet Silverado 1500HD

3 Answers

1999 Volkswagen Passat inside inner door panel


You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. If needed, you can pull back the weather seal (can't reuse it, but it's not that important) and you will be able to access everything inside the door

Mar 25, 2009 | 1999 Volkswagen Passat

1 Answer

Locking mechanism on 95 Jeep Cherokee Sport stuck in ''up'' positio


Push outside handle, simulating opening the door. At the same time, use a screw driver and pry open the jaws.

Nov 19, 2008 | 1998 Jeep Cherokee

Not finding what you are looking for?
1993 Saturn SC2 Logo

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...