Question about 1999 Pontiac Grand Am GT

1 Answer

Where is the TPS sensor for 3.4l motor

I need to replace the TPS Sensor for my grand am GT 3.4L. Only one problem. I have no idea where it is located on the car. Can someone please give me some direction?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Where your throttle cables hook to your throttle body, the tpi should be the cables

Posted on Jul 07, 2008

  • abbidog Jul 07, 2008

    on the other side of the throttle body

×

4 Suggested Answers

  • 33 Answers

SOURCE: Will a 1998 jeep 4L 2.5 motor work in a 1991 jeep wrangler?

Most likely yes. One thing about the older Jeeps is that they did not change the models much from year to year. If the two jeeps had the same engine, they are probably nearly 100% interchangeable.

Posted on Feb 12, 2009

pippall
  • 1486 Answers

SOURCE: 1999ford explorer,4l.single,OHC looking to findspeedometer sensor

Its on the back of the gearbox where the output shaft is.

Posted on Sep 02, 2009

Testimonial: "very helpful,thank,you for taking the time to help some one in need,once again all my thanks goes out to you tonight.JOE"

amsmith525
  • 99 Answers

SOURCE: i need the wiring schematics

Please contact me at http://www.google.com/recaptcha/mailhide/d?k=01UdpUKOVFe6ggXtroGQ8peA==&c=OTjo86GdQBZZLc_ZSAjzjJGcOw0SXf1z26PeNftYkXY=
I can get you the wiring diagram for this if you would like

Posted on Mar 15, 2011

TJMS02
  • 134 Answers

SOURCE: Can you please tell me

It is located in the bell housing, drivers side, top pointing towards the master cylinder. Has two bolts retaining it. Will have a 90 degree electrical connector facing towards the rear of the vehicle. Hope this helps, TJ

Posted on Aug 06, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1989 jeep grand wagoneer 360 how do i test bad crankshaft position sensor


double posted, now with 360, 5.9L V8 fact.
great.
and has no such sensor.
its a CARB car
with ICM , spark magic box. , NO ECU /PCM brain in car
there for no CKP sensors.. sorry?

if you dont know what is there, photo it and post it
so others can see what is missing or wrong, from factory day 1 build.

i google for you
rockauto shows no such part in 360
alldata.com same
hell. even the 90s the same.
see it here.
all schematics

if engine wont start. even with test fuel, check spark
see the spark section below, under ignition.

http://oljeep.com/gw/elec/GW_wiring-1990.html

the distributor has cam sensor. not crank.
it called today, CMP, cam sensor
this sensor sends signals to the ICM the ICM then makes spark
buy driving the coil,
the CMP is more like Points, simulation, and lasts near for ever.

the 89 4L has a CKP (crank sensor) and is know to fail on brand new cars. (you need to tune it to make work , back in 88/89) at flywheel.
ask me how in know./././??


360 spark
CMP >>>>> ICM>>>> COIL>>> Dizzy cap>>> spark plugs.
this is the chain of events.
the DIZZY does the ADVANCING with ICM. totally. on this car.

Sep 09, 2014 | 1989 Jeep Grand Wagoneer

1 Answer

How to change cam sensor on pontiac GR AM 3,4L 1999


Place a jack underneath the engine with a block of wood on it as to not damage the engine and pump up the jack just enough to keep the engine from sagging down. Then remove the engine mount near the power steering unit. Removing the motor mount doesn't have to be done, but it makes it easier to remove the power steering pump (your choice). Remove power steering pump and set it aside keeping all the hoses attached. Camshaft position sensor is located beneath power steering pump. It should be held on by 1 bolt if I remember right. Disconnect the 2 wire harness and remove sensor.

Aug 27, 2013 | Cars & Trucks

1 Answer

Where is the TPS sensor located,2004 Nissan Titan 5.6 v-8


The 2004 nissan titan is drive by wire, meaning there is no cable to control the gas pedal to throttle.
This system is computer controlled with a motor at throttle body and pedal sensors.

the TPS throttle position sensor is located inside the throttlebody . on most of these the complete throttle body must be replaced as there is no sperate tps sensor it is complete,
i would check and make sure this is the problem . GM started making TPS replacement sensors for there throttle bodies.

Jan 06, 2013 | Cars & Trucks

1 Answer

Location of tps and map sensor on a 02 jeep grand cherokee 4.7l


Both are attached to the throttle body. Tps is on the other end of the throttle plate shaft opposite the linkage, MAP is on the side...has small vacuum hose underneath and is flat, about 3" long. The other item on the TB is the idle air motor, next to tps.

May 07, 2010 | 2002 Jeep Grand Cherokee

1 Answer

What is the sensor on the front of the throttle body on a 99 grand am


Its either a mass air flow sensor or a throttle position sensor(TPS) if it is on the side of the throttle body in-line with the butterfly it is a TPS. If it is inside the air intake tube it is a MAF sensor but those are usually either in the intake after the throttle body or in the intake tube right after the air filter

Jan 23, 2010 | 1999 Pontiac Grand Am GT

1 Answer

How do you change the tps on a 2000 jeep grand 4.7


The exact placement of the throttle position sensor generally is located on the side of the throttle body below the air intake tube on top of the engine.

To replace simply remove the air intake duct (usually one plastic screw), locate the sensor, disconnect wire plug in, remove the two sensor mounting screws (torx screw variety, size not remembered) and the sensor will come off. When replacing be sure to line up the throttle shaft with the proper groove inside the sensor...it should just slip in there pretty easily with a little bit of wiggling. Reinstall doing the reverse of the above.

Take's about 5 - 10 min to replace from start to finish and remember to clean the throttle body before starting this job to ensure no dirt will enter the engine. Good luck, Merry Xmass

Dec 24, 2009 | 2000 Jeep Cherokee

1 Answer

Need location of TPS sensor . Autozone employee told me that the code that was reading the computer was for the TPS sensor replacement. I don't have an idea where it is


The TPS is located on the opposite side of the throttle cable on the throttle body. If you don't know what the throttle cables are, get a friend to sit in the van and push the gas pedal down until you see something moving. it will be on the opposite side of the movement

Nov 15, 2009 | 2003 Ford E150

1 Answer

Went to get free diangostics and told me about tps sensor


TPS is Throttle Positoin Sensor which is located on top of motor where throttle cable attaches. The sensor is there.

QDM is quad driver which a part of the Electronic Control Module (ECM) The ecm itself may need to be replaced.

Mar 06, 2009 | 1989 Buick Regal

Not finding what you are looking for?
1999 Pontiac Grand Am GT Logo

Related Topics:

138 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...