I just put a engine in a honda accord 90 it stared good and run about 25 mins, but when i put in drive and reverse it worked, after a while it just shot off and won't start, ichange the distributor and still have the problem, it try to star but it is not spark. I don't know much about electrical things,
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
possible that clutch has failed, to test do following switch off engine and put gear into 4th, with brakes on try to start engine while in gear. if the engine starts switch it off straight away
this confirms your clutch has failed, if engine stalls your clutch is good.but could mean that the clutch activator is not working. either way recomment you see a qualified dealer or machanic about this issue.
Sounds like your rear engine mount is bad. It's a vacuum controlled mount and only an original Honda replacement mount will work to make the car vibration free once again. The aftermarket mounts don't come with the vacuum setup.
What model and year honda do you have? If it's an accord, 90-93, take a look at your distributor by checking for spark, when the engine dies. If no spark, it's usually a bad distributor on those year accords.
without doing further testing it is difficult to say, but there is a part called the main relay, located under the dash on the drivers side. it controls the power to the fuel pump, and is a common failure on older hondas. good luck!
disconnect the heater supply pipes and put the hose through the heater pipes and the reverse the flow direction this should help .If it doesnt the put some caustic soda in the rad and run engine for till it gets hot then for a further 5 mins ,then flush it out again ,try it if it works then refill with antifreeze .use about 200grms of caustic soda